ricksi30

Always! Looking forward to the XCON Steve!

So what are the new plans man?

Sorry IHoP!

Tipsy Ihop top!

I obviously don't know him, but him and his "crew" definitely seem that way on the forums.

It sounds like it is a loose dust cap.

Either load will be fine. 500 RMS is not that much power, so you should be fine.

There was rumor of a 4" coil driver, but with how busy they have been I'm not sure if that is still on the table.

yes it is the ap1500. 2ohm it does right around 900w and when you clip it, well it could be as much as 1800w of heat. The sub took it like a champ! Nice! I guess it gives you a better apperication for the build quality. That's why I run SSA.

yes it is the ap1500. 2ohm it does right around 900w and when you clip it, well it could be as much as 1800w of heat. The sub took it like a champ! Nice!

Edited to be more clear.

Steve sells the DD-1. Basically everything he does is to rip you off. Our Steve...not that dip shit.

What amp? I thought that it was on the ap1500.

I believe SSA Steve uses his ZCONs in a smaller than recommended setup. What kind of airspace do you have?

Yes

AND they only recommend 8 gauge for the installation of the 2500.

All for only $425!!! They look like Audiopipe quality with a JL price tag.

Those are WAY more expensive than I would have thought.

At least he didn't try to sell the peak ratings.

350 shipped. This is 100 less than in stores (with tax) and 50 cheaper than Ebay. BRAND NEW, the box is still sealed from the factory.

At most I'd think about adding a single agm battery in the rear.

I never was a fan of the NSX. Even looks wise, I don't really like them.

You have a decent size alternator. Put it all in, set it how you want it, play it and check your voltage. Only then will you know what you need.

Put it all in and see where your voltage is and go from there.