diablo_331

What kind of power do these things put out? Underrated at all? Also how many are left?

I was one of the guys that posted over on DIYMA that was interested in a GB. I'm waiting...

The PR will be mounted cone back or to the side. It will not be facing up or down to sagging over time hopefully will be less of an issue.

I may be interested to splitting a pair cs50cf's with someone to be used as a center channel. I'll be going with a MS-8 so I might as well go all out the first time. I still have a bit of planning to do first but if anyone would be interested just LMK.

Every man should own that poster.

I used a Olympus Stylus 1030 SW, 2 lamps for decent lighting and a framed John Belushi poster.LOL It takes a little trial and error but anyone can take decent photos even with no proper equipment and any decent camera.

On a different note. I found this sweet ass deal on DIYMA and ordered mine right up. I paid $31 total for a crap load of connectors. Jump on this asap.lol Qty Part# Name Total 1 91463 XA-SWA-SX8 USD$ 8.00 1 91464 XA-SWA-SX12 USD$ 8.00 1 91465 XA-SWA-SX16 USD$ 8.00 Estimated Shipping & Handling USD$ 7.00 Estimated Order Total USD$ 31.00

Well on a side note.. Look what the big brown truck brought me today.

I also have more than enough space to port the sub but I have a few reasons for wanted to try a PR. Port noise. Space. Ease of fabrication. Ability to change tuning whenever I please. And last but not least.. MOAR DEEBEEZZZ!!LOL.(Than a typical sealed enclosure) My wood shop is 7 hours away from me. So with very limited tools it is very hard to fab anything. I hope this at least explains why I am trying to accomplish and why.

The spider and surround are the only suspension parts I know of in a speaker . The PR will be mounted on its side of course so sagging will not be an issue. I know that PRs work in a car. They have for many years. If someone can please plug in the parameters and LMK a good box volume to start with.

Does anyone have any ideas?

Nicely put.

Have you modeled it in a PR setup yet? To see how small of a box it may need?

I like it!

After entering all of the available parameters HERE, into WinISD Alpha, WinISD is telling me that the consistency check on a few of the groups has failed. This is why I hate modeling. Anyone have a few more known parameters that I can plug in? Here is a list of what I have entered into WinISD already. •Re 3.7 •Fs 32.4 •Qms 5.24 •Qes .39 •Qts .37 •Mms 222 •Vas 35 •Sd 480 •Bl 20.65 •SPL 86.7 •Xmax 31mm Anyone?

The VMP 15" was the PR I was planning on going with.

Yes this is for a vehicle.

1.cost 2.power needed 3.space is at a premium 4.electrical needed for the SAZ3500 that you know will be powering two Drew

Anyone know a good starting point as far as enclosure volume?

Adjustable mass?

Tossing a few ideas around for my sub stage and have a question. What would be the best enclosure volume for a 12" Xcon and a TC Sounds 15" PR? The PR will be tuned differently depending on my mood. Any input will be greatly appreciated. Thanks, Colby

Wow! That was fast! Can we expect a tracking number by email?

Don't get me too excited. I've only just calmed down since the day I ordered them.