Duran

Stock, it's closer to 1,000 watts than 1,500 regardless of impedance. Power handling goes up a lot when you get cooling and the flatwound coil, I recommend them, if money is the issue it's worth it to save for the upgrades.

For an N2 18" I would opt for as close to 110^2" as possible, you can use less if you use flared ports, a minimum of 90 or so square inches.

Is the problem perhaps the logo on the case?

Fucking DD

There are a lot of resources on here to assist you.

You are almost halfway there

Wow, 29 mm of one way throw from a 10" driver. What is Xmech?

I'd say it depends on the displacement capabilities of the driver in question, a 10" PA woofer will require less vent area than a high excursion 10" driver

Warden's aren't included.

A BL coil will fit just fine, but you want a Q coil. The BL coil is very short in relation to the Q. The motor and coil of the Q are optimized for each other, changing to BL coils won't make it anywhere close to a BL.

i Sean will like that idea Actually I'd rather see a ridiculously lightweight something with shitloads of power. A high revving lightweight 6/8 is more than fine with tha BOOST. Hennessey Venom GT? 2,685 curb weight, 1,200 bhp note though that I don't endorse anything that buttmuch sells... Ariel Atom?

Nick explained why I asked you why you think it needs a better suspension, sure you could have one, but it isn't needed.

ahhhh i see makes sense.. BTL should actually come with 6 total thou since the BL's come with 5 stock now.. Why?

You pushed it beyond it's limits, no repair, or brand new recone can stand up to that kind of abuse.

Ahh, yes much easier for sewing leads I'm sure.

The word you are looking for is "impedance".

Thy use the yellow?

Voicecoil

Yes he will No such thing as sub stage since the sub is PART of the front stage L=R = crappy "stage"

Ding ding ding. Otherwise I would use y-splitters. I'm willing to bet its a full range signal.

Multiple Y-splitters lol

Y-Splitters, he won't have a stage but I doubt he cares.

Galaxy Tab is the only one worth a damn

Given the displacement capabilities of the SX, I recommend a total of 115 square inches of port area minimum, if you want to tune at 34 Hz. Notice, internal area isn't mentioned, because it isn't needed when figuring port area, it is only needed when determining efficiency, maximum power, and tuning of the enclosure.

okay well that makes sense. i gathered that it was sending the sub a dc signal from how it just went all the way down and stayed there like that. any idea what causes this or why it happens? Your answer in red.