dbjunior

im guessing this is in an suv due to the size of the box needed for 2 18's. would you be open to a diffrent design. subs up and port back tends to work really good in suvs.

any pics? will they be strappable? lowest ohm stabillity?

any idea how much power that caused that. im guessing the signal was really clipped.

two should be ok but you might get port noise. cut the length of each to 10in long tuning it to 34.2hz

can understand not wanting to give up what size or quantity but could you atleast give up if they are sundown subs or is it going to be another companys subs

how do you plan on wiring those sub to the amps. i hope your not trying to give 2200wrms each. those power hungry amps will eat your electrical system up.

both face back

id say 4cu before displacement tuned to 35hz

id split the port into two ports tune it higher to like 35hz great for music then have a cover for one port for a retune for when you want low lows like 26hz tuning. on the video it seemed like you where unloading a bit on the lows and that kills output a lot.

looks great but all the crome flames looks way to audiobahn

if i had 100k i would buy two decent cars probably 5k-10k a peice a small suv somthing like a rav4 and a sedan probably an accord with a kid on the way i got to think practical i would then pay off all my debt 10k there and finish my project car 87 porsche 944 nothing major just paint new carpets seats some rims about 3-5k then a nice sq system not even sure but it would be about 10k total 2k just for deadening i would also get a nice apartment pay rent in full for a year so i can move out of my moms basement 20k would go to a college fund for the kid and i would then go on a little vacation about 5k the rest would go in the bank

www.bladeice.com

vids

i like but a little more definition on pts would be cool

low would be sq loud would be spl the bl is a great midgound sub it can still get somewhat low and will get very loud if you were to switch to the bl id make the port 5inw and 26inl

a little math and winisd

16hx48wx16d with a port 14.5hx4wx24.25l

well 2-12's are gonna be the loudest but use the most room and cost the most a 15 will take up a lot of room and and be a little louder than a single 12 the single will use the least amount of room and cost the least it will not be as loud as the others but will still get loud. a recommended enclosure for as single 12 would be 14hx34wx14d with a port 12.5hx3wx33L after displacement comes out to just over 2cu tuned to 30hz a good box for a Q12

what type of vehicle is it going in

dont use a prefab box with any decent subs you should have a box custom built for a good sub and if that box is ported for two subs its way to small for q's

how much room do you have to use and what are your plans sealed ported

spl comp vise or spl daily

from what ive heard the t/s parameter model it as a sealed sub. but i was wonderin what the bl and mms where of the drivers, the rest was not really important to me thats why i wanted to know the parameters.

not trying to be a pain but are the specs going to be posted anytime soon.i know the specs say they are a sealed sub but everyone knows how well they perform ported now they have been out for a while.

what type of vehicle is it going in 8cu is a large box. the q likes the larger boxes and is more of a sealed box sub the bl18 will do fine with 8cu ported. what size was your old sub and what type of box was it in