ANeonRider

Port, tuned low (28-30Hz)

They are already released: http://www.soundsolutionsaudio.com/shop/in...at&catId=48

I use the stuff that doesn't expand much... it also stays soft. No wrinkled panels ftw.

I had the same problem with the Xtant amps I was using. It switched them from unbalanced to balanced (even though I am running unbalanced) and it went away. Not sure if that will help, but I thought I would throw that out. Not an option on the XT series. It is a power supply issue. O well... I'll just get it fixed.

Oops, I meant the 4.100, although the 4.150 is in the books as well... along with some IB, since I found a good air strut I can use to lift the lid. Now I can get it of the torsion bars that it came with, and use the whole rear deck for either the 3-10s or the MJ18. (Ya... can you say, can't make up his damn mind?) I plan on making the baffle changeable with EZ-LOCs so I can see which I like best. Then use a 4.150 to run the 8s, and the IB subs(s). These things are so tiny... half the size of the XT1600.4

Better back that shit up... and buy a new one!

temp installed PDX... no noise thus far, will wait to give final verdict. Nice amp!

It's always going to be behind you if your front end is not up to the challenge.

I didnt end up getting those amps to test yet... I'm just going to go out and buy a PDX4.150 today instead. Remember when I said budget?

Where in the fuck did this power wire beside RCAs = alternator whine bullshit come from?

Damping Factor is a stupid spec anyways... The driver design is what determines its cone control.

Only XT series US Amps are available authorized online.

I would... but the shipping to Canuck-ville is kinda a pain.

What Pioneer HU is that?

At that point, I just dont care anymore

Almost a guarantee

Wish people wouldn't ask for advise if they don't want to hear what I have to say....

Has your stock been replenished Mark?

until you upgrade.

IMO... oversize the main power. Nothing less than 1/0 to the amps, then use a 1/0-4ga. distribution block to supply the amps. I used KLM wire, good stuff, plenty flexible for a 1/0 wire. I'd get 25ft... then you can use it to the big 3 as well. Fuse size? I use a 200A on my 1/0, then use a distribution block that is fused as well. If you want a battery terminal, you need a side post style one.

If you are going to use expanding foam... don't just fill the panel. Do it slowly, it is activated by O2... so if it can't get any, it will take a long time for it to cure.

He's in sand land at the moment... I think he gets back from his time out there in 35 days.

You cannot purchase any US Amps lines beside the Xterminator line online... Budget?

Ported enclosure will not give a better response at the lower frequencies... after tuning frequency the roll off is super steep.

I'm down 22 pounds to 222 since the 7th of March now... funny too. Favorite number is 22.