Mac N Cheese

I wouldn't recommend going the cheap route and getting your original alt. rewound. In fact your stock alt. will do better at idle than the beefed up alt.

for Sundown

second the 15, also room for amps, batts..

since your only running 500w to it then its really up to you if you want to include the extra features. But i would get the cooling just in case

vehicle will be a 95 blazer with a 355 swap so the computer wont be in it and i can use the whole section behind the rear seats music will be -hip-hip/rap going for spl over sq dont have amp yet i will buy the proper amp once i decide on the subs also i will build a box or box's to spec once i decide what kind of electrical are you going to supply that amp with?

please read noob guidelines thanks!

second that, thanks!

the wire is clean for the 3000D but still not yet for the 100.4 whats a good way to secure it? block of wood plus L bracket If it where my car, I would get a battery hold down with the j-bolts, THEN screw a short piece of 1" angle iron to the floor on both sides an hook the j-bolt through a hole in the angle iron. this way the battery will stay put in a wreck/rollover. easy to remove also. thats a good idea, thanks ill check it out at lowes

off to Lowes for solder, and spray paint

i noticed that you have weird ass posting times, sometimes at 5am!! hahaha

ten page t0p

yeah i know what you mean, i wish the factory panel was an exact 6.5 because in the pic it would look funny

the wire is clean for the 3000D but still not yet for the 100.4 whats a good way to secure it? block of wood plus L bracket

crisp, alot louder with the tweets, clear, very pleased with them

here is my original door panel and i want to somehow connect the JL grilles to the factory door panel any ideas? i was just thinking a steady hand with a jig saw and hot glue it in but i am still trying to imagine if it will look good what do you guys think? keep it stock? or add alittle touch?

heres the pics, the wires for the 100.4 are still messy i need to clean them up a bit funny how my 1/0 wire looks clean but not the 4ga, 18, for the 100.4 lol front plexi still not attached, still need to install fan Alright guys, now you see my amp rack how it meets up straight with the box? what is a good way to connect them together? i used screws last time but it made a funny squeeking noise. I used hot glue and it didnt work the best but i think fiberglass resin would work great also here i need help on these door panels here too pics in a sec

PICS!!

yeah you should be fine, if you have a volt meter keep an eye on it...but otherwise your good to go

nice work

coffee coffee coffee

Well you are located in Cali, and are getting a 12 BL so i wouldn't worry too much about the shipping

i had this same problem with my BTL last week, i took out my 3000D and saw a screw in the amp guts, the power terminal was loose so it probably wasn't getting full connection. So swap out that amp for another one

looks REAL clean, nice work!