So I decided I was going to finish deadening my car tonight. Only part left was the floor. Now in hopes of being a little more efficient than the ole' heat gun, I used an oven I purchased for powder coating. Awesome deal for $30. Anyways, I cut all the pieces to fit, then removed the backing, slapped them face down on the aluminum side and let them sit for 5 minutes each at 200 degrees. Worked out pretty good. Hell of a lot quicker than sitting there fanning the heat gun back and forth. If anyone has this option available to them, I suggest trying it.

Don't let them sit for too long though or the adhesive(read asphalt) will start to bubble and overflow onto the oven surface.

That definitely works really well ...

Far better than heat guns if it's cold out.

At least in my opinion. I'm pretty impatient.

- Steve

Interesting idea...although I've never had a problem with heat guns being overly time-consuming.

whoa dude. you have the awesomest avitar ever.

whoa dude. you have the awesomest avitar ever.

I concour.................................. :thud:

I guess i am lucky.................my dad owns a food equipment company so i can use one for free thyats industrial.

J

I usually crank up my space heater on max and sit the mat by it. That usually works. Just make sure to keep turning it as you go.

whoa dude. you have the awesomest avitar ever.

yeah, where'd u get it from??

I met her at one my sexy parties.

I have to find the page with all the gif files listed of those

I actually did the same thing with a halogen lamp

Let it sit too long one time and the asphalt is still on my dern lamp

I met her at one my sexy parties.

oh too bad. I found a link to her on another site. She has a few nice little clips