Out of the mother fucking blue!! Gawd damn you! Nice update chop!

You underestimate his sneakiness

Full force!

I am very very sneaky sir.

Nice update Chop! Looking forward to this one!

Thanks fellars!

Means alot to have my team supporting me!

It is my drive.

Awesome updates Chop!  Can't wait to see the doors done!

SSA swag

Like a Boss!

Small update, but rather significant.

Started putting the zcons together last night.

It could of definetly went together smoother.

I have three of the four together minus soldering the terminals.

Hope to finish up the next weekend.

HELL YEAH!!

Looking good!

Zcon motor.

Note the gorilla tape residue. Undesirable.

If one should choose to ship and.want assure the screws are retained in the motor,

I believe masking tape would do fine, and not add this factor.

Work station pic

Getting closer:)

Zcon motor.

Note the gorilla tape residue. Undesirable.

If one should choose to ship and.want assure the screws are retained in the motor,

I believe masking tape would do fine, and not add this factor.

 

The residue left from that tape makes it not worth using.

I have the carbon fiber dustcaps as well, however, there were several issues that left me hesitant on using them.

Went with this crisp and clean bnib originals! I like them a lot.

Nice! Can't wait to have them in the wall!

These things are monsters truthfully....

I get chills looking at them!

Zcon motor.

Note the gorilla tape residue. Undesirable.

If one should choose to ship and.want assure the screws are retained in the motor,

I believe masking tape would do fine, and not add this factor.

 

The residue left from that tape makes it not worth using.

This was a better than the others scenario in the pic.

It can be cleaned off, just not desirable to the recipient.

IMO

Lol at your humour, should I just toss them!? Haha

 

Zcon motor.

Note the gorilla tape residue. Undesirable.

If one should choose to ship and.want assure the screws are retained in the motor,

I believe masking tape would do fine, and not add this factor.

 

The residue left from that tape makes it not worth using.

This was a better than the others scenario in the pic.

It can be cleaned off, just not desirable to the recipient.

IMO

Lol at your humour, should I just toss them!? Haha

No I meant using the tape. I tried it once and if you never have to remove the tape it is fine, but if you do there is some clean up.

Looking good chop!

 

What coil dd you end up going with?

I am anxious to see those doors finished!

Sucks about the residue & the look but there should be no effect on performance, right?

Ready for the Cutty to start waking the dead

ZOMBIE BASS!!!!!

Somebody has been busy since I've been gone! Nice updates.