Posted July 31, 201213 yr A friend of mine sent his 11k to get the mosfets replaced, it was repaired and sent back to him. And immediately he installed it and is now seein protection after we start to gain on the bass a little. It flashes once, which in the manual states low ohm and short circuit. Brand new mayhems @1ohm
July 31, 201213 yr Author 6 kinetix 2400. 2 xs d3100.. ohio gen 180amp. It play for almost a year with out problems but after the fets went out and was repaired then came the protect issue..the voltage doesn't even drop below 13.8 before protection.
July 31, 201213 yr Author I think the amp was bein played on a low voltage battery bank and had no volt meter to identify the batteries was drained by a dead one, that caused the first failure.
August 1, 201213 yr Check to make sure the subs are wired to 1ohm. It sounds to me like the amp is seeing too low of an impedance.
August 2, 201213 yr Author Even when we connect a dual 2 mayhem to it it still protects as u begin to gain on the amp.
August 2, 201213 yr Author No we haven't even considering it bein that it won't b playing it at that ohm load
August 2, 201213 yr Author sure have no problem tryin it, but what's ur opinion if it stil does it at 4ohm which ill wire it to?
August 2, 201213 yr Opinion is that it would be no way in hell that the amp is going into protect due to a low ohm configuration UNLESS one of the coils are bad.
August 2, 201213 yr Author That's exactly what am sayin knowin that ppl run that as low as .25..but the coils are good the subs are BRAND NEW mayhem and each coils are readin the same,, a guy who repairs them said it could b a chip that's stuck so he ordered one to try that.
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.