Search the Community
Showing results for tags '500w'.
Found 3 results
So, right now I am running a 2011 RF Punch P2 12" on a RF Prime R500.1 (500 watts @ 2 ohms). This is in a 1.72 cuft enclosure tuned to 31.8 Hz via 4" aero. I have the itch to upgrade. I understand that almost anything is an upgrade haha, but I was curious if the SSA GCON 12" would be a substantial difference in volume, and SQ? I would put this in a 3 cuft box tuned to 28Hz via the 4" aero. My current setup is in a 98 grand cherokee, but it will soon be put in the trunk of either a civic or corolla. Just as any extra info so you guys can help: Goal, loudest possible SQ with this sub. What do I listen to? : Everything from Dubstep, to Classic Rock, to Metal, to Gangsta Rap. Why am I singling out the GCON? : It's from SSA, great rep, low Mms more accurate sounding (low compared to the OA-12, SA-12, VVX-12), should sound good on 500, and figured i'd try to stray from the SA-12, VVX-12 trend. If you need anymore info, just ask, I apologize for leaving anything important out. Thanks for all the help and advise!
hey everyone, so, soon I will be getting a 1998 Jeep Grand Cherokee Laredo. I have the majority of my system ready to install. (please dont judge, i was not as educated when i bought this stuff) Rockford Fosgate P2 12" (2011 model) (it meh...), Rockford R500-1 amp (low efficiency, 58% @ 2 ohms) , Sony CDX-GT565UP (love it), and KnuKonceptz 4 gauge kit. right ow I have a crappy box to test with, its 1.72 cuft tuned to 31Hz via 4" aero. I will be building a 2-2.2 cuft box tuned to 32 once i am sure how i want the port and sub positioned. the current box i have the sub is on one side and the port on the other. so it will be easy to experiment how it will be positioned. my question is, how should i position my sub and port? i will test and tune once i get the jeep, but im curious if anyone is/was in the same position and could give some advise. im thinking either sub up center, port back driver side. or sub up center, port side (driver). any opinions? I guess im just eager haha. thanks for your help!
Hey, I am looking to build an enclosure for one Sundown E-12 in the near future. I plan on putting it into a 2.5 cubic foot enclosure. (PWK recommends an enclosure for the E-12 of at least 60L (~2.1 cu ft) for a more linear response) I also want to use a 4" aeroport (precision port) 10.25 inches long for a tuning of 32 Hz. I think my question is, would it be alright to tune this box to 30 Hz? All it would require is 12 of port length compared to the ten and a quarter. I'm just slightly confused because I have heard not to tune too far below a subs res. freq. because it might cause roll-off right at the tuning. If it sounds stupid, that's because I read it once somewhere on a forum haha. The E-12 has an Fs of ~35.8 Hz. If anyone is wondering what this setup will be used for/what is expected of it is... a daily setup, that will hammer lows. Sure I want to get as loud as I can doing this, but I have zero concern for numbers (db). It will be fed 500w from a RF prime 500.1. If there are any other things I forgot to mention that might help in determining if I should tune lower, please let me know. Thanks for the help.