General Audio

www.audison.com or www.audison.eu Enjoy! Kelvin

hey whats good.. im looking to make another box... i want to know what will be better for my subs... i have a pair of re audio sx 12 inch that i want to build a spl box and i have 6 12s for everyday driving.. for pwoer i have a kicker kx2500.1 and a hifonics bxi2006d so let me know what will be the best box.. and the best style of box.. right now im running a crx style box with flared port on my 6 12s and like i want to know where will be the best position of the subs and ports if its posibble thanks oh the sx i want it for spl but also to handle some music heres my current box i have 2 subs on the sides keep in mind that is some kind of like a push pull design on …

Ok so most of you have heard me ranting in the ihop about this for a couple months. But now i'm starting to overanalyze and getting burnt out. I'm putting a system (yo) in my father's vehicle. His hearing sucks, tone deaf, badly in one ear, bla bla bla. basically it's just something that will sound "good", his current system sounds like ass and is so harsh i can't stand to hear it. The new system just has to be loud enough to be listenable(is that a word?) at driving speeds. lets start with what i have so far 4ch RF amp (thank you ramos) for mids and highs, yes, i will be going active 2ch butler/phaze amp, i'll probably use this as the sub amp, why? because i have…

delete

well im getting ready to purchase all my front stage equipment, SLS-8's and probably CDT gold 4" 2ways. the question is, if i decide to go with raw drivers for mids and high like the Auras or Seas, which are about all 8ohm, whats the best way to get some decent power to them? i understand that 100watts to these is about sufficient, but i know of competitors pushing 800watts to each driver! so whats your front stage/amp setup? and any reccomendations would be wonderful

ive been after a clarion dz9255 for ages, they arnt available in europe so was thinking about importing one, clarion just done a press release in the uk for the new head units, which doesnt include the dz9255, so i winged a little and as luck would have it i won one i actualy won a clarion hx d2 but same model just malaysia spec so i can use the radio in the UK and slightly updated compared tot he 9255 what a good start to my holidays

I would like to know what voice coils I'd need to wire 6 sub as close to .5 ohms as possible thanks

This is my setup and i need advice to see if i need a capacitor or not. 2001 toyota avalon xl 2 Type r's 1222d Kicker zx1000 Kenwood double din headunit This is my first system and the people at the electronics store said that i need a cap but i cannot be sure. I dont know how to do the big three upgrade. My question: Do i need a capacitor and if i dont have one will my lights be dim? and Will the alternator and battery be able to handle the power without sacrificing the dimming of lights and other electrical problems? i think the alternator gives out 80 amps stock and with the car on it is between 13.5-14.5V thanks

I just got a Kicker s12l72. I was planning on getting the 40hm but I got the 2 brand new for a steal. But Now Im confused on what amp I should get. Will the Kicker 750.1 be fine. And should I wire it for 1 ohm or 4 ohms? Thanks

well.....10 months have come and gone and now it is time for a new ride......pics will come soon......

I was planning on going DIY active 2 way in the not to distant future and I was wondering what is a good Midrange that someone would recommend that likes around 75-100 watts @ 4 ohm. I was going to go with the Seas Nextel 7" but the puppy is a 8 ohm and I'm not sure if I have enough power to make it feel really comfortable. I'd like some recomendations of a 6.5" or 7" woofer with like 3 inches/3 & 1/2 of mounting depth to work with. My budget is ummm say $100-$150 per woofer but not set in stone if something that will sound awesome, clear, and low distortion cost just a little more. For now I plan on using the Seas 27TAFNC/G (H1397) 1" aluminum dome tweeter. Having bo…

How do I find the DCR of an amp?

ive given up trying to fit my 18btl into my 86 monte. i would either have to fire into the trunk(eww) or lose all of my trunk. so im thinking about switching to 2 ssd 15's which will let me keep about 8 cubes of trunk space. the ssd's should be better for sq but still get down and play hard. i was going to feed the fair a clean 2000 watts at 1 ohm. should i get them loaded or just leave them stock. if i get them loaded can they take more power. (daily)

Hey guys well ive sold my system and am getting a job soon to get a new one cause i had to pay for alot of random things the begining of this school year. Ok so im trading my Memphis MCD2500 for a Kinetik HC2400 and 220 cash. So i want an amp around 2500-3000 rms Multiple or Very loud single sub (leaning towards new T3 lineup or TC Sounds) i want this setup to be able to sound good and hit the looowws since the 220 is prob gunna go into my box cause i wanna get a custom one the budget for the amp and sub/subs is around $1000-1200 Thanks

System consists of 2 US Amps MD3D's, 2 AQ HD3's and a Kenwood KDC-X891. Alright I will be playing my system bumping it hard and all of a sudden my bass will cut out. I do not think it is the HU because the mids and highs continue to work. The bass will come back on when I turn the volume down or if I leave it playing for a few seconds. I do have electrical upgrades: 220A alt, 1100A batt under the hood, big 3 done, and 3 Deka Intimidator 9A31's in the back. Why is my bass cutting out. FYI the HU does have a ground problem meaning that when I play a CD I have turn on noise and a thump when changing tracks, none of these noises occur when I listen to the radio or my USB sour…

well roe and steve meade forums thinks i got hosed (im beginning to think i did also quess i deserve it for getting in a hurry. the new cdt's comp set comp set with rear fill and upstage

I've owned my car for over 10 years, and went through 3 alpine head units, and went from a pair of JL 12W6v1s to a single SI Mag and from a 600W Crossfire amp to a 880W Massive amp. I've always had a problem when I play bass heavy songs where the song would "skip" (actually, it stops playing for a split second) when the volume's at 16 (The gains were set by ear at 15 and I would never hear distortion with the gain knob 3/4 around. And I always turn it back to less then 1/2, because my ears can tell if it was distorting). I always thought it was the amp going into protect, but I just realized that the whole song skips and not just the bass. I'm thinking if the sub amp …

Denim will be excited I've posted this I've got a 03 Dodge Ram 1500 Quad Cab now, and my Explorer is being driven by my Dad. It's a long story as to why that is, if you care to know PM me. Anyway, I had 2 RE8's in a custom ported box in my X, which will in no way fit in the quad cab of the Ram. Aside from that, we have a 3 week old infant who of course requires a car seat, so rear seat functionality must be maintained. The only thing I can think of is to measure out the area beneath the seats and somehow cram the subs under there, facing out, perhaps angled back. I figure with 8's I should be able to pull this off. The only thing is that I do believe RE's function …

first time posting. I been lookin around this site a while and Im glad i found it. Well im redo the whole system in my car. And i wanted to do a 3 way active for my front stage. I a noob when it comes to goin active. But i wanted to do maybe a DD MD6.5, rainbow mr 100, and a jl tweeter. I still dont know wat amps I AM A be using but does this sound like a good set up so far? I AM A be running a 12 BTL off a sundown saz-3000d. And i listen to all types of music but mostly rap, if that helps. any advice is welcomed

I'm always looking for ways to improve my daily driver. I am not an audiophile that can tell a whole lot about staging and imaging but I do listen to alot of music that reveals the best and/or worst of a system and I do love clean output at extreme listening levels. I have been pretty happy with my Morel tweeters and Peerless 6.5" mids with passive crossovers (my favorite amp on them to date was a US Amps USA-2000 running at only 8 ohms...extremely clean with a ton of headroom. Anyone have any USA-2000x's for sale? ) Anyway...my problems have been as follows: I burned the coils in the 200w rms Morels once already and had to rebuild them...and the two 6.5 Peerless mids…

I am having noise issues when I start my truck and whenever I change tracks on my HU. I have a Kenwood KDC-X891 and whenever I start my truck I have like a humming, pulsing noise through my subs, and whenever I change tracks I get a little thump through my subs. However, this only happens whenever I am playing a CD. Whenever I am changing radio stations I do not have any noise, and if I start my truck with the radio on there is no noise. I do not have any noise whenever I use the USB port either. I can hook up a flash drive and flip through all those tracks without one thump and start my truck with it in this function without any noise, but once I switch the source to CD,…

it collapses the thread into a windows 3.1 view looks weird ! having to click on all comment lines, one at a time too read a thread is it suppose to do that, never did it befor

I am making a list of everything I need for my system and I need help. I plan on getting a Fi BL 18 loaded with a Sundown 1500 watt amp with a 10 cubic foot box tuned at 30hz. I want to use one of Sundown multi channel amps for the mids and highs probably the 100.4. I am gonna get a new starter battery and a battery for the trunk, isolate the battery in the trunk and get a larger alternator. Run all power and grounds 0 gauge. These are the things I am not sure of yet, what head unit to get, what mids and highs to get, what crossover to get, what brand of batteries to get, what size of alternator, and what type of equalizer. I can't think of anything else at the moment. I…

So, I will be running 2 subs off a 2k RF amp and also about another 1k watts to mids and highs. I will be doing big 3 and puttin a extra battery in the back (smaller one). Right now I have a 160 amp alt and a stock 730ampere battery. Are these going to be enough or will I probably have to upgrade them?

I am making this request on behalf of a customer. He is presently serving in Iraq and under normal circumstances I would ask the customer to provide the measurements of the trunk. The vehicle is a 2002 monte carlo and I am requesting/asking for is the Width, Height and Depth in order to design enclosure to what is recommended or the customers requirements. If anyone would be kind enough to provide the info, I and the customer would greatly appreciate it. Phil Woodlawn Cabinetry