General Audio

Just bought a brand new f150 stx with sync looking to put my stereo from my jeep back in the f150 the alpine type r components are probably going in the truck as well as my ppi 4 channel i think im going to sell my kenwood excelon 997 considering how much of a pain it would be to replace the stock and im probably going to sell or trade my dcon 15 and custom ported wedge box for somethkng that will fit under the seats in my extended cab any recommendations would be helpful for loc as well as subs and a box for under the seat that could run off the rear channell of my ppi 800 by 4

So I helped a buddy install an Alpine HU last night. It was the first time I worked on audio in a loooooong time. He wants to do an amp, front speaker combo. I am trying to convince him that deadening will be the best bang for his buck when doing the doors. He has about $650 for budget and I'm trying to figure out the best way to maximize the budget. Sound Deadening Based on what I see with SDS the 3M acoustic is the highest cost. I'd like to do 25% CLD, a layer of CCF and MLV, some CCF to control rattles and a little 3M acoustic (most expensive it seems) I can probably spend about $300 on deadening and leave $350 for Speakers/Amp Speakers I'm thinking that a passive …

What could be the cause of a staticy sound coming through speakers? It doesn't seem like any kind of engine noise cause it happens with the motor off. It sounds like static from the radio if a radio station is not coming in good but quiet...... And it still happens when my rca's are unhooked from my amp and/or head unit.

Hi everyone please any help How do you wire 2 dual voice coil subs that are 2 ohms and i have a 2 channel amp ( http://www.amazon.com/Lanzar-VIBE2102N-2-Channel-MOSFET-Amplifier/dp/B00BN7XQG4 ) i want to know how to wire them up to the amp at the 2 x 2400 Watts @ 2 Ohms RMS i have come across this page http://a248.e.akamai.net/pix.crutchfield.com/ca/learningcenter/car/subwoofer_wiring/2DVC_2-ohm_2ch.jpg%C2'> but does that mean that each sub is wired for 4 ohms. Any help maybe i am missing something or its something so simple but this is my first build and the subs are 2 12" Fi BT series and this is the only amp i have for now. If this amp is not adequate after help…

Hi, I recently purchased a pair of supertweets and pro mids both of wich are powerbass. I have been looking for an active crossover tk install them but am not sure what to get. I think they are supposed to be crossed at 5 thousand htz and above. This is my firt set of supertweets I have ever installed so kind if scared i will mess them up.not wanting to spend more than $200 but not limited to that much .Sorry if posted in wrong place.

I haven't heard very much about hear much about these subs except that they are under rated at 600w RMS, my friends 2009 ssa icon just popped, (intentionally) but were now looking for something new and i was wondering if you could run the obsidian at over 600w RMS daily. coming from 1250 with the ssa to 600 is kind of a change so just wondering.

I have a 2005 tahoe My set up so far is 2 15" hcca, crescendo bc2000, 1 cresecendo logic f-31 bat, 2 runs of O gauge cca from sky high. The ? Is should I buy another battery logic f-31 or save up for a 270 mechmen alt. my set up is at 2 ohms.

Ive noticed that my entire system gets louder when its raining outside! i know this sounds weird but i wonder if the weight of the water on the panels acts as a mild deadener? is the moisture creating a better ground perhaps? pretty odd..

I'm kinda new to car audio. Right now I'm just running a sundown e8v3 on a boss armor 1500 which actually puts out the ammount I need. Anyway I really want to upgrade and be loud. I'm not about spl and hitting high dbs more about music and perceived loudness. I can work with about 3.5 cubic foot box. I'm considering either a fi q 18 or a fi bl 15. I just need advise on which would be better.

just wondering what u guys think about this look.....

im looking for clean bass music with no distortion......i already have all decaf bass music. looking for new bass or modified music to try out on my system......could be country ,rock bass anything

Anyone here have an 8th generation Honda Accord? If you do what system do you have in it and what does your trunk look like? Im trying to figure out how to build a box my 12" XCON subwoofer but the trunk is so stupidly designed. its very wide towards the trunk opening then goes very narrow as you move towards the seats due the wheel wells arching up into the floor. I dont want to Kill my entire trunk space by having to build a box and put it towards the trunk opening cuz i need to use my trunk here is a picture of how the trunk looks (you can see what im talking about how stupid the design is and here is a picture of when i had my alpine type R's in them. …

I got a new incriminator 20.1 a month ago and just got a used one two days ago they look the same but the link cables are differnt on the new one it looks line a phone jack and the used one is RCA my question is how would I go about linking the two together

Im going to build a system for my bike and i dont know what box dimensions i need i will be using 2 8's and 2 6x9's and a small 400 rms amp the box i was thinking of was with the 2 8's each one on each side and the 6x9's on top of the box ... something like this but with 6x9's

My insurance is covering my truck and a tiny bit extra, so with the next vehicle, since I know it'll kill me if I don't ask, which is more audio friendly? (since the price differences on them locally are pretty much negligible, they all fall around $2500-3k) Jeep Grand Cherokee (1995-2003) Explorer Sport (1995-2003) or even another Blazer/Jimmy/Bravada (1996-2004) I'm only really picky about having 4x4; everything else, kinda blurs together to me. *The trucks i'm comparing are the ones that were left on the list after accounting for mechanical issues being taken care of; so no, I got my priorities in order

me and my buddy are thinking about doing a 8 inch sub build for his older brother as a surprise so i was wondering if you guys know or have any problems with these two companies or subs for that matter, also if anyone has any amp or box suggestions, it would be much appreciated. thanks

looking to pick up a voltage meter. but I am unsure of what to use. I thought about the stinger volt meters, but are they any good? probably beating a dead horse, BUT I did search and found threads from 2008, 2012. Just wondering if theres any voltage meters new on the market that are in yalls opinion a great meter. Just need to monitor my voltage. any help would be great. Brandon

Hey guys I have a 96 Cherokee Sport, I also have a Warden motor laying around that I want to build into a musical daily ground pounder. Im thinking ill just go with and OEM IA recone and I have an saz3000 to power it. Im just wondering if people have other single woofer set ups like this in Jeeps? What size are you using? Im leaning towards single 15" Any pics or vids out there or advice would be great! Thanks

I am not at all satisfied with my current mids and highs, they are just loud enough to be heard over the BTL, but they sound horribly stressed and weak in comparison. I wanted to put a pair of 8's in my front doors, and some new tweeters up on the pillar or the dash; before I look into getting pods made for my doors, has anyone had any luck fitting 8's in the doors of a Blazer/Bravada/Jimmy ? i'd like to keep it simple, at least til it's warmer out.

By buddy keeps saying that before aq sold there name the sub was 1100. I never have heard of this. And he swears they was. So if this is true how much would my 18 be then?

By buddy keeps saying that before aq sold there name the sub was 1100. I never have heard of this. And he swears they was. So if this is true how much would my 18 be then?

i got a hdc4 18. basically brand new. i traded my box my buddy built for me. dude said it had a blown coil on it. and when we tested it out was perfectly fine. so i got a steal. i drive a Ford Taurus and the trunk space for a 18 would be my the whole trunk. i just want some opinions on if you guys would sell it. trade it or recone it to a 15.

I have a question for you all. I found a guy that used to own a car audio shop back in the day. He's got the whole Hifonics VII and VII series. I'm interested in a series VII Zeus. It's hard to find people that will ship to military personnel overseas and he's willing to do this. He wants $700. It's new in box. I remember when I paid $1/watt. Does this still apply for a classic amp that's 20yrs old? I'm not trying to rip this guy off or low ball him but I was thinking $500 - $600 max! Am I being cheap? All inputs are appreciated.

So I've bought several CDs over the past 18 months or so and can't figure out what the damn problem is. I have a 5 or so year old Sony CD player that I use until I get my stereo install done, and it won't play almost any of my newer purchases. It acts like the laser can't properly pick up the tracks. It spends about 30 seconds glitching out making odd noises while the laser tries to lock onto the track, then errors out. Normally I'd tack it up to the tracking mechanism or laser pickup going out, but I can toss any one of my older CDs in and it works just fine. It's only the newer CDs that it has problems with. Sometimes if I mess with it for 10-15 minutes either by…

I am looking at purchasing a set of high quality headphones without breaking the bank. I will be using them daily, directly connected to my iPhone 5. I want a set to have good tonal balance and smooth response. Requirements: 1. Tonally correct 2. Closed back to aid with outside noise rejection 3. Low impedance to help get a high output level 4. Smooth frequency response The German Maestro GMP 8.35 D looks like a good set at $250. Thoughts?