Sundown Audio

I just picked up some scrap 13' pvc. how can i make sure i get a good square cut?

152s here I come. The setup.

Just thought I would post some pictures of my 1500D's. I did 149.2DBs with 2 Sundown 1500D's on an 100 amp fuse. The sub used was an Atomic APX. The score was at the headrest. Without fusing during my clinic I did 149.9DBs. All in all very impressed with the amps can't wait to get 2 more. I didn't have much time to test before the show but I believe with a little more tuning I'll be over a 150 at the head. The 149.1 was the second day.

Well guys... if all goes according to plan we should have some new stuff coming soon ! By years end we should have : * SAX-200.4 : SAX-200.4 Prototypes In - Car Audio Classifieds * SAX-50.4 v.2 (less crossover features and therefore cheaper) -- More information TBA. * SAZ-1500D v.2 (more compact... very similar power output... more robust MOSFETs for enhanced reliability -- of course the 1500D was already a tank) : SAZ-1500D v.2 Photos - Car Audio Classifieds * SA-15 Woofers : SA-10 and SA-15 Factory Pictures - Car Audio Classifieds Prototype SA-15 Excursion Test Video - Car Audio Classifieds SA-15s will be introduced with all the latest features we have been putting int…

Shipped prices are to the continental 48 states. Paypal ONLY unless I authorize another form of payment ahead of time. ---------- 1) Set of very nice passive crossovers. I had these made in 2003 and never used them... designed for a 4 ohm mid and an 8 ohm tweeter along with 0 db and -3dB positions for the tweeter. Originally made for VIFA PL 4.5" and Audax TM025F1 with a crossover point of around 3.5khz or so at 12 dB per octave. Yes, those are 12 gauge copper foil inductors that you see. Inductors alone are valued at: 2x 0.5 mH 12 awg @ $56.60 2x 0.68 mH 12 awg @ $66.30 These also have Solen Poly Capacitors... very high quality crossover designed with LEAP at Madisound. …

143.3db out of a trunk, unmodified rear deck, seats up with a single 15, a new NSPL World Record. Found out my alternator was dying and was only charging at 11.6V also, so burps were done in the 10.7V range also, so not too bad for the 1st time out with the overnight install. Another show on April 8th, at that show we'll get serious and throw down some 149-150's with the seats up.

Right now I'm building a new box for one 8" sundown Sa-8 that I'll be using until I get another 1 or 2. My current box is tuned too high for my liking. How much square port area is recommended for these subs? What is the lowest you would recommend I tune the box to? Right now I'm tuned to 34 hz, between .75 and .85 cubes after displacement by messing with some dimensions, with 13 inches of square port area. Is this enough for one Sa-8? I don't want to make too big of a box for it per Jacob's recommendations. Thanks.

I've had this amp for about a month now and yesterday as I was driving around I lost power to the front speakers. I thought nothing of it just thinking that the power wire may have slipped out. So when I got home I checked and the power wire is in, all the fuses are fine and there is power flowing through the power wire. The remote wire is also in and has power flowing through it. The amp does not turn on or go into protect. Not sure what else this could be.

i need to know the T/S Specifications for a sundown z v2 d2 15 and how big does an spl box need to be for it

To order a drop-in re-cone assembly e-mail [email protected]. To reduce back-and-forth e-mails ALWAYS include the following : 1) What you are ordering -- Model, Coil Configuration, Etc. 2) If you already have a basket or not; please check below for any special notes. 3) If you need ANY custom options please specify up front. 4) !!! YOUR ADDRESS AND NAME !!! 5) A picture of what you have goes a long way to be SURE we are talking about the same thing. 6) When you send payment include ALL details of your drop-in on the notes(model, size, coil configuration, options, etc) IT WILL TAKE, ON AVERAGE, 3-4 weeks for a built item like a drop-in to be completed. It may take l…

i was wondering if u could help me out sundownz... i am trying to find the depth of a sundown e8 v1 from the top of the surround to the bottom of the magnet. i am doing a stealthy build and depth is a big restriction. thanx in advance

im sure a few others are still wondering if u have any dates yet on when they could possibly be here and cleared customs? feb 2nd there is a comp in OH id love to go to if the amps are in by then. thx for the update.

ok! I have just a general question on spl boxes . lets say you have a box that can do a db of 150 in a ... lets say... a suburban now lets say you have two duplicate set ups two same boxes, two same amps , two same subs and you put both boxes in the same car would you end up with 300 db? now i know its more technical then being able to stick the same boxes together to make more db's , so whats the science behind this? also i know that its hard just to have the power going to the amps for a single setup none the less two setups so lets just say the power is coming from an outside source into this suburban ones again just l…

here is a little vid to kinda show the insane flex my nightshades do on my volvo s60.. i have a hari trick vid coming soon.. yes it will do a hair trick.. 8v9c6Lytkyw

wow this suck's dropped in my second 3000'd strapped @ 1ohm and only gained 1 db so now I'm doing a 151.7 wish i knew were my lost db went i would be up to 152.7. anyway's lot's-o-work ahead now

just as the topic says if so what did you do to blow it up? voltage low load? nothing?

I blew my sa12 and was wondering if this is part of the cone itself? and if i got a recone kit if it would fix this?

ok guys heres my prob.1st i have 2 saz3ks on 16v wired 2 half ohm on 4 15.2 NS. gains are about 1/2 or so. my prob is when i start 2 turn up the volume on the HU the subs start 2 pop and go crazy!!!! wha could my prob be? i kno it has more in it but i cant get the volume out of it and i wanna wang it at the dub show comin up 2morrow, so i need 2 fix this prob asap. any hellp ould be greatly appreciated. it start 2 pop at about 35/50 volume on the hu sub level on hu is around -3. around 38 is where i usually stop. never had this prob out of the saz1500s i had. wha could be my issue wit this setup.

Jacob I was wondering do you plan on coming out with a larger SAZ model anytime in the near future? I am strongly considering buying 2 more SAZ-3000D's, but if you are planning on coming out with maybe a SAZ-6000D I may hold off for a while.

WoofersEtc.com - SAX-200.4D - Sundown Audio 800W 4-Channel Amplifier MAP was $815 on these - they are being sold at over 25% off that price now from WoofersEtc.com exclusively. Get em while they last

So what caught my attention with this sub is the price. I'm not really limited on space but I assume this is just as good as any woofer but a shallower mount. I have two questions about it though. 1. What is the suggested rms ratting for this sub? Is it 500rms like in the name? Or is that like max/peak rms? 2. Also, what would be a very general ported box size for this sub? I'm guessing around 2 cubes tuned to 32hz or something? Thanks!

What's up guys? Just trying to get more of you guys to subscribe to my youtube channel. I will be posting more vids of the new setup for the KIA once my box is finished and ready to be installed, should be next week some time. The new setup is 4 SA-12's and 2 SAZ-2500D's and the box will be tuned to 32 hz. I promise to return the favor for you guys if you subscribe. My youtube address is http://www.youtube.com/user/dcraig63

Hey guy. I just received some pics of my new enclosure that is going into the KIA. The enclosure is tuned at 41 Hz for SPL, and 35 Hz for daily with the insert.

TC Sounds OEM 10" Drivers (2 of them). Enclosure will be built next weekend. Here are some pics. Side By side with TC sounds oem 10" (left) and a Diamond Audio D1 10" (right) both dual 4 ohm.

The camera didn't pick up the sound very well. Mic was placed on the dash on the passenger side. This was taken with an RTA but mine reads .1 lower than the local TL. So I believe this to be accurate. Peaked at 53Hz. Box is tuned at 40Hz. HzznT2SlpUQ