Sundown Audio

Ok I'm new to this strapping amps thing but currently I have 2 saz.3000d's and 2 21" incriminator audio dp's (they r both d1's) right now I have them both wired at 2ohms each and was wondering what kinda load am I getting out of each amp??? Am I pulling 2ohms from each amp and that wud be both amps strapped at 4ohms??? This is where I'm confused abt...also if I wire each sub down to .5 what kinda load will I pull out of each amp??? Will it be .5 out of each amp making it 1ohm strapped or will I be pulling .25 out of each amp??? Really confused was wondering if neone cud help me out thanks

Two Stinger SPV-70 Batteries / 40-amp Power Supply / 8 awg wire power and Ground (this amp should have 4 awg) Wired to 1 ohm nominal : 1170 Watts @ 12.5 volts 1.97 ohms after impedance rise Wired to 0.5 ohm nominal : 1490 Watts @ 11.1 volts 0.85 ohms after impedance rise --- Measured with my Extech True RMS power clamp meter several seconds into the tone @ 60 Hz -- this typically reads about ~15-16% less than a "dual peak hold" amp clamp test. We'll do some more testing with a more adequate power wire coming up soon. The test bench 4 awg has the ends tinned so is a bit too big to go into the SAX-1200D terminals -- will need to get it in a vehicle.

ok, so its either 2 15's or 2 18's and its coming down to port area that will decide whether i have enogh space or not. how much port area are you guys using for 2 18 nightshades. im shooting for 8cubes w/ ? port area @ 30hz

while the saz3000 says 6v-0.2v for the gain, does addin a line driver which puts out 9v is not safe?

wondering if its possible to only use one input when bridgeing a 100.2? i know alot of the oldschool stuff i used to run you only needed one channel (usually the right) when bridgeing. the reason i ask is because im going to run two bridged 100.2s as a stereo pair and would like to avoid any funky Y-splitters or anything like that.

The next person that paypals me 5 dollars will get the inside scoop on what is going on at the Sundown HQ?

I show you a bit of Italian works I hope you enjoy our work are only a few works this is our page facebook: https://www.facebook.com/SundownAudioItaly Fabio Adimari Italian Dealer

I received a brand new Sundown saz-1500 this week and I just got around to installing it. All I can say is wow, it pushes the heck out of my RE SE 10 d4. It's funny, this is only giving the sub about 800 watts since it's running at 2 ohms. In addition, I have the gains on the amp turned way down, as I have not had a chance to set the gians properly yet. I think it's going to be time to get a sub that, first of all, can get to a one ohm load, and secondly, take the 1500 watts. That amp is a beast. I'm excited lol. I also received a Sundown sax-100 today for my highs, but I have not had a chance to install it yet. All Sundown as far as my power goes. I am converte…

Hey Guys....I recently installed a SAZ 1500D and I am now experiencing engine noise (a buzzing type of sound). I can unplug the RCA's from the SAZ and it goes away. I was told that I should ground both of my amps in the same place and that might help...Well, I've done that and it hasn't helped. Prior to installing the SAZ I had a JL Audio 500/1 and it didn't have any noise. I've even ugraded my BIG 3 and also ran some 1/0 gauge since installing the amp thinking that may help....But the noise still remains. The RCA's are new and I cannot imagine why they would make any noise since they didn't with my previous amp....Is there a possibility that the SAZ has something wr…

I wasn't going to start production on these so soon... but there is demand from my International accounts for these so I may start them pretty soon. Who would be in to a pre-sale on these ? Price would be $150 shipped in the continental USA for one and decrease a bit for multiples. I won't start immediately... I am testing one more prototype cone before confirmation... but I am surveying interest.

Little project I'm building... These are not available for the general public at this time, sorry guys!

This is not a pre-sale and Sundown Audio is not accepting money at this time. The SAZ-1500D and SAX-100.2 models are scheduled to be released around the end of July. When they arrive I will notify the board and all SS Audio members are eligable for a special introductory price for a 2 week sale period! The intro sale pricing will be as follows: $450 --> SAZ-1500D $225 --> SAX-100.2 $625 --> SAZ-1500D and SAX-100.2 package (Save $50!) North Carolina residents add 7% sales tax ($481.50, $240.75, $668.75 respectively). Prices include shipping to the continental USA. Stay tuned for the sale to begin. Current estimate for stock is July 25th, but this date is subject t…

I have no direct Sundown experience, I have read a lot of good things and I'm here to see what they have for my application. I have been researching amps for my newest upgrade from 10s to 12s and I wanted to get some suggestions. I have two 12" Cadence SE Solo Beast DR subs dual 2 ohm vc, 600 wrms / 1200 peak per sub. I would like to be at about 600@4ohms and 1200@2ohms if possible so that if I choose to I can run only one sub at a full 600wrms and potentially upgrade subs in the future. Sure I'd like to say that SQ is all I want but, not in the trunk, SPL is what a sub if for IMO. I would like to compare actual numbers, for example, I've considered only 13.6-13.8 volts …

iv'e been doing some reading and am thinking of buying a saz-3000d to run my Fi q series 15's in my system upgrade. my question is a ho alt a must or will i be able to get by on factory for a while ? i have been looking around for an ho alt for my car but it seems like it's going to be hard to find one. I have a 2005 sonata four banger not your everyday base mobile.

woofersetc_outlet has nightshade v2 for sale. http://cgi.ebay.com/NIGHTSHADE-V2-SUNDOWN-AUDIO-SUB-15-DVC-2-OHM-SUBWOOFER-/110593096169?pt=Car_Subwoofers_Enclosures&hash=item19bfdcb9e9 Anything wrong with buying from them?

can i get to nightshades dual 1 ohm, wire them dowm to 0.25 ohm and run it on my 3500d. i will have about 3 batteies and h/o alternator with 250 amp. in the testing jake did the resistance, and it rose to 0.67 ohms. which they can run @0.5 ohms, right?

is it safe to run my sundown audio 2000d at i believe .5 ohm? i have 2 15'' fi btl's dual 2ohm subs,,, so i can wire them to .5 ohm... i have a 05 f150 , 1 optima yellow top , 0 gauge , big 3 , xs battery 900d and of course the 2000d... am i ' safe ' ??? im currently savingmoneys for a HO alt.. please help...

was installing a new to me sae 1200 from db-r when the worst thing happen the bit fell out and arched the speaker terminals.. everything shut off came back speakers made a weird hissing noise so i swapped it out seem to help the sub works for a little then cuts out

Last night as I was just listening to the radio as I was driving along and I began to notice an odd smell in my car. My volume was low, and I have not played my music loud in a while. Initially I thought maybe something was just coming through the vents outside. However, when I got home and popped my trunk I was greeted with a haze of white smoke!!!!! I am running two amps; an SAE-1200D and a SAX-50.4. Upon further investigation this morning I checked the impedance of all my speakers and they are what they should be and my voltages are correct at the amp. After letting the trunk air out a little bit I noticed that the smell seemed to be associated with the 1200D and n…

My sub woofer sounds like the voice coil is frying on only about 350 watts rms at 4 ohms is it some thing to do with the new cones in the middle of the cone it gets pretty hot after only a couple minutes

Hey guys, I'm new here and I'm looking all over the net for some good info and I stumbled upon this site by a fluke I read on few forums that this is a quality amp and seems to be going for a price of $200 which is the top I want to spend on an amp, budget is tight. I've got two sets of coaxial speakers, both Alpine, one is Alpine Electronics of America, Inc. and the other Alpine Electronics of America, Inc. I'm working with limited space of no more than 17''x11'' in an enclosed trunk space, I will attach picture of someone elses car with the location of where I also want to put the amp.

Ok, got my 3000d today. Wired it to 1/2 ohm, and it just doesn't seem to be putting out power. i had the gain set at about 1/2 and it just seems like it's not puttin out the power. voltage read 14.53 and amp read exactly 0.5ohms. Also, when i turn it up to where i normally listen to it at the subs start cuttin in and out so i turned the gain down more and also turned the sub control down to like 5/15 and it still does it. Voltage barely drops, and it's really not loud AT ALL. what could be the problem?? Also, the amp never went in to protect or anything, i'm stumped...

Ok I am buying a little Mazda MX-3 Hatchback to have some fun with SPL local shows. I want to buy this guys NS 18 and I need enough power. Mostly for daily with some burps a weekend a month.

ive got 4 12's that handle 1500 watts max a piece and a box being build to spec.i was wondering if a 1500d would b enough for as3 next year at competition.i am planning on getting a second one the year after and strapping them.im using 0 guage wire and a 100 amp fuse.ive got a factory alt. w a decka intimadator batt. under the hood.will that be enough power and can i run them at.50 oms.?im doing the 4 12's cause i just wanna upgrade amps and batts. the following year.please give me some feed back.i would greatly appreciate it..

I'm looking to purchase a btl18 fully loaded "daily" I listen to mainly hip hop and I want a sub that poundes will this amp be a good match up with the btl 18?