Sundown Audio

ok! I have just a general question on spl boxes . lets say you have a box that can do a db of 150 in a ... lets say... a suburban now lets say you have two duplicate set ups two same boxes, two same amps , two same subs and you put both boxes in the same car would you end up with 300 db? now i know its more technical then being able to stick the same boxes together to make more db's , so whats the science behind this? also i know that its hard just to have the power going to the amps for a single setup none the less two setups so lets just say the power is coming from an outside source into this suburban ones again just l…

does anyone know the price of the saz 4500 after sales well towards february?

in my future install i want to go active with my 100.4. and i want to get a pair of ID horns. here is how i am going to set it up. 1.2khz and above to the horns 80hz-1.2khz to the midbasses so will i be needing 2 sets of rca's or just 1?? b/c i will be using all 4 outputs right so i should have 2 sets of rca's?? sorry i haven't ran active before so i am a "active virgin" lol!! so i will have some question so ANY help here would be good. my new install will be starting in the summer so i have plenty of time to think and plan to get everything right! my new install will be 2-15inch NS v1 and 2-saz2000 strapped with 2-nsb90's and 1-h/o along with the big 3 (the h/o and b…

How many amp hours will be needed to run a Saz-3000d on .5 ohms? i will be having a 270 amp alt. thanks, Julian.

How much would I gain if running one NS 18" D2 on saz-2000D against saz-1500D? Would there be difference on the ear with 500W more from saz-2000D? Is it really necessary to run over 1kw more than rated(assuming the underrated power of saz2000) to get loud or I should run 1500D and save that 100$. I don't really care about the meter. Just want to save some money.

This is the second one I've made. They are a pain in the butt to do... so I never offered them openly. Everything is so tight even the tied down leads smack the cone -- so I will likely go in and glue on some felt pads behind the cone. In any event... here she is : * Yes, the dust cap JUST fits inside the surround... actually have to pry it out with a screw driver even without glue. * Terminals come out to the side so I can solder the leads after assembly. * Big motor on small frame !

PRE-SALE ORDERS ARE FINAL - THERE WILL BE NO REFUNDS -- If you are not 100% sure you will be financially stable then don't pre-order. No more exceptions. <b>THESE WILL NOT BE IN UNTIL AROUND THE END OF OCTOBER!!!</b> <i>If you want something sooner the 3500s are expected in before the end of August so I suggest getting one of those.</i> DO NOT pre-order if you are in a rush or on a dead-line -- as always there can be delays with pre-orders. Just want that to be clear <img src="http://www.soundsolutionsaudio.com/forum/public/style_emoticons/<#EMO_DIR#>/smile.gif" style="vertical-align:middle" emoid="" border="0" alt="smile.gif" /> In any…

Minimal break-in time... just a few minutes on the bench: RE (Series): 4.33 ohms Fs: 30.3 Hz Qes: 0.519 Qms: 7.250 Qts: 0.484 Le: 4.743 mH Vas: 29.077 L BL: 22.168 NA Cms: 89.22 uM/N Mms: 308 g Took a few minute break from shipping 4500s and measured these bad boys... I expect Fs to drop to 25 Hz or so with full break-in... which will take probably a week or so of play on these.

ok here is the question . Assuming everything is the same. Same car, enclosure built to the specs of the sub ect, ect....... which would sound better and why. A sub with a rms rating of 2000 watts with only 1000 wrms going to it or, a sub with a rms rating of 1000 watts with 1000 wrms going to it????????? hope to see if I'm right.

Back in stock now with D2 and D4.

Is it possible to get a custom recone for a pair of RE HC's that I have?

I would like to know how much is the recone for ns 12" and whats included in the recone package? TIA.

my bad i put my last one under ssa antone know when the saz 4500 comes out?

I've got a couple of questions for ya. I recently purchased an saz1500 with the intent of running only one SA8 (d2). Which I have already purchased too. The goal is a tight musical system for daily driver. The concept for the box - install is to build box tall and set in the corner of the hatch back leaving room for groceries. I have approximately 2 cu ft to work with. I would like to have the ported box portion on top of a battery compartment using the same enclosure. Here are some questions 1. Will I have battery problems because of the vibes from the box? 2. Will 1500 be too much for one 8? 3. Is a second battery needed? Vehicle 2009 Honda Fit Stock HU Stoc…

The Dual-2 SA-12s will be in stock shortly... likely within 7-14 days -- along with the second shipment of the Dual-4 version. I've had alot of people anxiously awaiting the Dual-2 version so I thought I would let everyone know

This may be a dumb question but.......i saw on another thread about the 8" @150db talking about you running it on a 3500d @1 ohm and putting about 1500-1700 to it correct? But the 3500d is rated 3500 @1. Does it put out the 15-17 due to gain and volume turned down, or what? Also, i see people talking about running .5ohm daily, what kind of power does the 3500 put out there without clipping? what about 1 ohm @ 16v?

How do i get some of these? i broke one pretty easily today and would like to get a few spares to keep on hand. do i get them from jacob or dose home depot sell something close. if so what size, what pitch? thanks

Goofy question I know, but my 100.4 just came in and I was admiring it... Tehn as I was looking at the lil knob that come with it, I had the thought that I don't normally adjust my gains or boosts after they are set... Also, I don't really have a place or want to mount 2 knobs up front on the TrailBlazer when I get my system in and if I ever do get the system in teh Blazer, I sure don't want 6+ more little knobs up front there...

Hey guys, just curious I'm reading on another forum that the sae and saz are comparable! Is this true and are only about 200 watts in diference can anyone elaborate? If so which is better for a single 12 to 15 inch woofer rated about 1-1.5k.

What gauge of wire will your Sub's push connectors accept. Specifically the new 8's?

These all have original boxes + remotes. They are all "new case" style amps. Cosmetic condition varies slightly between them. ONE YEAR warranty included. $350 shipped each in continental USA. These are USED amplifiers... they are not NEW. Cosmetic imperfections are a given... if you plan to complain about any small cosmetic blemishes don't buy them. I will say it again... these are not new and are not necessarily mint condition. * Tape was applied to the face of this amp, you could scrub the adhesive off.

Trying to figure out how lonely I am in this great sunshine state! I'm in the Fort Myers area...anyone else?

http://www.facebook.com/#/video/video.php?v=1258050525783&ref=mf

I have a set of cd1e horns and need to tune this amplifier down. The horns are 40 watts each @ 8ohm. What should the output voltage look like from the amplifier? Does this sound right? E^2/R = W (W*R)^(1/2) (40*8)^(1/2) ~= 17.89 volts

I understand that the specs on this amp state 160x2 @ 4 ohm bridged and they are underrated. I was just wondering what these amps normally put out at 2 channels @ 4 ohm bridged.