Sundown Audio

Just pre-ordered an SA-8 to play around with...can't wait to receive it! Gives me time to build the box. From what it looks like, something like a .75-1 cu. ft. ported around 34 or 35Hz should be a good starting point for good sound/efficiency right? Planning on running about 450-500 watts to it.

Todd Mayton Amateur Street 3 & Drive-by 3 Equipment: 4 T3 TSS 12's & 1 Sundown 1500d AS3 - 145.3 - 1st Place DB3 - 122.2 - 1st Place Shannon Lee Modified 4 Equipment: 2 T3 TNSF 18's & 2 Sundown 1500d's M4 - 150.9 - 1st Place Highest SPL of the Day Robbie Wyatt MECA Kids 2 Equipment: 1 T3 TSS 12 & 1 Sundown 1500d MK2 - 140.6 - 1st Place For show pics, check out www.myspace.com/wsfchris.

ok i have my sundown shirt... black is a bit hot on comp days sometimes.. lol.. but i love the shirt... i really think we need hats... i dunno if jacob has something like that in the works but id be willing to pay good for a sundown audio hat....

Just wanted to give a public thank you for the amazing customer service!! The amps showed up today, a couple days before I expected them to. I will always give you the first shot at any audio business I may have in the future( and I know I will;)). Just got my 2 sax-100.2's to go with my saz-1500d. I'm gonna try to run them in dual mono to my Diamond d-971 components, I think that will drop my noise levels wayyyy down, and really help my staging/imaging as well. Again, Jacob... THANK YOU!!!

Sunday Brandon and Jake pulled 151.6db @ the sundown show a.k.a Meca . . This morning at the shop, there will be a little trash talking going on , well I hope anyway. Brandon's truck had a problem w/ the maxx-link and he lost 2 subs .

In Meca where less is more. What fusing should I drop down to on an saz 1500? A little more info for my particular install. Amps SAZ 1500 SAX 100x4 Power Stock alt 2 yellow tops for a total of 88 amp hrs Subs 3 sa 8's I would like to run in the lowest class possible

Truck/SUV 0-30 - We did a 146.4 dB. Good enough for first place for the day. Truck is unmodified factory electrical and no sound deadening. 1 SAZ-1500D on 2 SI Mags D2 12's wired to .5 ohms in a 5cu ft box; did a good amount of work to get the port just right. Looks like the key frequency was 48 hz.

got my saz-2000d and sax-100.4 in the big brown sleigh today. loving this support i need to get to work installing these.

Just wanted to publicly thank Jacob for his support with my cause! A great guy with a big heart and with a great product! To save some typing, here is a link: http://www.soundsolutionsaudio.com/forum/i...showtopic=26719 That right there my friends shows this company is going places.....well besides DOMINATING SPL events.

Okay if I've done my math correct, the 3500D (with a 350A fuse), I should be able to power this thing with a 250 amp alternator and (2) D3100's (117 AH each) running at 1 ohm on (2) of the of the Z15's?

YEAH!!!!!!!!!!!!!!!!!!!! I JUST BOUGHT A SUNDOWN SAZ3000D!!!!!!!!!!!!!!!!!!!!!! I'M KINDA EXCITED FOR IT...

I know the sensitivity is only up to 6 volts but ill be running 2 3000Ds strapped

Tarheels Auto Sound Challenge # 3 Sunday May 17th all classes spl/sq/dbspl registration starts at 9:00 AM and closes at 1:00PM. This is a MECA 2x point event . We would also like to welcome NSCSPL to the event as they will also be hosting a show as well. That's right we will be holding TWO shows at once. Hope to see you there.

As long as I don't let my voltage drop I should be able to strap them at 1 ohm right ????? what is a 3000d rated at at .5 an ohm has any one ever tested them??? plan on runnning four dd 12's 3500 or 9500 at 1 ohm is it worth it??

Hello everybody. I just wanted to let everyone know that my Kia Sportage SUV is on the Sundown Audio's Rides Page. It is listed under the Customer's Ride's Page, but it should be listed in the Team Sundown Audio Member's Page. I am just happy they accepted my pics. Tell me what you think guys.

Finally getting started. Car already had a system. Its about 6 or so years old. Going to redo all of it from battery back. New system includes Replacing 4g with Shok 0g. (in the mail now) New Battery Alpine Type R Components (alrdy in car) Alpine deck (alrdy in car) JL 6W0 in rear spots for midbass (alrdy in car) Front half and doors ardy has Dynomat Extrme Doing hatch in second skin (in the mail) also adding luxury liner pro to doors and rear finder wells SD 100.4D for components and midbass (aldry have) SD 1500D for subs (still need this one, so if anyone has a used one shoot me a pm) 4 SA-8s running 1ohm (alrdy have) start with pic of car and old hatch that…

put it in this morning... spent the rest of day driving around enjoying it... first, let me state the system, 1/0 knu-con, in engine and to the back 230a, alt 110a idle? yellow top up front, kinetik 2400hc back 300a circuit breaker front, and back. stinger volt meter. with gain @ 1/2 on the amp, no bass boost, 1/2, or less boost from the alpine deck, at volume 20, 35 is max... one song popped the breaker. voltage held good, well not at idle, but did drop just below 12 at times when pushing it hard. the orion 2500 put up 147.2 when it popped the breaker, put I was pushing it way harder. So, I hated the breakers then, and do now... what are you guess fusing these amps a…

Hey guys i need some more knowledge from the ever so wise ppl here on SSA! Here is my problem. current setup is: 1-15inch NS 1- sae1200d amp big 3 0/1 wire 1-100.4 and 2 batcap 2000's in the trunk! my problem is when the bass hits even at 1200rms my lights will dim it isn't a bad dimming but still a diming occurs and when the new saz 2000 arrives i am worried i will be running into a problem...The only remedy that i have heard to fix this is to get a cap? but if i get cap would i wire the cap before or after the batteries? and what kind a cap should i get? any ideas would help me out A LOT!!!! thanks for your help and advise Kenneth

What the minimum and maximum voltage u could run...say a 100.4...or 4500d...what would be the safest for a 16volt system for a 4500d?

I got my 1200D yesterday evening and had a chance to look it over and take some pics today. 1st off this thing is built like a tank, very solid feeling amp. It blows away the Infinity 611A I have been using as far as build quality goes and the Infinity costed just as much when I bought it new a few years ago. Not to mention the Infinity puts out half the power. On one side of the amp it's got heavy duty power connecters that take 1/0 gauge wire. They are not made from cheap crap that makes you afraid to tighten things up.The speaker outs and remote turn on are built the same way.It's also got 5 30 amp fuses. On the other side there are 2 rca inputs and I believe 2 rca p…

Todd Mayton (Twisted Mayhem) Amateur Street 3 - 147.7 dB Amps - 4 Sundown 1500's Subs - 4 T3 Audio TS 12's Oran Barkley (Team OSC) Mod Ex 3 - 148.5 dB Bryan Mayer (Twisted Mayhem) Street 4 - 148.0 dB Amps - 2 Sundown 3000's Subs - 12 True Bass Ultra 8's Shannon Lee (Twisted Mayhem) Modified 4 - 150.6 dB Amps - 4 Sundown 1500's Subs - 2 T3 TNSF 18's Christy Gambrell (Twisted Mayhem) Modified 1 - 142.9 dB Amp - 1 Sundown 1500d Sub - 1 RE MT 18 Honorable Mentions TN State Finals Competitors - Goodlettsville TN - 10/26/08 Daniel Kirkland (Twisted Mayhem) Mod Ex 1 - 148.2 dB - 2nd Place Drive-by SPL 3 - 119.7 dB - 2nd Place Mod Ex SQ - 61.2 pts - 2nd Plce Mod Ex Install - 66 p…

I had decided to go with another set of 18s and swap amps too. But, I really would like to get alot of my room back. So, I will sale my bl 18's and keep both sundown saz 1500d's. I would like to change to either 2 12" nightshades or 1 12 or 15" with both amps strapped on 1. I have 20 cube box now, so anything smaller I will get alot of room back. Any suggestions on those above or possibly Z15?

well im upto a 153.2db now as my burp score 8 sundown 1500d's 4 dd 9515's (pre-wired) ****UPDATE**** this is with no testing other than throwing the subs and amps in and checking volume and tunning 153.2db burps score 152.3db bassrace (perfect start) 151.9db bassrace (later start) this is as clean as it gets untill i get to a 155db

I have 2 1500s coming to me and before i install them i want to make sure that my electrical will handle it right now i have a stock alternator on my bravada (blazer if you will) pushing ~110amps and 1 yellowtop optima my plan was just to replace the stock alt with a 300 amp one but seeing as these amps can be run at a higher voltage than 14.4 i was thinking of doing dual alts and running 16 volts on a 300 or 200 amp alternator (whichever is reccomended) and have a seprate battery in the back I would like to get as much power from them as possible so i will most likely strap them @ 1ohm (i know its not covered under warranty) I just need to know how big of an alternator…

Please say the upcoming (and highly anticipated for me anyway) SAX-50.4 model will have the same awesome crossover capabilities as the new SAX-100.4 Rev D?