Sundown Audio

This is Team Nemesis Jay's Magnum. It has a pair of Sundown NightShade 18"s powered by a pair of Sundown saz-3000s. This car loves screwed music and will play it all day long. The amps never get warm and the subs barely get a temp even after some hard beating. Here's a vid. The song playing is a screwed version of Gorilla Zoe - Waddle that peaks @ 31hz. I've heard some comments about NightShades not being able to play the lows. Well here's a reality check.

i was having some issues with my electrical, and my battery died at the school yesterday. long story short i had to go get a new battery and put it in. well at the school i don't have any tools in mine or my friends car. i decided that i was sick of hearing them rattle last week so i took them out hahah. and so i could only tighten the terminals by hand. well on my drive home, so i can completely tighten them, i was having some shorts goin on with the terminals and i ended up blowing 2 of my 30 amp fuses on my amp. i was just wondering if there is any way i can test the amp myself to make sure no other damage was done? i'm about to go get some new fuses, and i will get ba…

in peoples opinion which sub will sound better for spl. both will be in ported box built to specs, powered via 3500d?

8x SAZ-3000Ds - SEE BELOW * 3x Excellent Condition New Casing -- re-built by DB-R * $725 each w/ FULL 2-year warranty * 3x Good Condition New Casing -- Used Amplifiers * $675 each w/ 1-year warranty * 2x Okay Condition OLD Casing -- Used Amplifiers * $600 each w/ 90-day warranty

This is for the Saz-1000, 1500, 2000, 3000, 3500 and up as well as the Sae-1200. Lets start out by saying that these amps are mono block amps. This means they are internally bridged (paralleled). First lets take a look at the sub. Unless you trim the wire down two 8 gauge are not going to fit in one terminal (if you want to parallel the coils at the sub). So, what I do is parallel the coils at the box. This is a picture of the speaker wires inside the box. This is what it looks like on the outside. Since the coils are paralleled on the inside of the box with the bolts, all you have to do is send two positives and two negatives to the amp. You can even put a set of …

hello my name is kyle i'm new to the fourm but i'm real cool with one of the sundown Reps Dj Williams i was wondering which is the Sound Quality Z or SA also which is the Sound Quailty Loudness sub i'm looking at both subs i want a mix of spl/sq if that is possible.

i will be redoing my install in a few months and wanted to know if maybe i can color match the amps with the color of the car... not really gonna be going to shows just a personal preference, i think the amps would look sick painted... new set up will be 2 15 ns, 2 1500s, and a 100.4, the box is getting built by pete which we havent worked on the details yet but he stated that we might go the horn route... i have a good bit of room to work with, enclosure space to work with is 16 high, 42 wide, and 30 deep... also i have a ohio gen 180/225 alt and getting a d3100 to replace my 2 dekas ( which i plan on selling).

http://www.youtube.com/watch?v=YhCUZCG8l5w http://vids.myspace.com/index.cfm?fuseacti...ideoid=54115137

$425 from TODAY until April 18th, 2009 -- PAYPAL me at [email protected] to place your pre-order. The above is an ultra-special discount for those patient enough to pre-order NOW and wait for the amps until they come in. It is equal to the best sale price we had on 1500Ds! $485 from April 19th on until they arrive around the end of June (ETA is around the end of June). ALASKA AND HAWAII ADD $15 Regular MSRP = $899 / MAP = $625 PROTOTYPE PICTURES: * Production models will have the mirrored part number like the 1500D. * SAZ-2000D requires external fuse. Production will have the "new case" with internal fins. * SAZ-2000D in the center You can see test results vs. …

so i was tunin my amp for my 12" Q. and i wanted to use as little bass boost as normal on the amp. but even if i maxed out the gains, set my LPF around 80hz, and turned down my bass boost to 0db. i was only puttin out about 17 volts (if i remember correctly i did it early this morning). i know it was below 20.. and i needed about 31.6 volts. is this normal? i used 50hz tone when i had no BB, and when i used it, i used a 60hz tone. the only way i was able to reach my needed volts, was when my gains are just over 3/4 set, and my bass boost is about the same spot, 15-17db. but is that about normal? would it be better if i maxed out the bass boost and compensated with my gai…

havent seen any available on SSA site. just wondering where can i pick up a set of 15"s. just preordered the 3500d lookin for something that can hang. also order 100.4 need components for that too. i have a set of 3 way components but i dont know if i wanna use them they are 350 watts rms.

I've been at SBN from Thursday night to last night... just now back in the shop. If you have not had a reply via PM or e-mail that is why. I will try to catch up today.

Refurbished saz-1500d or new saz-1500d. the new one i can get for 600 and refurbished will be getting for 450. which should i choose? this is coming from db-r.com

i read some were that the SAE-1200D is not stable @ 1 ohm. is this true? would i be able to run an fi bl with dual 2 ohm coils at 1 ohm for long periods without harming the amp?

i met up with nightshade the other day just to talk and hear the shades. And let me tell you its brutal!! i have been to a couple of shows and havent heard anything like this. vision blurry, hard to breathe, felt like somebody was just punchin me n the head and kickin me n the chest and that was only halfway on the bass knob. at full blast, i felt myself drifting in and out of consiousness LOL . zach is one of the coolest dudes youll ever meet, and he knows his chit. Just wanted to show him so love. Shout out to team sundown!! the videos doesnt do zach's setup any justice. his car flexes like crazy!! oh, and excuse the terrible cameraman **cough**

We are leaving tonight... so Sundown is closed Friday and Monday. So - if your stuff hasn't shipped and it is Friday or Monday that is why. We'll be back soon, though!

I made it here safe ..........

I am very excited, just threw it in. Only a little tuning and already sounds better and louder then the Kicker amp is replaced. :woot:

is CA glue or the new epoxy included with a recone? i need to know if i have to find my own, or it's included

Regular MSRP $349. Special price $225 until end of March! You can order from your favorite dealer OR Paypal me directly at [email protected] Rated power output ----RMS power, 4 ohm stereo 50W x 4CH ----RMS power, 2 ohm stereo 80W x 4CH ----RMS power, 4 ohm bridged 160W x 2CH Signal to Noise Ratio >90dB Low pass frequency crossover 50Hz~500Hz (CH1&2) 50Hz~5KHz (CH3&4) High Pass Crossover 50Hz~5KHz (CH1&2) 50Hz~500Hz (CH3&4) Variable Subsonic Filter 10Hz to 500Hz Bass Boost 0~18dB Variable Bass-Boost Frequency Control 35Hz to 120Hz Frequency Response 10Hz ~ 40KHz (+/-1dB) THD@RMS Watts <0.1% Channel Separation 75dB Fuse Rating…

i have an sax 100.4 and i have 2 pair of alphasonik pct6551 3way components,2 for the front and 2 for the back there are rated at 350 watts rms would the amp be powerful enough to power the components. or should i sell them and get a lower rated component set?

ONLY VOTE YES IF YOU *WILL* ORDER ONE during the first 30-day segment with the extra discount. Do not vote if you think you might... only if you will. Please POST if you voted YES - all other posts will be deleted. If I started it now and ran the pre-sale for 30 days it would 60-90 days after the "initial" pre-sale for amps to arrive but you would save $60 per amp vs. even the regular pre-sale for waiting the extra time. POLL RUNS UNTIL TUESDAY 3-17-09 -- if enough people are saying they will do it pre-ordering will start then. This puts amp delivery in late June to mid July. --- ORIGINAL POST: Who would be willing to put money down towards getting amps in late June if a …

10% off all SAX-100.4 Refurbished until 04/15/2009 dB-r Electronics Online Store http://www.db-r.com/sell/store/ SAX-100.4B A-Stock - $279.00 was $310.00 SAX-100.4B B-Stock - $243.00 was $270.00 SAX-100.4C A-Stock - $288.00 was $320.00 SAX-100.4C B-Stock - $252.00 was $280.00 SAX-100.4D A-Stock - $292.50 was $325.00

Building a new box for my 15" nightshade. Going to be running (3) 4" external aeros and was thinking about ~2-2.5 cu ft before displacement.. Will be testin different port lengths after I get the box built to see what does the best. Any input?