Sundown Audio

Anybody know where they sell the sundown saz and z series woofers?Didnt see them on her.

Went to my first show with the new SAZ2000 and i broke my record last night!! My old record was a 150.3 at 47hz just by changing out my SAZ1500 to a SAZ2000 i picked up .9 so my new score was a 151.2!!! Not bad for one 18 and 2000w!! The 2000 is a little beast just like the 1500!

I am just checking if you got my PM, I have seen you on, but not sure if you just missed it or are ignoring me. BTW, I dont think you are ignoring me!

What kind of current draws can I expect from the 1500D and the 100.2? I see that the combined fuse rating is 220 amps, but I assume this is under extreme situations. I have been considering incorporating both in my new system, but I only have a 130 amp alt. I really don't want to replace it if I can get away with it. The 1500D would be powering a Q 15 more than likely. Does anybody have any experience running this sub/amp combo? How about the same sub with a 1000D?

Just re-built the avalanche again here are the pics. Donor Midgate The gear 2 dual2 Nightshades and 2 SAZ1500s (one is not mine but friend needed money to fix his car so he kinda pawned it to me for the time being) New wires and relay and connectors New Alt Ohio Generator... need to put this in sometime this week All tore out and opened up Box 7.1 cuft after displacement tuned to 33hz with around 110sq in of port Cut out Midgate Filled and fitted Marking openings Wanted to see it Working on the midgate Planing the amp rack Finished amp Rack Finished install well kinda Sounds good and gets loud dont have any new numbers yet.... I hate the way the vinyl turn…

Regular MSRP $349. Special price $225 until end of March! You can order from your favorite dealer OR Paypal me directly at [email protected] Rated power output ----RMS power, 4 ohm stereo 50W x 4CH ----RMS power, 2 ohm stereo 80W x 4CH ----RMS power, 4 ohm bridged 160W x 2CH Signal to Noise Ratio >90dB Low pass frequency crossover 50Hz~500Hz (CH1&2) 50Hz~5KHz (CH3&4) High Pass Crossover 50Hz~5KHz (CH1&2) 50Hz~500Hz (CH3&4) Variable Subsonic Filter 10Hz to 500Hz Bass Boost 0~18dB Variable Bass-Boost Frequency Control 35Hz to 120Hz Frequency Response 10Hz ~ 40KHz (+/-1dB) THD@RMS Watts <0.1% Channel Separation 75dB Fuse Rating…

To start off, i have 3 sa 12's, they were on a saz 2k, and i had them in a 5.5 cube box 2 6" aeros, tuned to 35hz, Well that wasn't cutting it for me for the low's, So i had to go back to slot ports, i made a box to recommended size, 5.25 cubes for 3 sa 12's, tuned to 31 hz with 81.25 port area. It sounded great, i loved it, But thought the subs needed more power, so i got my saz 3500 back. Put it in, and the sound changed a lot. It is louder, but doesn't sound as clean now and not as aggressive on some songs it did with the saz 2k. It almost sounds like it lost its "clean, accurate" sound, if that makes any sense. What would cause that? the box being to big now becuase i…

Mike Bruno is going to be re-building the QC failed E8 drivers with all new parts for $60 + shipping : http://www.caraudio.com/forum/showthread.php?t=340607 Get them while they last... when the E8s come back into stock the pricing will not be as low as the original pre-sale.

Merry Christmas everyone

Will there be a future for these or coaxials?

Just curious I want to do a small sealed multiple sub setup using either 4 10s or 8s. I have an sae 1000 for amp. How much cone area does each 8 have?

hi guys, im using this calculator http://www.caraudio911.com/tutorials/GainSet/voltage.htm to get my gains all set up on my truck, and im getting different numbers. i have 2 sundown saz1500-ds strapped, and 2 d2 fi audio BTL 18s in my s10 can someone help me out on getting these gains where they should be? also i metered it the other day just setting the gain by ear and it did a 146.8 legal. im getting 2 more sundowns down the road, i want to be in the 150 club! thanks for your help in advanced,

Where should i set my ssf filter to on my saz-1500d? Using it to push a AQ hdc in a 3.5 cube box tuned to 38.

Finally cleared out most of the used item inventory I had accumulated... so I am ready to accept some more trade-ins. For now trade-ins will only be towards pre-orders of the SAZ-3500D. Contact me w/ trade-in quote requests.

Kit I am planning on buying: http://www.knukonceptz.com/productDetail.cfm?prodID=KFX-PK0 What fuse size shall i need to buy?

So while my car was in the shop for near a month I made a new enclosure. I also made a big math error on the width. Meh we are all human, so instead of just junking it, I decided to recycle it and make a newer box with a 6" aero port. Here is what the box started out as. And here are some of the steps in recycling it to a new enclosure. And here it is prior to being loaded in the car. And here it is in the hatch. The low bass response is much greater with this box. Here is a quick video I did in the driveway, I may do more just gotta find a spot where I don't piss off all the neighbors.

I was planing to build a box that's about 1.50 cubic feet tuned to 36hz that's all I have room for. But I don't know which sub I should get Sa-12 Sa-10 E12v2. My amp should do around 750rms clean. This is for a ext cab truck. Any help would be greatly appreciated.

ik some of you nightshade guys out there have had to do a recone, so instead of blowing up jacobs email, i figured i would ask you. what did u use for shims when you did your recone? also, what kind of glue do u recommend? i have read that i can just use some 15 minute epoxy, the stuff that self mixes. or should i use ca glue? thanx for the help.

Jacob, any chance of us seeing Sundown home audio amps in the future? I know you make some great bang for the buck car audio amps and I'd love to see that carried over to the home audio side of things.

I am undergoing a rebuild, and took everything out of my truck to check on everything. After opening my amp I found this zip tie broken, I don't foresee any problems forming from not having it... but it had to be there for some reason. Will my amp be alright? Thanks!

Hey guys I need some help with identifying what has messed up with my amp and if it can be fixed by db-r and maybe if someone knows if it would be worth fixing.

Does anyone know what the motor width of the sundown 12" sub is? If theres a few 12" lines Im looking for one that is 6.75" in width if not less thanks

* Peak Score 6.5 feet away - 128.2 dB on music http://www.youtube.com/watch?v=PkKPgifYfvA * 25 Hz peak SPL - 140.4 dB http://www.youtube.com/watch?v=K0vYteGwShg * 29 Hz peak SPL - 141.4 dB

Hey everyone, newbie member here. I was told to look into Sundown subwoofers by people that actually know what they're talking about in car audio - they said these things are good stuff. Value priced and high quality, and from what I hear the manufacturer is a real solid guy. My question is, how loud and clear are these things? I need some low end for the Polk Momo system I have in my Buick LeSabre, and after shopping around speaker brands I decided this was the way to go. But I don't want anything obnoxious, and I don't want anything that is going to require a huge box and big, conspicious amp. My big thing is keeping a clean, stock(ish) look with this system. That …

I have a 18 inch btl on a hifonics 2400 right now but I want to get a saz3500 for 2 15 btl later on but if I get the saz3500 now and put it on the 18 btl wired at 2ohms will the sub be ok?