Sundown Audio

Ok, so I just got a new 3000d and a 100.4. My HU only had front/rear, no sub pre-amp output. Question is, if I wire the front/rear to the 100.4, if i Use the channel 1/2 output to the 3000d, will I lose my ability to use the hp/lp settings on 1 and 2 or if I do use the hp/lp will it still send a full signal through the 1/2 output? Sorry if I am not being very clear.. front / rear from head unit into 1/2 and 3/4 of the 100.4 1/2 output to 1 on 3000d will using filter controls on 100.4 impact frequency output on 1/2 output channels?

Thanks Jacob for all the help. http://www.titantalk.com/forums/titan-visu...eview-pics.html

Re-Wrapped the amps

Since we tore up the Nightshade proto I decided to have some fun showing off how strong the cone is. I cut the surround off so it would sit flat on the ground and had Justin (local sales rep) stand on the back of the voice coil: Just sits at around 350 pounds Neither the cone or the triple joint glue failed and he bounced up and down a bit while he was on there.

Just did a 157.2 w/ 1 3000d and 8 SI bm 10s 1987 VW golf think the concrete may have helped a lil bit

alright, can i set my remote gain to where full remote gain is peak for me. by setting the amp gain low, and having the remote gain hi will that mess the amp up or send a clipped signel i know with the hifonics you can not use the remote gain as a volume knob for the amp, but the hifonics remote gain for the goliath is a input adjuster, so it raises and lower the input signel, i wanna make sure my sundown can dothe job or not also jacob i got no sundown swag with my amp.... can i get a sticker or somthing:D and a flyer,

I'm gearing up for the impending install in my SC400. I just ordered a 180a High Output alternator that should be here in a week or so. My tenative plan is to run 2 12" Fi Q's (D1 Ohm) on a SAZ-1500D. These will be running along side a JL450/4 for Mids/Highs. Am I going to be okay? Ohiogen, who is selling me the alternator, suggested I throw a Red Top in the back in addition to all of this but I don't want to if I don't have to, as it's just added weight and more money on top of the ~$550 alternator that I didn't want to have to buy in the first place.... It's a LSQ Install and I don't plan on blaring them in a parking lot with the key off or anything irresponsible. …

im adding another 1500 d to my setup and was wondering if i should run more 0gage wire to the back.ive got a 200 amp alt. with a yellow top up front and two batts. in the back.voltage is fine now.lowest at around 13.6 at full volume.ive upgraded my power wire from my alt. to battery and was wondering if i should run a wire from alt. to fuse by amps or add any wire or what to do to get maximum wattage.im running them at 1ohm each and will strap them later one.thanks for ur help guys.

topic says it all. i have a 3000 watt sundown, how mnay runs of 0 gauge should i make, i have one run now. ill run up to 3 runs of need be i have 3 yellow tops and 2 bl 15's

I am wanting to use 2 of these for mid-bass and when I say mid bass i mean 80hz to about 350hz or so what type of enclosure should a try sealed or ported? Thanks, Brock

I like them too much. What do I do. Looking at them isn't helping. I need a show to go too.

Hey everyone, newbie member here. I was told to look into Sundown subwoofers by people that actually know what they're talking about in car audio - they said these things are good stuff. Value priced and high quality, and from what I hear the manufacturer is a real solid guy. My question is, how loud and clear are these things? I need some low end for the Polk Momo system I have in my Buick LeSabre, and after shopping around speaker brands I decided this was the way to go. But I don't want anything obnoxious, and I don't want anything that is going to require a huge box and big, conspicious amp. My big thing is keeping a clean, stock(ish) look with this system. That …

I have no direct Sundown experience, I have read a lot of good things and I'm here to see what they have for my application. I have been researching amps for my newest upgrade from 10s to 12s and I wanted to get some suggestions. I have two 12" Cadence SE Solo Beast DR subs dual 2 ohm vc, 600 wrms / 1200 peak per sub. I would like to be at about 600@4ohms and 1200@2ohms if possible so that if I choose to I can run only one sub at a full 600wrms and potentially upgrade subs in the future. Sure I'd like to say that SQ is all I want but, not in the trunk, SPL is what a sub if for IMO. I would like to compare actual numbers, for example, I've considered only 13.6-13.8 volts …

All I can say is wow. No exclamation points. No Caps. They would not do it justice. I have no numbers regarding SPL as am not sure where I would go nearby. I have not swapped out the interior speakers yet but did hook all of the factory speakers to a RF 500a2. I ran a positive and negative cable run of 1/0 Knuconceptz Kolossus cable. As temp power I ran two 4 gauge cables to the positive of the amp and a 1/0 ground. Alpine cda 9884 cd receiver and the Alpine RUX-C701/PXA-H701 controller processor combo. The sub is in a ported enclosure kinda on the large side. 3.6 cubic feet tuned to between 35-40 hertz. Not quite sure as I need to do a little more to finish the box and w…

Just swapped out my US Amps for some Sundown Audio amps. Sad to see the ol' faithful US Amps go, this was VERY hard to do. I must be a responsible sundown dealer and use the stuff that I sell. I did consider slapping a sundown sticker on the US Amp heatsinks. Old install I still have an Fi Q12 and the Sundown SAZ-1500D is my first ever class D amp. I metered at 140.5 db. Pretty damned good if you ask me for the bass eating BMW trunk. A 2.3db gain since I was metered using the sub brand new with a super stiff suspension. Measured by a termlab in the pass side kick panel. Peak freq was 47hz. The reading might be a little higher since I was inside. Electrical: Stock…

Well, my TL finally came back so put the truck on the meter... my head hurts even with ear plugs AND hearing protective head phones on. First go @ the TL after finding the peak of 48 hz: Legal mic position too: Take a look at my collection of Powermaster D3100s, seven at this time: Used to power four SAZ-3000Ds: Dual Powermaster alternators for the win: While taking that last pic I realized that I forgot to tighten the ground on the top alternator... so I did so and run the truck again: ---- Not too bad! Now... it's time to get tweaking

Got a new car today... been wanting one for a while so pulled the trigger. Picked up a 2006 VW GTI 2.0T today Okay, so it's not NEW per-se... but it does look new, and it's new to me! It's time that I went back to a hatch-back vehicle to make me really happy again Pics soon! Once I get settled into the new Sundown warehouse in the coming weeks I'll start on the system.

4 - 15" Soundstream T4 subs enclosure 15.75cf after displacement @ 36Hz amps:2x Sundown Audio 1500d / Strapped - Master & Slave peek note 46Hz 152.7 @ 2ohm 154.1 @ 0.7ohm Subs facing up / Port facing up along the back window line pics too come later

I'm going to be replacing my HiFonics BXi1606 with one of these amps...I currently have 0/1 guage running from the battery to a fused distro block that has (4) 4ga outputs...the length of the wire running from the fused distro block to the amp is about 12 inches...would it be okay to run 12 inches of 4ga to the power input of this amp?

im sure a few others are still wondering if u have any dates yet on when they could possibly be here and cleared customs? feb 2nd there is a comp in OH id love to go to if the amps are in by then. thx for the update.

Thought I would try a few burps today Legal scores right now are 153.6 on 43hz 144 on 25hz still taken it easy on the volume knob a little I will keep updating in the future

http://www.sundownaudio.com/NS_Presale/ Follow the above link to place your pre-order. This pre-sale will be open until JANUARY 31st of 2008. Subs are expected in February of 2008, but delays may occur. For your patience you will get this great introductory pricing! 12" Nightshade D1 or D2 -- $350 each 15" Nightshade D1 or D2 -- $390 each MSRP on the 12" model is $549 MSRP on the 15" model is $599 So, rest assured, prices this low will not be seen again! These prices are shipped in the continental 48 states, contact me for shipping elsewhere. More information and photos available here: http://www.soundsolutionsaudio.com/forum/i...showtopic=12907 SPL Testing thanks to Chad…

Just a heads up... I will be gone for about 5 days, January 5 - 10, for the CES show this year. Sundown Audio will be closed for that time... if it is an emergency I may be able to have someone ship an item during that time -- but normal orders will not go anywhere until I get back from CES.

The camera didn't pick up the sound very well. Mic was placed on the dash on the passenger side. This was taken with an RTA but mine reads .1 lower than the local TL. So I believe this to be accurate. Peaked at 53Hz. Box is tuned at 40Hz. HzznT2SlpUQ