Amplifiers / Head Units / Processors / Electrical

I have a JVC KW-NX7000. I have had it for years and love it. I recently got a Sony Xperia Ion cell phone. My goal is to get things like Netflix on my HU screen for passengers to watch netflix or browse youtube videos on my lunchbreak, etc. The phone has a mini-hdmi output. The HU has an open RCA( audio/video) auxiliary input. So far I can't find a cable that converts it. What is a good solution?

I have two sundown Sa-12s on a saz-1500d v.3 and a stock alt and battery. I'm probably in my car for an hour a day and i don't always have it turned up. Someone told me i can wire it at 1 ohm but to set the gain down. I have the big three so would this even be safe and if so what would i set the gain too?

Planning a build in a 2012 hyundai sonata with the infinity premium system while retaining the stock unit Here's what we have so far Hybrid audio clarus jl hd 600/4 + 750/1 2 jbl gto 12's(IB) No processing as of yet since the head unit schematic is very tricky. Now, from the information I've gathered The stock head unit has a digital out(spdif) that goes to the factory amp. Usually, you'd go straight from head unit to processor, but, if you bypass the factory jbl amp, you lose bluetooth, xm, & am/fm radio. I'm about 90% sure the speakers crossed inside the amp, so I'm lost on what to do here. Tapping after the amp seems like the only option, but I can't seem to f…

So I've been pondering the idea for a while, but now I've started to putting it in real sense. I would like to take all my audio/video source into one media source. Now, I'm aware of people placing "Carputer"s into their vehicle, I guess in a sense, this is what I would like to do, but not 100%. I would still like to keep a 7" DVD unit as the headunit and the brains of my vehicle. Currently, I have the Pioneer 4300DVD, but I also have my eye on the Clarion NX702. Either system supports many ways to go about extending its media source. So currently, I've been using my ipod for the most of my music, and music videos. Then I would use the the cd/dvd slot for watching movies…

Gents, Just curious if I can run my Xcon D2s at 0.5 ohms and be good, or should I just run them at 2 ohms? Electrical consists of 3 XS Power D3400s ( 1 as a front batt, 2 in the rear). I ran all zero for the Big 3, and currently have a HO alt of 250a from Excessive Amperage in the works. Just wondering how I should wire the subs on these amps. Any input is appreciated. Also this is a daily driver, if that means much. Thanks.

So i purchased a stetsom 7KD and I am curious what the external fuse rating is. i looked up the manual online but it only has info for the two ohm version. The one i purchased is the one ohm 12 volt version. Also when i install this amp I will add another battery or two to what i have.I have noticed that a lot of setups have unfused connections on their terminals. As of now i have two batteries with two fuses 12 inches from each terminal. so if i install a third would i need another two fuses or would that only be necessary if they were a certain distance apart? And of course when i do the install i will do another positive run and dual input terminals. Thanks

I know that the older amps they made were amazing but I was wondering if any has tried their new amps and if they are high quality or not. Input would be much appreciated since I looking to purchase a new amp. Thanks in advance Sincerely, Matthew

is knukonceptz kolossus fleks the best 0 gauge wiring kit out there? seems like a great deal. just got my elite audio kit in from sonic electronix today and not pleased...definitely sending back for some store credit. setting up a hifonics brutus brz2400 running an 18in Fi bl btw. also looking at an audio technix big 3 upgrade kit. reason i'm not just buying the wire and terminals etc myself is because i dont think im experienced enough or have the proper equipment to be setting up a high quality wiring upgrade. here's the link to the audio technix. http://www.ebay.com/itm/Audio-Technix-1-0-GA-Gauge-OFC-Silver-Tinned-Wire-Big-3-Wiring-Upgrade-Kit-5-/110986503556?vxp=mtr&…

I had a sundown saz 2500d shipped to be and I'm positive it was dropped during shipping and the speaker wire input busted off. I was wondering how i could go about getting that fixed and what the cost would be. or if I can just order a new one. The metal that connects internally is busted off. I'm not positive if its covered under warranty or not. I emailed sundown and haven't heard anything back from the yet. Any help would be greatly appreciated.

Would mounting my amp on the same side I mount my woofers cause any problems? I mean that would be the strongest part of the box considering its a double baffle? There's enough space to fit it there so I don't see how it would be a problem but figured I'd post to get input, any possible side affects?

anyone here heard of nvx? how do their amps rank up against the rest? interested to hear your opinions and experiences.

I'm still waiting for the GCON 10-D2 to actually arrive, but figured I'd take the time to look for a amp to power this beast now. It will be in a sealed box, in a saturn ion 2003. Looking to present a 1ohm load at amplifier, since I'm assuming that power at 4ohms is asking too much for my budget. No HO alt, or big 3 done yet, assuming it won't be needed yet though. I was mostly wondering if I'd need to feed it the full 750w, or if I could get by with less, near the 500w level? Just wondering as my budget is a bit tight currently, and I was hoping to grab the amp for under $150. Given what I've listed, would any of these amps work well, or are there others I should be cons…

So I've had my BC2000D for about two weeks. I've only had it running on 4 ohms for 3-4 days and then 2 ohms for the other two weeks or so ive had it. It's been playing mint and today i was just driving around, had my music playing at about 10/62 for half an hour and then i decided to turn it up a little bit. I had it around 20/62 and then my subs just cut out. I went to look at the amp cause its in the back seat and they go back on, they went back off again and then just stopped coming on at all. No protection light and they still have power. I was even playing them earlier this day for almost an hour at near full tilt. I've checked everything fifteen times, the ground i…

I recently sold my amp, m3a, looking for a new amp under $1000 and wanting brand new. The amps I am considering are a M3b and SAZ3500D V.2 but not sure why I would pick one over the other. From comparing the older models it seems the saz3500d v.1 produced more watts than the M3A so is the M3b comparable to the SAZ3500v.2? This amp will be powering a BTL N2 and will be wired down for .5 ohm on a 12volt system. Need some advise

I am in need of the wiring diagram for the inputs of the JBL amps for a 2012 Toyota FJ. I know the voltage should be well below 6volts and want to convert them to a rca plug to install and after market system while still using all the factory headunti features. This is for a friend and I do not have the FJ handy to look at things. I am preplanning and any help would be awesome!

ok so as some of you know dani picked up a new car, a maxima with the bose system in it , for now i would like to get a LOC unit put it on the output of the bose sub and run an amp off of it of course, i was looking at LOC units, and i have used some high end ones, and i have used some scoshe ones from walmart but , they have alll been adjustable, the stinger one im looking at now does not... im not sure that it will matter, the boes sub is very low power.. i guess its only getting 10 watts or so... its very low power.. has any one used this LOC before? http://www.walmart.com/ip/Stinger-SGN11-12W-Fixed-Line-Output-Converter/21647873?findingMethod=rr and also if an…

I just bought a sundown saz 2500d...I was wondering which battery should i buy. i'm looking at a yellow top or a XS Power D2400. I don't have money to buy 2 at this time but i do plan on buying another one of which ever i buy to put in the back. Thanks guys

So I hooked back up my amplifier today and when I turned the headunit on and played some music I realized that no bass was coming from my subwoofer and my amp was in protect mode. I also noticed that my lights would flicker and dim and why voltage dropped to like 12 volts. Any suggestions to what the problem may be?

So I hooked back up my amplifier today and when I turned the headunit on and played some music I realized that no bass was coming from my subwoofer and my amp was in protect mode. I also noticed that my lights would flicker and dim and why voltage dropped to like 12 volts. Any suggestions to what the problem may be?

Amplifier: Rockford Fosgate T-1000bd Recently whenever I turn on my amplifier, regardless of the vehicle running or any input signal from he head unit, just subwoofer on solely, my subwoofer proceeds to violently shit itself. The noise is absolutely terrible. It's just a one pitch note (pitch varies) and is always extremely loud. This has actually been going on for a while. The noise will happen very sporadically and for different lengths of time. I can go a week without the amplifier doing this or I can go one solid month with the noise every time I turn on the amp, no break. It will also go away for months at a time and then come back with a vengeance. I've figured out…

which would you suggest 2 x american bass vfl 450.1 or 2 x audioque AQ2200 or 1 x audioque AQ3500

is there a control knob out that alows 2 amps to run off 1 knob? are they better than the factory knobs?

Hello all! In today's day and age many vehicles have controls on the steering wheel for controlling functions and features of your factory sound system. Many are discouraged from moving to an aftermarket head unit for the sole reason that they would then lose these controls. Well fear no more! This video will show you my experience with the Axxess ASWC - Steering Wheel Control Interface. I found this interface to be extremely easy to use, easy to install, and easy to program. Following the steps outlined within the vehicle will have you well on your way to controlling an aftermarket head unit with your factory steering wheel controls. I hope you enjoy!

Im running 2 12 inch pioneer subs (Ts-w3002d4). With an 3000 watt hifonics zeus amp (zrx3000.1d). My question is what to tune the ssf and lpf to? I play mostly rap music.

I got a new highs amp from a friend of mine! Epic ass Audiosystems X-Ion 70.6 Plus!!!! Two fans on this side and two side on the other. A little fuzzy, but you get the idea.