Home Audio

Hi Everyone. It has been a while since I've posted here... You may (or may not) remember my build log (start on page 5ish) The old Mercedes has reached a point where I need to sell it. It's sad after all of the work I've done, but it's getting too expensive to maintain. I spent a lot of money on the audio gear in that car, and I'm sure I won't get anything near its value when I sell it. So my current plan is to remove the audio gear and replace it with inexpensive stuff. I don't have a car to transplant the gear into, so I was thinking that maybe I could make a nice little stereo for my woodshop using my 3 way front speakers, my sub in a new sealed enclosure, and my …

Found a Technics SL-210 in the attic at the folks house, as well as a bunch of old records Going to get a replacement belt from http://www.turntablebasics.com/belts/technics.html Also needs a needle/cartridge. JimJ, where can I get the Shure cartridge that you mentioned? or what are some good budget minded cartridges? Would love to get this thing running again. Will hopefully sound great when I get some BIB's up, built, and running

Just finished these for my cousin. They are Murphyblaster Usher 2-ways on top and Tang Band 8" on the bottom. http://murphyblaster.com/content.php?f=usher2way.html Cabinets are built similar to my NCMS Rhythms. 2.25" fronts, 1.5" on other sides, internally braced. Drivers flush mounted. The top half of the inside of the cabinet is coated with a mix of 1/2 premix dry wall compound and 1/2 tacky glue. Cabinets are more than "dead". Outside is covered in black ash laminate. The front baffle is spaced 1/8" to allow painting with a good end for the laminate. Also looks cool if you know much about cabinets, because you can tell how thick the fronts are. . . Here is the …

Does anyboby know how to get the best bass outta 2 12 alpine type r with a audiobaun 4000watt amp?

Hey Guys. I bought a Klipsch SW-450 sub for my house. I am having issues with it wanting to shake down the entire side of the house it's on, rather than provide clean crisp bass. There is lots of interior walls and small rooms near the subwoofer (laundrey, halfbath) It's located in a somewhat small foot printed nook but has lots of headspace. main floor so basement is underneath but the back wall that the port fires into is an exterior wall. Is a downfiring sub rear port a bad idea in this case? later tonight I'm going to try and fit it in an identical nook on the otherside of the living room that has two exterior walls supporting it. I'm hoping the rigidity …

I will be using car audio amps in my garage. No more than a 40a draw. Will this type of power supply work for what I will be using it for? I do not want a noisy power supply introducing distortion. Before it is mentioned I do not want to use a regular home audio amp.

I have a Pioneer RX-560 home reciever, and speakers. Has MTX Thunder 3000 subs in it, thats it. right side is gone on the unit, only the left works. I was playing tones and it pops when I start stop the tones and a high pitch ringin out of the mids. I just use this thing to play music out of my computer, and I'm using 3.5mm to rca ran under my baseboard to the reciever and it is hooked into the aux. I'll have a video..

Hello, Being a cautious guy, I would like to buy a home alarm for my appartment. Which brand would you recommend? What features should I be looking at? Thanks a lot for your help guyz, Kelvin

Hey guys, I'm trying to make my first h/t setup. I really need two seperate setups, one to please the wife, and a second for me. I've been into car audio for years, but until recently I was only home for a few hours to sleep, so the car was more important than the house. I'll give you a run down of my expectations and limitations, as well as what I already have/will have/have planned. Expectations: I really want something that's going to sound good, get the full range very well, and not break the bank. I'll probably have to take my time to get everything I want right, but I need to know what to look for. Limitations: My wife. She wants a decent sounding system that'll be…

thought itd be cool to see why some ppl got into audio... for me it was my pops heres half of his collection hes been working on

I have a Home Theatre in a box (I know...but it was cheap) and I am installing new speakers, including an active Subwoofer. The Subwoofer output from the AV receiver is two-wire (Pos and neg) but the new Subwoofer has a single RCA jack input. Someone suggested using an LLC, but I have no experience in this area.

So I have looked around in the internet and found out that you can install car audio stuff with a power supply. My brother fixes computers so i have plenty of those I have a pioneer head unit. and 1 12 inch sub and was wondering if i can connect those to my computer. Along with an amp to power the sub.

so i finally hooked up my new yamaha 661 with my new behringer ep 2500. just used my sub out to an rac to an rca.xlr adapter. just temporarily hooked it up to my ported kicker til i decide what ht set-up i want. now here's my problem. there is almost no output from my sub, with much more power then my speakers i can't even hear it because when i turn it up my new ep2500 almost instantly goes into clipped and kills the signal. any ideas? i'm such a newb to ht it hurts

Has anyone had any experience building transmission line enclosures for a 12" SSD. Saw a post on another forum where this person used a Fi SE, 12", to build one and everything I read about these cabinets talks about how accurate and loud they can be. Only downside is they are HUGE and heavy, but in comparison to regular sealed and ported enclosures they are superior, best match for any driver, superior SQ, and the most output. Also, this one was tuned to 25hz and would reputedly play notes an octave below that no problem. Sounds like it may be a good design for a combination music/HT enclosure. Any thoughts about these claims and or experience would be appreciated. satwil…

Hi guys, let me start by saying this is my first venture into home subwoofers. I have a very old('97) Orion 2NT 15". It has been sitting in a cabinet in the garage so long I forgot it was in there until recently. I want to try it out in the theater room just to see what it would sound like. The spec sheet recommends 2.7 cu.ft. for a ported box. Should I build the same size box for home use? I have a 500watt plate amp that I will be using.

What are some good Home theater Recievers? I am looking to start piecing my HT setup and would like to start with a good Reciever that puts out decent power that doesn't hurt the bank... Im looking at either a 5.1 or 7.1 looking to stay under 400 bucks..

Well my goal is to complete a 2.1 channel system for home theater/audio. I currently just finished my build for my Fi Q18. I would post pics if I knew how to do it. But past the point. My next goal is to get rid of my Sony A/V receiver and replace it with quality audio components. And I think I have it down, but I feel like I'm missing something. I need an experts overview. I want an Equalizer, and I guess the ones I have been looking at have a built in crossover in them. How convenient this is the Equalizer/Crossover that I've been looking at http://www.partsexpress.com/pe/pshowdetl.c...FTOKEN=50274444 Then I wanted to use one of these amps (haven't decided yet, I will …

bash 300 go to web to look at it http://www.parts-express.com/images/item_s...d/300-750_s.jpg do u think it hits hard and low java script:add_smilie("","smid_27") with memphis pr 12" in custom box 2.50cb ft http://www.sonicelectronix.com/item_10315_...+15-PR12S4.html

Right now I have an MJ18-M in 11 cubes net tuned to 20hz with about 650 watts. I was wondering if I would get more output with an 18" Nightshade at the low end in the same enclosure? I listen to music about 15% and watch movies and play games 85%. I have a behringer EP1500 watt amp. Is it worth switching or not? I can get a trade for the nightshade is why I am asking. WinSD shows about the same spl.

Ok, I need some help planning out a sound system for my small den. The room is exactly 10

i scraped the spherical speaker idea and that means i need a large format tweeter what i have now is a pair of ca18rnx's and a pair of cheap-arse tweeters. i'm looking to upgrade the tweeters and i need some advice since i don't know what to choose. budget : $100 for the pair. i'm just looking for something laid back and not harsh. EDIT : budget is $150 and the IB question. we just finished building a garage and it's adjacent (sp?) to one of the walls in my room. that means i could attempt an IB subwoofer. only trouble is the garage isn't insulated and there is quite a temperature diffrence during winter : -5*C in the garage and about 20*C in the room. would this diffre…

Okay, I have a question. I really don't know how to word this, but I think you guys will understand. Okay, so I saw the thread a couple weeks ago (I think it was JimJ) and he was talking about these really big speakers his friend ordered. There are pictures of it in a garage. He then said it gets painfullly loud with only 7watts....That's whats confusing me. There is something I'm obviously missing here. How does it get so loud with only 7watts? Thanks

Basically being at college sucks because i cant use my car and enjoy my car audio needs, so i am looking to get into some home audio. I want something i can build myself. Nothing to fancy yet, just a nice beginning build with great sound quality and a reasonable price for all materials, drivers, and amp.

I have a pair of Cerwin-Vega RE-30s in great condition. Today, I had the idea of playing the "In the Air Tonight" bass test version on them for the hell of it. Throughout the song, I heard this somewhat loud vibrate/hissing (hard to describe) coming from each cabinet. I figured it was just air coming from the port, but after further inspection, it seems that it is actually air escaping from around the fuse "box." I have never heard this before, probably because I have never played anything very bass heavy with soft-ish mids and highs. I thought that cabinets and boxes are suppose to be pretty air tight, or at least not let this much air out. My question is, why is this ha…

I don't know if there is anything that can be done, but just thought I'd ask. I have two old infinity cabs that are sealed and some random Phillips speakers from a mini Hi-Fi system sitting on top, all power by a Pioneer receiver, nothing special, just gets the job done for my bedroom. I noticed the other day when playing some rap with higher bass (say 50-60hz) that the lows are MUCH louder when I'm standing in the doorway to my room... WTF? Its like my room is an enclosure and the door is the port or something? Any way, is there something that can be done to make it louder inside my room instead of on the way out of my room? Thanks, Mike B.