Subwoofers / Speakers

I tried searching but for some reason cant figure it out I know yall may not know but I found a cheap deal on craigslist and was wondering will a 2013 f150 super crew the 4 door prefab box fit in a 2013 f150 super cab the ext cab under the rear seats any help is appreciated

Picture !

i have rockford fosgate phase one 12 inch subwoofers 8 of them in a 16 cub ft box im trying to get them to hit low and hard they do hit very hard and loud!! but when the songs go to the low bass it drops out they are ported 6 ports 4inch by 3inch deep the ports are all on the front side with the subwoofers thats what rockford gave to me they say that will tunes them to 37hz but it sounds like they are tuned to high and out put around the 50hz and lower drops off and i dont get that lower end that shakes the car and flexs the car just trying to get my point across on what kind bass looking for please help me

Please correct me if I'm wrong. Does polyfil slow down the air in the box and make a sub sound as if it is in a larger box? So say I have a pair of 15s and they require between 1.5 cubes per chamber and 2 cubes per chamber each sealed. Say I put them in 1.5 each, could the appropriate amount of polyfil in each chamber really make them sound as if they are in 2 cubes each?

I bought two brand new dd 3512's I thought they blew but when they got to dd they said that the motors had shifted. Then they asked me if i droped my box or if a had gotten in a car accident. (which i hadnt) they fixed them and they are on there way back I was wondering if this has happened to any one else??? im running 4 subs all 3512's other two where fine.

my subs where working fine befor i remove them i put them all back and i got a horrid noise comeing from the back. its late to night so i really couldent look at them. but it sounds like metal radlling but not exatly do subs make that noise. it all most sounds like there blown but still pound. idk its late got my car all back to geather lets hope all is good and its just something lose right....

I'm looking at getting a new 18" sub right now I'm debating a hdc318 and a fi q 18. I have a zx1500 amp so looking to throw 1500 watts at it. I want a sub that will play low as well as get loud I use to run a pair if 12" re se's that did a 144 legal on tl so I want new set up to beat that any ideas I. What to get? I also have concidered a bl but they aren't in the website yet and I need to order sub by monday.

Picked up a dual behind the seat truck box for $50 for my crewcab f250. its made for 2 10's with (so they say) 5.25 mounting depth and .75 cubes per side. The amp ill be using is a t5002 putting out 900-1000w @ 2ohm bridged. I looking at the SE SR10d2's they have a 5.25 MD and say they work in small enclosures and the ID10v3's with the 5.25 as well. When the box gets here and if I can mod it to fit something deeper maybe 5.75" so the IDQ10v3's or maybe step up to SR12's or the IDQ12v3's might be an option. both say they will work in that small of an enclosure but im looking for real world opinions. (also can always add polyfill, probably will anyways) so basicly How do th…

I can't get a lot of info and no reviews for this pro audio speaker i guess because it's new... I currently have a sundown 100.4 and a set of ID components rated for 100wrms per side. I want to bridge my components to the sundown 100.4 but i'm sure it will kill them due to too much power.. Question is- If i purchase these pyle pro PNDW6 6.5s, where do i look at replacing my current crossover with a new one so i dont burn it up due to too much power. I looked on partsexpress but it looks like u have to finish building them, i'm looking for already built ones.

ok guys i am currently running an active frontstage setup with 2 mli 6.5" and 2 infinity 1" dome tweets. it is decent but when i turn on some hard deep bass they cant keep up with the btl the bass drowns out the music part of the song and not so much the words i am starting to build my next project for 2 18" btls so what i am looking for is some ideas for my current setup and my future setup with 2 BTLS i am runnind a sax-100.4 amp for the current active setup there really is no budget atm money is ok right now i just really want the music and vocals to come in real clean when i want to show off the BTL and full tilt thanks an advance guys. again i apprecheate all your g…

I am wanting to replace my fi Q 15 ported with two 12 port in the cab of a 2000 dodge dakota. Am getting a 1500 and am buying another 15 to go along with the one that i took out of the dakota. Am want to hear from someone who has heard both the re se or sex 12's or the incriminator lethal injection 12's. I have been wanting a pair of either of these subs for a while. I dont really care about pricing and all that, am just wantting to know what are some of the pros and cons of each of these subs from the user's point of view. Stuff like low end, high end, SQ, Loudness, stuff like that. Thanks.

thinking about putting two fifteen inch Bl's or Q's in , but I'm limited for space . I'm working with 17hx40wx28d going to be using 4" flare ports, question is should i keep the box right around 8 cubes or drop the size down a little to around 6 cubes and what should i tune it to 30 or 37 hertz? the car is a 2005 sonata box will be subs back ports back any help or suggestions would be appreciated.

Anybody know anything about a sundown/T3 hybrid 12", dual 1 ohm? I'm lookin into them but haven't heard anything about them. Supposedly 2500 rms? Would they go good with a saz2500d and a 4.75 cube box tuned to 36hz?

Im upgrading to 1200 watts soon, so ill either be getting a new single fi bl or q or maybe a second ssd. If i get the second ssd, the new box will obviously fill pretty much my whole trunk. I have a ski hatch that allows air to flow freely from the cabin back to the trunk, and my current setup is noticeably louder with the port open (sub back, port back setup). If i build this new box for 2 12s, would it be smarter to leave some room around the edges of the box and leave some room between the back seats/ski port and the box to continue to allow air to flow into the cabin or should i take advantage of every possible inch of trunk space and forget the whole ski port thin…

whats the frequency response of the id horns?

I am interested in using two Flatlyne 15's in an IB install in my Civic sedan. Are the Flatlynes ready to be run IB or do I have to special order them to be set up for this application?

Hi All, Would like some advice from those who have heard them. I have a sealed box that has appx .75 cubes after displacement. It has to be sealed and I prefer sealed anyhow. I put two Sundown SA-10's in there (yes I know they are better ported but my son has sa-12's sealed and sound great) but they just aren't doing it. Maybe some of it is because I'm used to my son's 12's but it seems like the 10's aren't hitting all the frequencies. They sound amazing with certain songs but not so great with others. I listen to mainly rock and metal btw. They are running off an AQ2200d and are going under the back seat of a 2012 Dodge Ram running at 1ohm. Anyhow, I would like to …

Any one a supllier of sundown sub in Philippines..

Just trying to see how you guys think 3 10"xcons would do in a 4th order that is 2.2 sealed and 4.5 ported before displacements. I know a lot of thing matter but The reason I'm asking is because that's the box I have my 15" zcon in . Its ported though the rear deck with removable port ( could make any tuning that would be good for the xcons) but not really wanting to do a new box right now cause its built in the car and I'm wanting to get louder. Loudest so far has been 145.6 and cant seem to get louder. .... would be at least doing rms. I have ho alt. 2 runs of 0 .close to 300ah of batts. lots of deadener .. let me know any questions you may have. Thanks

What's peoples opinions on the HCCA's? I seen a website that sell's the 10's for $200 a pop I was thinking like 5 of those off a sundown 3500 would slap. (I'm debating on what to get for an SUV I don't even have yet lol)

misposting sorry look at other post thank you

Getting one of these as a temporary sub to try out. Trying to figure out how they are, what to do for an enclosure, and how much power i can safely give it. i have probably about 1200 on tap, the last owner said he was running it @ 2 ohms on an SAE1000 and it'll take more. I was thinking of doing something like 2.3 cubes net w/ like 60 square inches of port, tuned to about 35

my friend wants to know what will be the best option to go with he said he wants it to be loud and low i told him go sealed but i dont know what else to tell him we have the same car 89 caprice its down to three sealed or two ported 15's and i also know that a lot of people not a big fan of sealed boxes so can i have a options and opinions please

I will be running 4000 watts when my other amp comes in and i have narrowed my subwoofer down to 3 choices. If youve had experience with these subs, please give opinions on which one would be good for me. It will be played daily with occasional spl competition use. The choices are FI fully loaded BTL 15, Atomic Extinction Level Event 15, or DC Sound Lab LVL 4XL 15.

hey guys, i was wanting to install my jl speakers buttt i had a question i know u guys can help me out with. my stock speaker size is 6x8 in front and back. up front, i have the jl 6.5s and im doing tweeters up in the pillar up front. then in back is where my problem begins, the speakers are 6x9s and the hole is for a 6x8 so how much if any will i have to cut out to make them fit?