Leaderboard

Here's all the pictures I have up to now. Constructive criticism is welcome. If you have a snide comment or remark, well, I'm probably not going to respond to that. Here we go.

Here's a few little updates. Here I'm cleaning up the holes drilled into the board for all the wires. Dremmel FTW! Here's a shot of the channels routed into the back of the board. In this area the board will be right up against the panel in the van. To keep things flush the wires will run down the channel to the SAX-100.4 and be held in place by an 1/8" piece of fiber plate. (an old sign from work, thin but very strong) You can also see the beauty panel that will trim and fit the amp board to the panel in the van. Ready for carpet. Carpet applied to the front only for now until the adhesive sets, then I'll slowly work it around the edges.

user was banned for this post