Duran
SSA Regular
-
Joined
-
Last visited
Everything posted by Duran
-
There is smaller than a handful of people who work at Fi, in fact I can only think of 3. The fact of the matter is the polycarbonate plastic is being pushed beyond it's limits, I'm sure a solution is in the works, as this has happened before. -
No, my dick is WAY bigger.
-
The only thing I know is they are 3" coils rated at 750 watts.
-
-
A friend of mine will be there, Thomas O'Brien.
-
They are sent out when finished.
-
See if you can find out where it has come loose
I see no problem with your spider joint; the chips in the magnet are purely cosmetic, they probably happened during shipping. Your dust cap is loose
yes i am. 2.3 cubes and jl recommends 1.5 cubes. it sounds really go though so i aint to worried lol. no smelly coils yet The coil will not fail, the suspension will fail. Watch your excursion; recones from JL are VERY expensive.
Call them, perhaps it isn't sorted yet.
You need to solder the tinsel leads to the terminals, the voice coil leads will already be soldered to the tinsel leads. 5 minute epoxy or spray activated CA glue will be the easiest to use.
Pressurizing your eustacian tubes, I gotcha
Send an email to SSA, '[email protected]' for a basket, they may even be able to just add it to your order. You will need a screwdriver, something to shim the voice coil, a soldering iron with solder, along with clamps, and I think some glue.
The 12"-18" have the exact same motor, the only things that change are the cone, basket, and surround.
The 18" will perform like an 18", in proportional enclosures, an 18" will be more loud and sound better than a 15" on the exact same power.
No, your XCON will forever be an XCON. You can change cone sizes; you would simply bolt on a new basket and install the soft parts. The only way to change the woofer is to change the motor and soft parts.
I'm always watching the forum Thank you Stefan.
Due to how the caps are made, those are brush marks from brushing resin on, as you said you must look very close to see them; the same goes for the small air bubbles. Thank you for the review!
Pattenting is incredibly expensive.
My XCON is in the same enclosure
12"? I can make Carbon Fiber dustcaps if they are
Personally I wouldn't buy any of those for myself, they would not meet my goals. I cannot speak for you because you have yet to state your goals.
It will be marked on the former, if it is not identified it should default to daily.
A real carbon fiber dash would have been much more expensive I'm sure