Duran

A lot of momentum there, they are lucky the enclosure didn't decapitate them.

The SA series really screams ported, but sealed will work.

Check your grounds and power cabled for shorts

The top of the top panel is transparent, it's not doubled on the sides. Bromo is very good with enclosure designs.

You won't have a problem underpowering, it won't like 2 ohms though, at least not forever.

I really liked the murdered out Z...

That's Tirefryr, we have several ladies on here.

I got all excited when I read this, though Jacob was gonna bring back the 3000D, then I saw it was 3 years old, oh well

If she wants to keep to stock the easiest thing to do is get an LOC, they aren't bad if you get a good one and set it up right

Nice looking show

If only that were the case.

Bravox? Bravox? Anywhere?

I feel the SAME way, my rebuild is to commence as soon as temperatures become reasonable again

She was blown to smithereens. How did this happened? They can take tons of power. Andrew Not the new Chinese versions

She was blown to smithereens.

No such thing as too little power, the 1K will do great. I'd go for copper coils

Xmech is a useful figure to know sometimes.

You will have to get in contact with Nick or Scott to get xmech figures, they aren't posted. As far as ports, whatever gets you sufficient cross sectional area will work great.

No problem at all.

High xmax increases wind height of the coil, the BP option is a machined plug that blocks the pole vent, channeling air around the coil. Thermal power handling increases due to the forced cooling, mechanical power handling remains enclosure dependent.

Let's not forget Alan Dante's 1 18" puling 180+ There is a huge difference in installation, because those "guys" with the Tahoe's have more power and cone area than Dante, yet he's more loud, how do you think that happens? It's obvious they don't know what their doing