If i were to use 4 or more sundown 3000's, does the BR out work for daisy chaining multiple amps together, or is it only for strapping 2 amps together?

Its only for strapping two amps together

dont daisy chaining those amps.

so how would i wire up more than two amps without havin to split my rca wires which would lower the voltage from the rca's

so how would i wire up more than two amps without havin to split my rca wires which would lower the voltage from the rca's

Technically you won't lower the voltage - in parallel circuits the voltage is the same.

Have never had any issues splitting them to run two strapped pairs

so how would i wire up more than two amps without havin to split my rca wires which would lower the voltage from the rca's

Technically you won't lower the voltage - in parallel circuits the voltage is the same.

Have never had any issues splitting them to run two strapped pairs

thats wat i had thought before, but i talked about splitin the sub out from the hu to two amps on here before and i was told it would split the voltage. and when i hooked it up like that it did seem to make the sundown amp put out less power so i had to turn up the gain

Edited October 21, 200816 yr by fritosaregood

then grab a line booster.

then grab a line booster.

ive heard using those creates more noise in the signal along with increased voltage. another possibility is a bass reconstructor, it would work for increasing my voltage from 4 to 8, and help with makin music from my zune sound better, but it would get expensive if i needed more than 1.

I read a post on here a few weeks ago about the car that went to the finals with 16 saz 1500s, do you know how the rca's on that could have been wired

Moving.

MaxxLink is your friend. I love mine and its not that expensive.

MaxxLink is your friend. I love mine and its not that expensive.

What is MaxxLink?

MaxxLink is your friend. I love mine and its not that expensive.

What is MaxxLink?

Its a line driver.. more info here:

http://www.maxxsonics.com/hifonics/sigproc_ipod.html

I wouldn't be concerned with a line driver adding noise in your subs.. you'll never hear it.

What is the output voltage from the maxxlink

You might be able to get an audiocontrol overdrive cheaper. Ideally, you'll luck out and get a matrix cheap. 1 pair in and up to 3 pairs out.

The Maxx-Link is a lil more than a line driver. Thats just one of its features. Its technically a strapping module and its output voltage is adjustable.