im fitting my FiQ 15 bp and sundown saz 1000 this sec

its 2.3^3 box sealed, was just wondering a rough guide line to set my LPF, Subsonic, phase at?

listen to rap,

thanks

Don't touch phase. Set LPF half way. Don't touch sub-sonic.

everything is on min, or same as min gain atm?

so leave yes? just set gain

use 50Hz tone, turn gain up slow till satisfied whilst being careful

everything is on min, or same as min gain atm?

so leave yes? just set gain

use 50Hz tone, turn gain up slow till satisfied whilst being careful

yes, do u have a dmm to set the gains correctly?

ssf - 0

phase - 0

lpf - halfway

going to hit bed now, am not successful yet

amp is working all lights remote everything but sub not making any noise and no movement?

any ideas, all seems wired up ok, +amp to +term - to -

going to hit bed now, am not successful yet

amp is working all lights remote everything but sub not making any noise and no movement?

any ideas, all seems wired up ok, +amp to +term - to -

check the head unit settings, and all the connections (amp, battery, head unit and rca's). hopefully its a small trouble shooting problem.

my step dad did check for current running all the way through, amp is powered, and grounded. remote from stereo is working, amp remote lights up, i put it on half for now.

im just trying to see any movement from the sub.

doesn't matter where the gain is im getting nothing?

grrrr this is annoying.

also i feel like i have had the sub to long to do anything even if its broke. its been sat in my room for 7 month whilst i am getting the other peices of my system.

im going to have another look.

please post ideas

thanks

just to check.....

speaker wire...

i have 1 pos to cup to + term on 1 side of sub.

and 1 neg to cup to - term on other side of sub?

sound right ?

bump

ASAP

That doesn't sound right. The Fi has dual coils. You should have one wire from red terminal on one side of sub to the red terminal on the other side of the sub then to positve speaker on the amp. Then wire from black terminal on one side of the sub to the other black terminal on the other side of the sub then to the negative speaker on the amp. If it's a dual 2 then you have a net 1 ohm load. Can you post pic of how you have it wired now?

Make sure your RCA's are in the back of the HU and Amp

that sounds like a plan. i'll try it now thanks so much im so anxious to get it done lol

i literally have the way it looks on 12volt

http://www.the12volt.com/caraudio/woofer_configurations.asp?Q=1&I=22

??

that sounds like a plan. i'll try it now thanks so much im so anxious to get it done lol

i literally have the way it looks on 12volt

http://www.the12volt.com/caraudio/woofer_configurations.asp?Q=1&I=22

??

i bet your missing the jumper wires on the sub that are shown.

you just put the speaker wires from amp.

good luck

yeh i think i did. its now working ))

gunna go set it up better now....

set to about 23/35 on my alpine on 50 hz tone increase bass untill reasonable...

is distorion easily noticed on subs being very low sound

thanks

seems to be working fine had it going most of yesterday

pretty loud im going to get a dmm on it i think it can take more no where near max xmax

super sub am way happy.

thanks