April 22, 201114 yr Author i have the flooring cut out and ready to be anchored-I dare somebody with a Scion tC to make a floor any wider than that!55 5/16" wide! That took a while to get just right.To lazy to do your BUILD! and To LAZY TO START YOUR OWN DAMN THREAD! THREAD JACKER!
April 22, 201114 yr haha, my build log here on SSA is one of the largest on here.I'm just not posting anything in it yet until i get near done.Everything is being posted on another forum though.. u know which one that is.
April 22, 201114 yr Author haha, my build log here on SSA is one of the largest on here.I'm just not posting anything in it yet until i get near done.Everything is being posted on another forum though.. u know which one that is.Yes the one of which we do not speak of LOL
April 23, 201114 yr has the chemical welds held up thus far? anxious to see your progress! lol, did not realize this was your thread mike until i seen it posted..... thought it was our iakhop...my bad.....
April 23, 201114 yr Tell me about it bro! Im better off replacing the engine while im in there lol!oh the irony...
April 23, 201114 yr Author Tell me about it bro! Im better off replacing the engine while im in there lol!oh the irony... :roflmao: :roflmao: who would of thought I was a Prophet!
April 23, 201114 yr my build log here on SSA is one of the largest on here.With the least number of pics too.J/K Bro, well kinda lol :roflmao: :roflmao: who would of thought I was a Prophet!
April 24, 201114 yr Author well I will have some new pics up soon! they will be of a bunch of 0000000000000000's because this thing has drained the BANK! Stupid engine cost me 2 zcons and my amp and a few batteries!
April 24, 201114 yr Author ^ ?!?! was that installed?its not installed yet but It cost a nice chunk is pretty much what im saying! lol FML!
April 24, 201114 yr damn man. that blows. all that could have been but no... its going to an engine... GLW it man.
April 24, 201114 yr I have to get the timing belt and tensioner replaced on my car, not the same as your case, but similar feeling. Good luck man
April 24, 201114 yr I have been in the same position. I had to bounce around to find a place that would actually try and fix it. Luckily that vehicle is out of my hands now. Good luck on everything and you know i am down to come and check it out soon!
April 24, 201114 yr Author Im done with the NUMBER GAME! Im putting in the port plug which will actually be the back wall! Final box will be tuned to 30hz to do major damage to the vehicle not the meter!
April 28, 201114 yr V8 swap by chance?that would have been a sick option. nope, just replacement. side note over, looking good bud. i'll call you tomorrow when i'm done with work/class and drop that stuff off to you
May 1, 201114 yr When life hits you hard it hits you HARD!Aint that the truth. Good luck with the motor swap buddy!
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.