General Audio

So is there any way for me to be able to get my 8ga speaker wire once doubled to fit in my btl terminals? I can't seem to get it to fit in amp or sub terminals, also I have an Audioque 2200d powering my btl which has four wire ports can I combine the two+ and the two- into the+ and- on box or what would be my best bet?...thanks

Name off some high power subs (anywhere above 1000 watts RMS) with a low Fs (below 30 hz) and preferable a 15"

Now for the question . Is it better to run in a daily driver setup 1 or 2 ohms? I there really a difference between the two besides the resistance in the current.

In my town, we have absolutely nobody to consult for car audio...so I am in dire need of some advice. I have about $1000 budget (as posted above). I just put in a pioneer head unit, so that part is taken care of. With the budget, Ide like to replace the 4 stock speakers (all 5 1/4", 2 in the rear roof, 2 in the front door panels). And then I am sacrificing some space in the trunk for a sub box. My dimensions are 20" height, 35" width, 15" bottom depth", 8" top depth. I have no idea on what direction I want to go other than Im thinking 2 12's with the space I have and an amp to match them, but I really want to avoid extra batteries and alternators and so forth (if I can).…

I just put in a new box in my 1999 jeep grand cherokee and I reattached the back battery, In doing so I noticed my voltage is at an average of 12.6 with little bass. My voltage is going crazy and im not sure what is going on. Normally at full tilt on rock, the voltage plays at 12.8, But now its at 12.2...... My Interior lights are now feeling the power drops and dimming everytime a bass note hits.....as before it wasnt doing that......any ideas?? My alternator is working i had it checked today..... Also might i add that with the bass off my voltage goes from 13.6- to 12.8....with no bass...only mids and highs......wtf?!

Well, I finally got the last word about my deployment. I ship out right around New Year. Now that I have a time-line I need to get the Neon in saleable shape. I bit the bullet last night an bought the amp. It's an older Kicker KX550.3 3 channel. Fresh refurb. $149 shipped. Now all I need is the sub. Looking for an inexpensive 12 that will work well in a small sealed enclosure and 200@4 or 400@2 for power. The build will take place over the next 3 weeks before I ship out. More sooner than later. The current trunk install comes out this weekend and the build begins. I'll start a build log in the correct section. Looking for ideas for the sub. Needs to be a 12. …

theres a kinda new song out called Black Mags by: The Cool Kids....i was wondering if there's anybody that wouldn't mind making a video playing this song. ive only heard it on my computer sound system, and it seems like it beats pretty hard and low... i just want to hear what it sounds like in a car wit a nice sound system....anybody want to do it? thanks guys

Hey guys! I drive a Ford Expedition and I pretty much made up my mind on my upgrade. Now I have two Diamond Audio d6 components in the front and two d6 coaxials in the rear powered by Diamond Audio d3 500.4 amp, runing 4 guage power and ground wires to the amp. I currently have two Diamond audio d3 15 inch woofers powered by Mmats 2000.1. I want to replace the subs with four Ascendant Audio Havocs and having two Mmats 3500.1 powering them or should I get two 18's instead with one of the Mmats amps powering them. The box is going to be ported tuned at 32hz. I'm more into sq but I also want to feel the bass in my bones when I need to lol. I listen to a wide range of music. …

I'm looking for low weight, basically. Rigidity isn't a huge concern because my box will only be 1 cube and in an L-shape, so all the corners and small panel sizes should make it pretty stiff regardless. I may also add a second baffle on front to countersink the sub. Birch is getting up over 60 dollars a sheet, though (5' x 5'). MDF weighs twice as much and half the price. Is there anything else readily available at most lumber yards that would do the job for less?

So, I arrive home from work to a package sitting on my back porch. Hmm...that's weird, I don't remember ordering anything. Though I do recognize the name and address of the sender as being one Njccbflo What the heck?? LOL......... A little abusive, aren't we?

I am looking to sell my current setup to upgrade I currently have a Cadence ZRS-8 amplifier (1500 rms @ 1 ohm, 750 @ 2 ohm), and a 12" RD Alpha V.2 in a 2.3 cube box tuned to 33hz. Along with my 6.5" Polk Audio DB615s (slim fit), Infinity Reference 9623i 6x9's, and Pioneer deh-p3900mp H/U. What do you guys think my setup is worth if I can sell it?

im currently at a stand still with my build. i fabbed up a amp rack last night, but it just doesnt look as clean as i was wanting it. if there is anybody that can possibly show me some pictures of their amp racks, it would be greatly appreciated. im looking for more sleek clean finish. (round over edges, plexiglass over amp,,etc) just looking for ideas. forgot to mention, i have 2 soundstream tarantula 1000d going behind each seat in my reg. cab silverado

Drivers side ... enough room for the mid right where the foot rest is, may be enough for the tweet too. Passenger side ... plenty of room for the mid in the area right by that plastic bolt. Paper template baffle in place. Similar to real life size (tweeter would be moved closer to the mid). Drivers side. Drivers side again. Trying to show where the mid could go. Passengers side ... looks like barely enough room if the tweeter was moved up. Closer view of passenger side ... should be ok on this side if I move the tweet closer I guess. Spring project ... fiberglass box for the (Magnum D2) most likely. Should turn out ok. If it turns out that there is too much air…

Hello guys i have recently pulled all the factory crap out of my truck and ordered some things but i have a few problems. I bought a set of Cadence CVLT-35B tweeters along with a pair of Selenium St-200s i also purchased two pair of Alpine SPS-500(i know i could have gotten components just didnt want to) . The amp i have is a Hifonics HFi100.4 and the headunit is a Pioneer AVH-P5200BT. At the time of purchase i didnt know the seleniums needed a bass blocker of some sort so i searched and came across using an active crossover. My question is would i be able to use what i have listed with the addition of a crossover or should i buy a separate amp for the tweeters? The cros…

Ok.. I have a FI BTL 18 and a Rockford Fosgate T30001bd amp. I have all 1/0awg wire big 3 and a kinetik 1400 in the back. So when i first hooked everything up it was SUPER loud.. but for some reason when i like park somewhere and shut it off then go to get in to show someone it is not even close to as loud as it was.. Does anyone have any ideas. My only idea is because i only have a kinetik 1400 in the back so its not enough power? And sometimes when i turn it up it will start pounding and the will start to cut out. I was wondering if anyone else would know what the problem would be.

Hello once again, last time I wrote here I was debating on getting 2 10's, and a amp looking to spend maybe about $500 to $600, then I stopped chasing a dream that was a bit out of my grasps... I've always loved car audio, my friend "Hove" who is a member here who is the one who got me into all this mess lol, has had a system since jr high school. So needless to say, I'd like to introduce myself, and say the last time I spoke here I planned on limiting myself to overstock mass production MTX crap with a box and amp built into it, lol. Some how my buddy "Hove" talked me into getting something else... So heres what i ordered... I ordered: Sundown Audio SAZ-1000D FI BL 15" i…

Brother just bought a new camry Nice car stock system? HORRIBLE. Probably the worst stock system i've heard. I've decided to surprise him with a setup, but im tryin' to do this on a super super strict budget. Here's what im looking at HU - Used pioneer deh p60mp(70 shipped) Speakers - ID ctx65cs $125, Incriminator comps $119, & cadence cwm6kit $65.99. Amp - toss up between 2 us acoustic amps from audioclinic on ebay $140-160 OR a ppi sedona 5 channel $155 Sub - dcon 10 $119, or phoenix gold rsd 10 $50, 3 jbl gto 8s $150 Yay? Nay? Any deals out there that i should look out for?

I am hoping to updrage my chit duralast to a optima yellow top. I was wondering if i can do this with a stock 70 amp alternator? I dont know much about electrical and need an opinion whether this is safe.

Hey guys, Just got my 2 sa-12s installed with my saz 1000d. My light dimming is very minimal at night so i figured i would do the big three before i do anything else... I currently have 4ga wire for my amp ground and amp +. Would it be okay to leave it like that? If its okay to leave it like that, can i do the big 3 in 4ga? or just do it in 0ga. I will never put a larger amp in this car if that helps with anything. saz1000d will be the largest amp it will ever see.

im looking for something you can buy at walmart or something like that for my trunk, to help stop the rattle and help the sound out a little? any suggestions

what are people referring to when they are talking about a horn? it always seems like theyre talking about the enclosure, but what makes a horn a horn? and is that the full name? just "horn"?

Hey I'm in the planning stages of a build for my cousin. She knows absolutely nothing about car audio but I'm slowly changing that. I have a request for you guys though... Show me some Fi X's, DCON's, 187's, anything. I need some good pictures of stuff around that price/power range. I know all of those have stock photos but I wanna see some upside down and in boxes and all that. Thanks in advance.

http://www.phoenixgold.com/images/pdfs/PGCAT11_web.pdf Check out the Ti1600.5.

I'm about to step in and start editing some more music for custom purposes for car audio and want to know what frequency range i should focus on? This project will mainly be focused on older 70s-80s rock that had no bass hardly. I want to bring out frequencies that just didn't audibly exist before. I've done this before a while back and some people have the custom 16 min Pink floyd track i did but now i want to do this... So, what frequency to you is LOWWWWwwww? i can bring it out all the way to 1hz but there comes a point to where it's too low so i need to know how low is too low really. Anyone who listens to these tracks can mainly only benefit from it from a setup whe…