Sundown Audio

These are due in about 4-5 weeks from today. Neo-Pro 8 - 100 watts RMS / 8 ohms * Neo-Pro 10 - 200 watts RMS / 8 ohms * * Assuming proper crossover frequency for your application; typically 80 Hz or so but perhaps higher or lower depending on the power and size of door. Frequency response is good to ~5000 Hz on these -- they are a high Qts design for IB door installations in a car audio environment. To order send a Paypal to me at [email protected] Pre-Order as follows : Eastern USA : States not listed under western USA. Neo-Pro 8 - $80 shipped EACH Neo-Pro 10 - $95 shipped EACH Western USA : ND, SD, NE, KS, OK, TX, NM, CO, WY, MT, ID, UT, AZ, NV, OR, WA, CA Neo-…

I am very curious to hear what you have to say about buying this box - https://www.woofersetc.com/p-7421-sqp15spl-ground-shaker-15-single-ported-high-spl-box.aspx It would be going with a Sundown nightshade. The 4.2 cu ft. seem good and the box looks nice to me. I know building one will be a little cheaper but it probably wont come out as nice and would save me the headache of building one myself. But if you recommended that I just build one myself then that's what ill do. I emailed them asking what the tuning is so if its not around 33hz then obviously wont get. Also its not double baffled so idk if it will be strong enough for 2500 watts. Theirs also this http://cgi.eba…

I recently installed this amp with a pair of HAT Clarus 5.25 and I was wondering if the LPF on channels 3 and 4 are not functioning properly. I'm currently running active and I was attempting to bandpass my mids using the Subsonic and LPF. When I select LPF the mids produce that range I selected, however there is a buzzing sound coming from the mids and they sound slightly distorted. When I select HPF they play just fine. The Subsonic is set to 70HZ and the LPF is set to around 5500HZ. Thank you

WELL NOT REALLY! I just got my new toys in the mail and these sub are bigger than what i expected now all i have to do now is come up with a design...thanks Jacob Saz-3500D Sundown Z v.2 15's THANKS AGAIN JACOB! B.Ellis

Back from SBN so time to start catching up - had a good time !

My Buddy, Kelly, aka (The Rattrodder) finally uploaded the video he took of the Kia demo yesterday at his new shop. Affordable Audio Solutions in Dillon SC. Enjoy. http://www.youtube.com/watch?v=Z3Oyw1g9XHI&feature=feedu

Hey Guys. It has been a while since I posted on here. I finally have both of my Sundown Nightshade 15's and new enclosure in and we did some vids of the Kia in action. As soon as my buddy gets them downloaded, I will post them on here for you guys. All I can say is that everybody was impressed with how this thing hammers on only 4,000 watts. The flex is just crazy and it has no problem at all playing in the 20 hz range. I hope to have them posted by tomorrow sometime.

too start off I'm not bashing any products this was just a direct swap. we started out with this box on a 40.1 @.5 did a 154.9 then we dropped this in and only came up with this voltage drop was from 15.2 on the volt meter down to 13.4 on the 40.1 and from 15.2 down to 12.3 on the 4500 there was a nsb90 under the hood with 6 runs of wire to the back batteries they are 110lb data safes. the 40.1 was giving some crappy wave's on the TL and the sundown hard perfect wave's on every test we are going to do the 4500 on 16 volts next and see what it will do then here is a pic of the wave with the 40.1

well i found a new toy that loves the high notes.in our testing it was able to do a 155 outlaw @ 71hrtz with 1 NS12 and a 40.1 on 12 volt.this new vehicle is stock from head to toe. no damp,no duct tape nothing yet.since i was using a freind of mine equipment.I need to start getting my own again so I want to go with a lighter sub like 2 x sa10's and a [email protected] to start out with since i cant afford what I need. will the sa 10's hold up to some 71 hrt burps until i can afford some bigger subs and more power? this new vehicle is crazy loud to start out we tested for about 2 hours before we got to a 154.7 with a box that was just sitting in the garage. LOL once i find the swee…

i have a nightshade v1 15 dual 1 and a rd1750.1 that i will be running at .75 ohms i want deep clean low bass while listening to rap and rock please help me with box design specs

So im on my way to building a new box, right now im using 2 6" aero ports, in a 5.5 cube box for 3 sa 12's. But i want to tune lower and cant with the aeros, so im going to have to go back to slot port. Now my question is what is the pros and cons of small vs big ports, i know people recommend 12-16 per cube, but thats pretty broad. So what would you gain or loose from having a port at 12 per cube, or 16 per cube?? or in the middle. Does the bass get sloppier with a bigger port? (this is all for music by the way)

is the sundown 1500 .5 ohm stable?? for daily use? Using it for 2 15" SSA Icons

http://www.sundownaudio.com/misc/Russia/Russia_Magazine.pdf Full PDF of the Magazine -- the the Mazda on Page 61 - 65 Nice cover shot too !

Whats a good tuning freq. for this sub? I listen to 90% rap. for some reason i was stuck on tuning at 30-32 hz

Currently waiting on customer to pick out some vinyl so I can finish the truck box, but in the mean time I decided to get started on my next box for the kia. The quad SA8s were decent in the kia, I dotn like the layout and the way it goes in the trunk however, So Im making a new box. Infact Im going to add the 2 refurbs Ive got on the way to the mix to do 6 sa8s in the kia. So my question, how much port area should i use for 6 of these, Im going to tune to 34hz approx, maybe a few less, and Im gonna build the box at 3 cubes. probably gonna get going on it tonight as long as I can figure out the port area. Some calculators Ive tried put the port area much higher than I fi…

I have two SA-15's and I just finished making my box with the intent of adding in 6" PSP ports when they arrived in the mail. I was pressed for time because I'm going back to school (nine hours away) tomorrow so that's why I finished everything except for adding the ports. Well I ordered the ports from parts-express last Monday and just to make sure they got to my house in time I paid for two day shipping. I MADE SURE they were in stock when I ordered them. Guess what happened? The ports didn't ship out until Thursday. I called parts-express on Thursday to see why I didn't have the ports yet and they told me that "they just shipped out today (Thursday) because the parts w…

I recently just got a SA-12 D2 in a 1 cube sealed box running off an AQ1200d at 1 ohm. I wanna get a ported box and was wondering what size and tuning I should go with if I mainly listen to rap, going for more spl, and is good with the power level I'm using. I originally thought to go with 1.5 cubes w/ 35 hz tuning. Does that sound about right or should I go with something else?

Got some refurb SA-8s coming next week from Mike for some builds, and here's the first. Its going in a 99 Silvy, made to fit over the center hump under the rear seat. And we did not have to raise the seat at all! The box nets 1.1 cubes, tuned ~ 38hz. https://picasaweb.google.com/ASB2106/NathanS2xSa8# Some of the better pics..

For the month of March our SAX multi-channel amps are on special ! SAX-125.2 : Regular - $250 MAP SALE - $205 SAX-100.4 : Regular - $385 MAP SALE - $345 SAX-200.4 : Regular - $815 MAP SALE - $650 You can order from your favorite local or online dealer OR you can Paypal me at [email protected] to order. This is for the month of March only and in the USA only. For Alaska and Hawaii SH quotes e-mail me -- otherwise the above are shipped in the continental 48 states.

Was wondering if you guys are going to make a amp in the future thats full power (so to speak) at 2ohm instead of 1ohm? Instead of just linking 2 together

How long is shipping? Is it the standard three to five business days?

My SA-15's came in the mail and im looking forward to building a box for them shortly but i find that there are no T/S specs at all on the SA-15's page over at sundownaudio.com Help?

so im pumping gas today and the guy at the pump ahead of me seen my sub thru my windshield and ask'd if its the old power hx2. i said ya and he started talking bout he used to have a pair then he ask'd what i was runnin it with and i pointed thru my hatch n said a sundown saz1500. he said no shit?and im the first here in oklahoma other then himself that hes talked to who has any clue what sundown is. and then he says he will be working for sundown audio this summer and i think he said his name is hitman or sumthin....asian guy in his early 20's....is this guy for real or just talkin out his ass

hello i have a couple of sundown 3500's strapped @ half ohm and i was wondering what are the best rca cables i can use ?... i was sure i saw a thread about it but i cant find it .... help ?...

This was to be a week of catching up on e-mails BUT the container of SA speakers showed up about a week early so we've spent the week unloading, sorting, and shipping the SA woofers. I've done as many e-mails as possible during but still have over 100 messages to do. If I can wake up early one day this weekend before my family I'll try and tear through them and get everyone taken care of. Thanks for the patience guys !