Sundown Audio

Looking for suggestions on which sub would be better suited for my situation. I have right at 6 cubes after all displacements, figuring on 82 square inches of port tuned to 33hz. Power will not be an issue with either sub, current plan is one or two PPI Black Ice 1800s. Electrical will consist of 270A alt and 2 D3100s. Going into a very well deadened 99 Ram Quad Cab. The reason for the limited space is I'm attempting to keep a small seat area on either side and run the enclosure centered on the back seat, seat bottom to ceiling. With that setup the only wat I can realistically pull it off is to have both sub and port forward. I figure I'll center the sub between the front…

This is our second full-range Class-D / 19v stable multi-channel to hit the market after the SAX-125.4 model. It is a VERY compact unit designed to fit just about anywhere. They are available NOW for $400 from any authorized dealer in the USA. ----------

NeoPro-v.2 Info below. They will be in stock mid to late August. New power ratings : 6.5 - 180 RMS 8 - 200 10 - 300 * Included Grilles And mechanical drawings : http://www.sundownaudio.com/misc/protos/NeoPro_v2/NeoPro-10%20V.2%20mechanical%20drawing%2020130716.pdf http://www.sundownaudio.com/misc/protos/NeoPro_v2/NeoPro-8%20V.2%20mechanical%20drawing%2020130716.pdf http://www.sundownaudio.com/misc/protos/NeoPro_v2/NeoPro-6.5%20V.2%20mechanical%20drawing%2020130716.pdf

This is a direct replacement for our old SAX-100.4 model as it is a Class-A/B model amplifier. It is much more compact than the old SAX-100.4 but not nearly as compact as the SAX-125.4 model. We have had a great deal of demand for this unit as it is significantly less expensive than the SAX-125.4 model and is perfect for those that don't need such a small foot-print or a 19v stable amp (these are stable up to ~16v). They are available NOW for $400 from any authorized dealer in the USA. -----

To order a re-cone e-mail [email [email protected]][email protected] -- do not e-mail my "sundownz" address if you need a quick response.To reduce back-and-forth e-mails ALWAYS include the following : 1) What you are ordering -- Model, Coil Configuration, Etc. 2) If you already have a basket or not; please check below for any special notes. 3) If you need ANY custom options please specify up front. 4) !!! YOUR ADDRESS AND NAME !!! 5) A picture of what you have goes a long way to be SURE we are talking about the same thing. IT WILL TAKE, ON AVERAGE, 10-14 days for a built item like a drop-in to be completed. It may take longer depending on how busy ou…

What is the total outer diameter of a zv4 12" minus the gasket? I have 13" to mount them in. And no, Im Not talking bout the cut out for the hole to mount them in the box. Lol

I want to know a single SA-8 V1.5 T Line enclosure design for a sedan. The sub will be daily played and I have 650rms on it.

These amps are due mid to late September. This is our ETA (Estimated Time of Arrival) -- as in it's our best estimate based on the information we have right now. It is subject to customers and transit delays -- so please, DO NOT pre-order if you cannot accept possible delays. To pre-order visit your favorite authorized dealer locally or online OR for the purpose of the pre-order send us payment via Paypal to [email protected] -- include a FULL description of what you are ordering and be sure you have a CONFIRMED shipping address. You can also call in and pre-order with a credit card with Debbie at 704-528-9700 Ext : 5 ---------- PRICING : MODEL // Regular Price /…

Will this work? Power will be a Shark Audio 2500.1 (APSM-2000 clone). TIA!

Just wondering how these guys are linked to you? www.emfcaraudio.com

The sa12s are rated at 600rms but i have seen they can take more. My question is can i safely run two sa12s on the saz1500 at 1 ohm in a daily setup?

I've tried emailing support like 5 days ago.... Haven't heard anything back. Called a few times, always a busy signal. All I need is a replacement dustcap for my sub.

Z v.4 12" D1 : Z v.4 12" D2 :

Just got done unloading the trucks... the 15s and 18s are here in stock for the first time. We have additional 12D2 models for any over-flow overs as well. Any 10s either coil or 12D1 we'll still have to build until the next shipment. Also some X-18 in D2 and D4 were on the truck as well as re-stocking quantities of SA-10/12/15 and SD-2 10/12 woofers.

Curious if anyone on SSA has purchased the X series subs?

Is the amp available in the store? It's perfect for my application but it has no image and the description saying that it's essentially in a prototype stage.

Here is some up front info Vehicle : Gravedigger Powerwheel Location in the vehicle: rear hatch, ported into front cab Space available (Length x Width x Height): Subwoofer make and model: SA-8 V1 Subwoofer Size: 8" Number of Subwoofers: 1 Type of Port (Kerfed, Slot, Aero, etc.): 4" pvc What type of music do you like?: just want a burp box. Is your goal SPL or Everyday Music?: Mid 160's SPL Tuning Freq (Hz): 40 give or take - Volume : .5 - 1.0 cubic feet of space available. the box pictured below is .62 Questions: Just joined the site. See this thread http://www.soundsolutionsaudio.com/forum/topic/60250-powerwheel-time/ Anyways started a new design for my sons Powerw…

Just came in about an hour ago ! So they are now in full stock in 6.5 , 8 , and 10" models in 8 ohm and 4 ohm. * Included Speaker Caulk

We unloaded these last week -- they are fully in stock in D2 and D4 coils at the same price as always. Rating is now 500-watts RMS due to the longer coil and modifications to the soft parts. They feature a longer coil, bigger surround, deeper motor structure, and a few other minor modifications. The E-15 v.2 will be coming at some point in October to November.

Does anybody know how to replace the led inside of the bass remote for the sundown saz 1500 v1? Also what kind of light it is so i can buy the correct replacement? Also why would my knob make my bass the same loudness at halfway and all the way up?

See below for X series production parameters : ----- X-10 D2 : X-10 D4 : X-12 D2 : X-12 D4 : X-15 D2 : X-15 D4 : X-18 D2 : X-18 D4 :

Cool comparison pictures AND introducing the TEAM Sundown motor that is in development. It will be our first 4" coil motor. Before you ask... ETA and price not yet available. As usual both will be announced when they ARE available. * From Left to Right : TEAM Sundown, NS v.3, NS v.2, Z v.4, NS v.1, Z v.3, Z v.2, and finally the X Motor

Here are the photos from Facebook -- I suppose not everyone gets on our FB page so posting them on the forums too : * SPL Spiders shown with the Carbon Fiber Dust cap prototype

I'm going to be powering 2ea Fully Loaded 4" Voice Coil FI Audio BL15's (1,500rms ea) and I currently have a Rockford Fosgate Power 2500bd-1 Amp but i'm curious how the Sundown SAZ-2500, SAZ-3500 and the SAZ-4500 Compare to the Power 2500. I have 2 power 2500's right now still in the box which box say over 3,100 watts ea at 1ohm. The biggest reason I ask about the comparison is the cost of the SAZ-4500 is the same cost at the Power 2500. Is there just too much brand name mark up in the Power 2500 or is it a solid amp for the money? My Power 2500 Birth Sheets say...

Will 2 15" SA 15s have enough room as of specs in a ported box that is approximately 36" long, 18" deep and 24" tall? Just wondering because I would like to put two 15s in the cab of my 98 s10 extended cab.