Sundown Audio

Just wanted to publicly thank Jacob for his support with my cause! A great guy with a big heart and with a great product! To save some typing, here is a link: http://www.soundsolutionsaudio.com/forum/i...showtopic=26719 That right there my friends shows this company is going places.....well besides DOMINATING SPL events.

Well I finely went out and worked on the van, I haven't touched it since this weekend. I pulled the sub out that I knew had problems.

I am back from SBN... will take me a few days to get rolling again but we are working hard on e-mails, the SA-8 pre-orders, and any other orders that have been placed !

hey guys, what do these put out at 1ohm on a electrical system of 14-15 volts? also 1 more question if you dont mind..do you think a 300 amp alt from EA and a yellow top under the hood and 2 Kinetik HC2400 batteries in the back will be enough juice for the saz-3000 to its potential and a sundown 4 channel amp? heres some info on the kinetik's incase some dont know them Kinetik HC2400 Power Cell. MOST POWERFUL audio cell anywhere, PERIOD! Used in the loudest vehicles in the world and boasting over 180dB when used in competition. This bad boy has more current than power cells twice its size. If you want the BEST, this is it. Providing thousands of amps at near dead short,…

The bass knob for my SAE-1000D is really stiff and difficult to turn. I'm afraid that if I try to turn it it's going to rip the screws out of my cheap plastic dash. I have a Kicker bass knob that's much looser and easier to turn. Can I use the Kicker knob on my SAE-1000D?

will b building a new box soon, & tryin to figure out how much port area you'll recommend 4 a 15" ns in a 3.5 cube box? I have it n a 4.8 cube box now, & it sounds good. using 3 4" aeros @ 32 hz. not sure if I want to use the aeros or a slot 4 the new built, would like to use the 3 4"s but ill b to long 4 my box. so I'm thinkin maybe only usin 2 4". what u think?

great. i have 2 8ohm mids in my car temporary for now until my door panels are done, and ive had numerous amps hooked to those same 2 mids with the same HU settings and all, and on any amp ive used (RF Punch amps, MTX, etc) the sundown 100.2 sounds the absolute cleanest, HU can be turned up alot higher (pioneer 880, usually keep it at 50 out of 62 max) and now, like 55-58 doesnt even distort when before 50 was the most i could go. great amp overall, im really glad i went with Sundown. :bigclap:

just wondering if i could beef up a paper cone with some resin on my ten's? can someone tell me how they did it? front or back?

Hi All, Complete noob to the Sundown name, but I recently purchased a SAE-1200D to power a SSA Icon 12 as a daily driver. My question is on the remote that came with the amp there is an 'off' labeled to the left of the min setting. Does this turn the amp off if the knob is put there? I was going to install a switch in the remote turn on lead so that I can have the radio on with out the sub at certain times. (Like listening to a hockey game on the radio) But if the remote will serve my purpose then there is no need for the added switch. Thank you for any help that you can provide.

Todd Mayton (Twisted Mayhem) Amp(s) - 2 Sundown 1500d's Sub(s) - 4 T3 Audio Ts 12's Amateur Street 2 - 145.5 - 1st Place Jason Drinkard (Twisted Mayhem) Amp(s) - 1 Sundown 3000d Sub(s) - 4 T3 TSS10's Street 2 - 148.7 - 2nd Place Bryan Mayer (True Bass/Mayer Audio) Amp(s) - 2 Sundown 3000d's Sub(s) - 6 True Bass Ultra 10's Street 4 - 148.00 - 2nd Place (by .1 dB) Shannon Lee (Twisted Mayhem) Amp(s) - 4 Sundown 1500d's Sub(s) - 2 T3 TNSF 18's Modified 5 - 149.5 - 1st Place Oran Barkley (Team OSC) Amp(s) - 4 Sundown 3000d's Sub(s) - 2 Memphis MOJO 15's Mod Ex 3 - 148.4 - 1st Place Congrats to all Sundown Users

Nightshades are out of stock -- updates will be posted when they are available again.

Alrighty down to business! Take note of my 2 pics below. The first pic shows a piece of mdf with 4 12volt fans in it to cool the amp which is under it. Notice the second pic where the amp is underneath the fans. I am doing this so i don't lost 100% of my trunk as i will be going back to school in september. I guess this is a makeshift amp rack! My question is should my fans be blowing onto the amp? Or sucking the hot air off of the amp? I assume blowing (cooling ) the amp but i thought i would double check! and also should i be using 4 or will 2 work just as well! the fans i am using are: http://www.parts-express.com/pe/showdetl.cfm?Partnumber=259-150 amd yes i know my…

Would my 1500d power 2 12" t2 ok? I know they are 1000rms/2000peak but I dunno if its underrated or over rated specs.the reason I'm asking is cuz I found the t2s at an awesome price too good to pass up! I just wana know if my 1500d would be a good match for the 12s.any input would be appreciated! Thanks

well team carlisle acoustics/ team sundown audio went to E town today and i believe we made a good showing. 1st palce STREET 2 - Derek "me" with a 147.7 @ 34hz SPL in my VOLVO 2nd place MOD 2 - Jeremy with a 149.9 1st place DRIVE BY 2 - Jeremy with a crushing 128.4 1st place DRIVE BY 1 - Corey with a 121.9 and i believe Seth was in 3rd place in AS1 cant remember his score We should have plenty of pics to post up as well.!!

Hello all, My question is as follows: When utilizing the RCA output on an amp, such as the 125.2 or 50.4, how is the outputted signal affected by the crossover and gain settings of the amp it is coming from? For example, if I were to use a 50.4 to run tweeters and mid range, and then I wanted to utilize the RCA out of the 50.4 to connect a 125.2 which I would use to run mid-bass. Will the RCA out of the 50.4 only pass the higher frequency signals that it is set for to run the speakers connected to it, or will it simply pass the signal through that it is receiving from the head unit? Thanks for all of the input in advance!!!!

$400 for an SAZ-1500D until August 31st They are IN STOCK and ready to ship. My way of saying "thanks" to my customers over these past three years! This is the lowest price ever seen on the SAZ-1500D. Send me a Paypal to [email protected] with Note "SAZ-1500D SALE" OR Talk to your favorite Sundown dealer !!!

I'm going to be replacing my HiFonics BXi1606 with one of these amps...I currently have 0/1 guage running from the battery to a fused distro block that has (4) 4ga outputs...the length of the wire running from the fused distro block to the amp is about 12 inches...would it be okay to run 12 inches of 4ga to the power input of this amp?

Finished up a nice little install in a 2001 Lexus IS300. Kenwood DNX6990 Hybrid Audio Imagine 6.5 Sundown Audio SAX-100.4 2 Sundown Audio SA-12's Sundown Audio SAZ-1500Dv2 Customer took the videos, as this isn't my car.

I was looking into the SA-15 and looking at this spec sheet confused me. The specs for a sealed box are only implied for a D2 version of the subwoofer and the ported for a D4. Is this specific recommendations or can either subwoofer work for either enclosure type and size? Don't want to seem stoopid but I've never seen it explained that way before, so I had to ask.... Thanks....

I have Knu Konceptz Krystal Rca's in my ride and I need a Single Rca to Master/Slave my Saz1500d's together. Anyone know of any nice Rca's to use to make the Single run? If you will post me a link cause i am looking to buy one tonight. I am searching as we speak. The shortest KnuKonceptz has is 13 feet. That is way to long. I am still looking.

Wanted to share my install with everyone on here because I have been reading your post and advice for a long time. Its a saz 1500 on two Kicker L7 10's in a sealed box internally fiberglassed for extra strength and also for better sound quality. Kicker was not my first choice of subs but its hard to find a 10 inch sub with shallow mount that can handle the 1500. Went forward firing because its the loudest application you can get in the titan and also because up or down firing limited mounting depth. Went through 4 brands of subs and swapped out a diamond audio d5 1200 for the Sundown before being happy not an easy truck to get great sound out of. Here are some pics.

From what i've read, bass boost only sends an ugly, distorted signal to the sub. So should bass boost be set to zero, and only use the wired gain remote? Also, when using the gain remote, does it override the settings you have on the actual amp (the Gain knob on the amp)? Also, bass should be set to zero on the head unit, correct? Edit: Talking about the Saz-1500d here

did a 147.6 with 1 10" and 2 1500d's. last year i beat the burb with the kicker in it! and this year they did'nt even compete. oh here are some pix from today and will get more up later http://s8.photobucket.com/albums/a42/splfrek/truck%20bed/

so here's my dillema. i bought 2 sa12s after hearing my brothers friend erik talk about them on and on. they were on ebay and i got 2 fro 200. sorry im ballin on a budget. so when i decided to buy my amp i guess i lost my mind cause i bought to big of an amp just because i could and the price was good on db-r. was originally gonna run the 12s in my civic but its kind of ugly right now and just bought a pair of 23s for my tahoe so i might as well put the system in it. if I were to run 3 or 4 dual 4 sa 12s what would this amp put out at 2 ohms or 2.667? it will be a sealed enclosure cause i dont think i can fit a ported enclosure behind my third row along with an extra ba…

So guys i am getting a recone on my 15 to a pair of 12's, the subs in question are the NS v1. my question is how many spiders does the NS v1 normally come with? i ask b/c i will be running 2-saz2500 strapped to the 2-12's and someone mentions to me maybe i should get another spider added to the 12's so they can handle the amount of power? so my question again is do i need or shoudl i get another spider added to each sub or no would stock be enough. i plan to do a daily/ burp car but primary a daily setup application. thanks for viewing my thread and any input! Kenneth