Sundown Audio

The SAZ-3000D is now available for the general public, contact your favorite dealer for pricing today!

I just picked up a 3rd 1500D last night for a steal of a deal and might pick up a 4th in a few weeks if the guy decides to sell it. Is there way to wire one remote gain knob to both strapped pairs of them? If not how do you normally control multiple amps as I really like being able to turn them up/down from the driver's seat?

Jerome, I responded to your e-mail from both of my e-mail accounts this morning and have responded to you three other times. It seems you are not getting my e-mails - if you are a forum reader I can respond to you here.

Just for reference... please e-mail me. The delay on responding to PMs is annoying when I have 10 to answer so I am going to quit answering them once my box fills up again - please e-mail me.

Trying to wire up now- not worried about what ohm to wire it up to got that i got 3 and i am wiring it to 1.33 ohms and i was gonna just use the wire terminal as a jumper to get the neutral and power wire to the other subs like 2 wires on the terminals on 2 of the subs and the last sub will just have 1 wire into all the terminals because i dont have to jump it on the far end so my question is can two 12 gauge wires fit in one of the terminal in the sa8-- if not would it be better to run a seperate run for each speaker to where the wires are coming into the box- or would wire nutting them and getting a good tape job be good enough cant wait to try these out-to make su…

I have the original motors and I wanted to know a few things about these puppies. 1) Are the new motors deeper (or any different at all?) allowing the coil more travel or are they close to the original E8, as I've bottomed these out and cause several mechanical failures (I will take this into consideration when I build my next box, 8-16 will be powered by a single 3000D, re-enforce the spiders, ect., design the box to prevent bottoming out, i always set subsonic, but love low extension and will likely be tuning low) 2) The spiders are wider, about all I know, are they stiffer? 3) Is the surround built to handle more travel, is it stiffer? 4) If you happen to have the spec…

well we had another good showing today at a great show down in elizabethtown.. was a little hot though.. Derek 1st place Street 2 with another 148.. PHAT CAR award!!! Corey 2nd place Street 1 with I believe a 145.3 1st place Drive by 1 with 121.8 Seth 2nd place Amatuer Street 1 with a 143.4 Jeremy 1st place Mod 2 with a 150.4 "playing music the entire SPL run.. hehe" 1st Place Drive By 2 with a killer 129.1 "lookin for a 130 but just too hott" Also Drive By Best of Show also another member of our team that doesnt have sundown stuff yet Josh 1st place Mod 5 152.3 have a few pics on the way

At what voltage is the sax100.4 rated at?

hi, i am going to be getting an sax100.2, sax100.4 and a saz3000d. and i am wondering if this is going to be enough electrical to support it. 1 powernaster D1200 up front, 2 powermaster d3100 in the back, a 190 amp alternator (biggest one for my car) 1/0 big 3, and i am going to be running a ground run to connect all the batteries together. also the sax100.2 will be at 2 ohm. two of the channels will be at 2 ohm and the other set will be at 4 ohm on the sax100.4 and the saz3000d will be at 2 ohm(reason for the saz3000d at 2 ohm and not an saz1500d is that i might get a new vechile(sp) in a year and then i want to go for just spl in the new vechile(sp(. so then i will al…

Watsup fellas, so I got a new Sundown SA12D4 after I blew my other one and I got some questions in regards to setting gains to prevent this from happening again. So my setup consist of a single sundown SA12d4 in a ported box 1.75 cubes tuned at 35hz, wired at 2ohm to an Alpine MRX-M110 (rated 1100rms @ 2ohms), and Kinetic HC2000 w/ knuconceptz 4g kit. So i set my gains with a DMM using the equation squareroot(rms×ohm impedance). Since my amp is more powerful I downgained and used the rms rating for the sub instead of the amp in the equation which gave me squareroot(600×2ohm)=34.64voltage. What I'am wondering is if id be able to raise the gain past that to perhaps squa…

Today I took the Escalade to its first show its seen, I honestly was expecting to do terrible, but I just wanted to go to have fun and meet people, I wasn't about the numbers. I haven't had access to a termlab to test with, and I totally thought the Funkmaster Flex show was next week. This being said I have been awake for 48 hours, yesterday after I got home from a full shift at work at 4:00 a.m. I did nothing but work on the car and get things put in. At Noon wrapped up and headed over to the show. While I was there I Introduced myself to Team Loco, they're great guys. I ran DB3 and took 1st with a 122.5. The show was great, DJ Unk performed, tons of people, lots of amaz…

would this amp suit these subs? or would it need less juice for these subs? i hear the E8s can take 800 but RMS is 200...JWing...looking for a good resonably priced setup... thnx Doyle

Ok, I will send out a BNIB Sundown Audio 125.2 FULL WARRANTY to a random donater for Haiti reflief. paypal me @ [email protected] with your message being: TREMOR DO NOT STATE DONATION OR RAFFLE, ONLY STATE TREMOR!!!!!!!!!!!!!!!!!!!!!!! I already have the random number of the donation posted up on a website. It will simply state a number, that particular donation will be the winner. Like I mentioned, its alread posted on a internet forum. I only ask that the donations be for $3+ and we will end the "game" at 12:01am PST. This is a mad ass rush for donations to the Haiti relief effort and a chance for you to get a BNIB amp for $3!!!!!!!!!!!!!!!!!!! Once the "game" is ov…

i just saw someone mention a amp of this size when is this being released or is it?

Anyone have this new amp up and running yet. How is the power of it?

Im thinking bout picking one of these up for my daily Warden set-up. Wanted to see what tests have shown in a standard 12/14.4 volt set-up, id be wiring to .5 ohm.

The SA line is mostly sold out right now... we only have SA-10 D4 in our warehouse at this time. We have more SA-8s both ways and SA-10 D2 due in 3-4 weeks. We have all other SA sizes and configurations in large quantity due in November. ----- Our distributor in Iowa, Top Dog Audio, has some SA woofers in stock. WoofersEtc.com also has stock on most configurations of the SA line right now as well.

Hey guys, not avoiding anyone but I am behind on e-mails by a day or two due to the holiday. Will work to get through them as soon as I can.

2xSA12 + SAZ2500D = 149.4 dbs - SMD Forum Originally posted on SMD by Greg Kashin. ---------- There was a regional comp this weekend and one of the Team Sundown guys was there to take the first place trophy :yahoo: car: Opel Astra OPC subs: 2x SA12's d2 amp: SAZ2500D 72Ah lead-acid under the hood and a Stinger 2150 in the back 149.4 at the comp dbrag legal sealed on the TL here's a vid testing the system a few hours prior to the comp: pics are a few and blurry...hoping to get more info on this later -- here's a nice video of the same car with just one SA12

I want to say thank you and just let you know that you WILL be put up on the rides section, but unfortunaly, I am currently working on a project that has not been approved and accepted and have not yet done it. Fear not, they are coming!

Went to local show, Larry's Electronics today in Mesquite....Lotta nice stuff there... Had my hoopty out there as usual...both 3000D's strapped @ 0.5ohm...each amp seeing 0.25ohm....and the 18" Nightshade in my daily music box tuned to 27Hz....WoW! lol.......Peaked out at 44Hz.... Tone 44, I burped a 150.4 and a 150.5.......I can't wait to get the SPL box in this damn thing... On to a couple pics..... The Ride.. The set-up... The Equipment of choice.. The score... Had a good time...Looking for 154's when I get the SPL box done...

I might be able to get a hold of a preproduction prototype model 100.4. What are the differences between the two? TIA.

Hey guys, Got backed up a bit on emails again around the beginning of August... some emails from earlier in the month and scattered throughout up until now have not been read yet. I will get to them ASAP -- sorry for the delay! We've had alot of work to do this month... looking to be another record month for us -- so thanks to all of our customers for the support and patience on emails

I'm about to order a dual amp kit from KnuKoncepts: http://www.knukonceptz.com/productDetail.cfm?prodID=KFX-PK20 What are the correct fuses I would need for the Inline Fuse and the Fuse Block for wiring up a 1500D and a 50.4. Thanks

I Have two sa12's on saz-1200d in a ported box @38hz its a hammer to the chest loud .. only problem its lacking low end.. box is 4 cubes total.. I don't want to give up much of that ear drum pounding that it has now but pick up low end would going to 35hz be a good change.. an would the box size need to go up or down ?