Leaderboard

You can walk off axis you know. SAE1200

So the only valid piece of info you have on any of the three sets is that one of them has drivers made by scan speak and you are not choosing that one? Now I'm confused

I would not use an ap mat in a door for a few reasons. For one moisture will ruin the membrane material. Not too sure why you a stuck on low qts for midbass. Higher qts is better suited to achieve a good midbass response. Plus ib maybe your best option. Plexi is not the optimum choice for enclosure materials. Especially the thin stuff you would be using. Hard plastic cutting board material would be better. Although like I stated ib is probably best for you. IMO for your install a two way would be best. Can you fabricate a small full range driver in your sail panel, dash or a-pillar?

I think he meant .5 ohms.

That's bad ass bro!!!

My 10 gauge got here today, tomorrow I'm rewiring and praying I helps

You'd be suprised how unamerican american products are. No.1 cone and spider source in U.S. Loud Speaker Components bought Nuway in Mexico about 2 years ago uses them for nearly all their spiders and some cones now. no.1 coil manufacturer Pecision Econowind winds all of it's OEM automotive coils in China mostly the only thing wound in Florida is high temp coils but all the materials are Chinese. Magnets, you ain't gonna a find a source here in the U.S. and if so it's gonna be too expensive.