Leaderboard

Volt meter installed from Amazon, way better cosmetically and performance wise than the Down4Sound one I had before. I will get some night shots of it later, I know its not centered but it will do.

I didnt like how tough it was to plug in the older Kicker RCAs coming from the Pioneer Radio to the Dayton DSP so I bought some matching NVX one's..

I had some old Kicker RCAs that I paid a chunk of change for almost 10 years ago, that came with braided a outer cover. Coudnt find matching Kicker RCAs but found some very similar NVX RCAs that were shorter than the Stinger RCAs going from the Dayton DSP to SSA amp. Removed the wire tie downs that I had holding the Stingers and then put the NVX RCAs in there place. Looks much cleaner. And go figure the NVX 6ft. RCA for my sub duty are sold out everywhere so that's why that random Knukonceptz RCA is in the picture for now. But it still looks better in my opinion than before with the Stinger RCAs.

Got a brand new DSP in from Dayton, didnt have any noise issues before but had some with the new unit. Removed all my grounds from my metra radio wiring harness and it stopped all my interference. Reinstalled everything and decided I wanted to upgrade my RCAs to avoid any issues in the future and also didnt like the look of the Stinger RCAs by the Dayton going into the SSA amp as you can see below.

Crossfire mids are installed

Mounting pads for my sub amplifier. Board will be attached to the enclosure, with dampening pads between amp and board, also rubber washers between board and enclosure. In the picture below you see two washers stacked on board, I actually used a single stack and spaced them out evenly.

My new baby.

Mood Lighting

Front battery came stock with an AGM but it was approaching 6 years old and getting low. Finally got around to upgrading it. NorthStar 94R

Or Rear Battery Position #2. It goes back in the cubby another 1" - 1.5". Excuse the clutter

Rear Battery Position #1 Excuse the clutter.

I finally got around to removing those two pieces of electrical tape that covered the holes from Hyundai emblem.

Just picked up my secondary (trunk) battery box from being covered in bed liner. Now I just need to find some room for back there for this and another amplifier.

Crazy how Hyundai made all of the lights LED but three of them, these vanity lights were the last ones needing to be swapped out.

Trunk light replaced with Festoon LED bulb from Diode Dynamics. Old bulb on the left in the second picture, new LED bulb on the right. I wanted a Blue LED but they were out of stock.