Jump to content
View in the app

A better way to browse. Learn more.

SSA® Car Audio Forum

A full-screen app on your home screen with push notifications, badges and more.

To install this app on iOS and iPadOS
  1. Tap the Share icon in Safari
  2. Scroll the menu and tap Add to Home Screen.
  3. Tap Add in the top-right corner.
To install this app on Android
  1. Tap the 3-dot menu (⋮) in the top-right corner of the browser.
  2. Tap Add to Home screen or Install app.
  3. Confirm by tapping Install.

Featured Replies

Wire your left horn plus left tweeter to channel 1 and your right horn plus right tweeter to channel 2. Each channel will see a 4 ohm load, sending each speaker 60 watts give or take.

What tweeters do you have? Do you think they will be audible receiving the same power as those horns considering their efficiency?

The only problem doing it this way will be the ID horns and Soundstream tweets will be playing the same frequncy, which wont help the horns if you try and accomodate the tweets by going with a higher tuning. If you go with a lower tuning to accomodate the horns then the tweeters will probably get damaged for playing too low.

or sell my 100.4 and get a 200.4 before they sell out :morepower1:

it would probably still be cheaper to do option one though lol

No need to have that much power for the tweeters.

My personal opinion is two amps. Either a big 2 channel for mids, and smaller one for tweeters. Or keep the 100.4 and buy a 125.2 for tweeters.

or sell my 100.4 and get a 200.4 before they sell out :morepower1:

it would probably still be cheaper to do option one though lol

No need to have that much power for the tweeters.

My personal opinion is two amps. Either a big 2 channel for mids, and smaller one for tweeters. Or keep the 100.4 and buy a 125.2 for tweeters.

Refer to post #17.

  • Author

Wire your left horn plus left tweeter to channel 1 and your right horn plus right tweeter to channel 2. Each channel will see a 4 ohm load, sending each speaker 60 watts give or take.

What tweeters do you have? Do you think they will be audible receiving the same power as those horns considering their efficiency?

The only problem doing it this way will be the ID horns and Soundstream tweets will be playing the same frequncy, which wont help the horns if you try and accomodate the tweets by going with a higher tuning. If you go with a lower tuning to accomodate the horns then the tweeters will probably get damaged for playing too low.

Then what do you suggest? I already have the 125.2 and 100.4 so there's no turning back lol

  • Author

I have the soundstream sst-05 tweeters, so yes they keep up

Oh ok, I was looking at those tweeters awhile back myself. How would you say they compare or differ from the horns sound wise? Thanks

Well the horns really out perform the tweeters in every way as far as frequency range and all around loudness. However, they were designed for different reasons. I feel The tweeters fill in the little extra something in the much higher frequency Range that the horns were lacking. I feel it just gives the finishing touch, to the music, so to speak.

You could just put some blockers or wire an in-line crossover to the supertweeters and run them like I stated earlier or you could just run them off of the headunit.

Hy this is like my setup.

4 neo-pro 8s... Bridged on the 100.4

2 srlenium st200s and 2 morel mdt-12 tweets

1 of each wired to 4 ohms per channel on a 125.2

The neo pros will get loud wired 1 per channel but 2 bridged is another story.

Recently Browsing 0

  • No registered users viewing this page.

Configure browser push notifications

Chrome (Android)
  1. Tap the lock icon next to the address bar.
  2. Tap Permissions → Notifications.
  3. Adjust your preference.
Chrome (Desktop)
  1. Click the padlock icon in the address bar.
  2. Select Site settings.
  3. Find Notifications and adjust your preference.