Scooby 8 Posted December 12, 2011 Box is small,.6-.75 and is sealed.I know that it won't give out the sort of output like a ported would,but I don't have room for a huge box.Looking for a mix of loud and good sound if that is possible.600rms @2ohm on hand. $150 price,give or take a few bucks.Thinking I can get a decent used one. 0 Share this post Link to post Share on other sites
Dangrebel 89 Posted December 12, 2011 Sa-8 man no other way!!!! 0 Share this post Link to post Share on other sites
S.DeYoung 968 Posted December 12, 2011 Check out some of Dayton audio's woofers. 0 Share this post Link to post Share on other sites
altoncustomtech 773 Posted December 12, 2011 You were a little lacking on the info of the box, is it already built? If so what size driver hole does it have? If it's not built yet then I'd like to recommend either a 10" Fi X series sub or the 10" SSA DCON. Both subs will work in that sealed enclosure and on that power quite well. The SA-8 doesn't do very well in a sealed enclosure and if all you have is that .6 to .75cuft then you'll not likely have the room to port the enclosure for the SA-8 either. A good 10" seems like the best choice for that smaller sealed enclosure to me.Just my .02 1 Share this post Link to post Share on other sites
Scooby 8 Posted December 12, 2011 (edited) Box is a prefab made for my specific vehicle to allow me to keep the room in my hatch area. Driver hole size is 9 3/16,but I could always make it a little wider if needed. That FI X looks like a very nice sub,nice price too. They have a configure option that says "BP" yes or now. What is that option? Would they perform about the same? I can get that Dcon for a good price from a board member. Just wondering if the FI would do better? The specs looks like it would. Edited December 12, 2011 by Scooby 0 Share this post Link to post Share on other sites
ssh 924 Posted December 12, 2011 I would have said the same as Alton. Both drivers should perform quite well. 0 Share this post Link to post Share on other sites
Scooby 8 Posted December 12, 2011 Picked up the Dcon for a good price. 0 Share this post Link to post Share on other sites
altoncustomtech 773 Posted December 13, 2011 You won't be disappointed! 0 Share this post Link to post Share on other sites