Sundown Audio

They are here early -- original ETA was October. * Current MAP is $299 * RMS is still rated at 600-watts * The coil is the same as the 10/12/15" models * The motor is 10mm wider, 10mm taller, and the top plate is 20% thicker than the 10/12/15" models -- in order to drive the heavier moving mass * The spider is an 8 3/8" with standard XL leads (10/12/15 are 7" spider and recently also got XL leads) * It features a newly custom tooled high roll foam surround * DUAL-2 SPECS * DUAL-4 SPECS

Okay, so I finally was able to buy some Sundown product!!! Well I bought an SD2-10 and a Sundown SAX100.4. I read on the forums that the recommended box size was .5 cu ft sealed. Upon installing I had my Dad build the box and he told me that with sealed bigger is better. I believe the dimensions of the box are as follows... Top Width - 18" Bottom Width - 23" Depth - 9.5" Height - 13" Now granted these are external dimensions and we used .75" MDF... I'm just curious is this box too big for the sub? I have the sub wired to a 4ohm load on the rear channels of the 100.4. Any input would be greatly appreciated

my right front speaker went silent. Channel one front tweeter still worked so I swtiched speaker two to channel one n it played. I then put speaker one into channel two n it was also silent. All I so far.. Can the channel just be bad?

This is a simple little system but it sounds good. For those who haven't used a 100.2 yet, the power is incredible. This amp is way underrated and works great to drive subs. I am not into installing tv's all over the place but the owner of this truck had reason. His family takes road trips so the headrest monitors are for his two kids and the visor monitor was installed for his wife since the bypass for the Z1 was only good for 500 miles at the time. All factory speaker locations were retained and the headrests have covers so the truck looks stock from the outside with the exception of the Z1.

Great customer service. The Distibutor *edit(delivered) the amp of right at my door. Needless to say I am one happy customer. But and a Big BUT there is a black mark on my power terminal ??? I know it is possible during the connection of the amp while testing but is this something I should be worried about? I will install Friday and if it works then I suppose i would be happy yet again, but im just worried if it may cause problems down the line.? is this something to be concerned about?

1. Sorry for my poor english (i'am from russia) I need help to build ported box for 2*sa12 (1 ohm connection) amp - Rockford fosgate t1500-1bd, i'd like port to be tuned to 40-42 hz Can anybody help me with dimensions of box and dimensions of port. Thank you very much. In russian discusion a can not find any info about that

I thought I saw some where that there was a carbon fibre cone and dust cap on the SA-8v2. Was this a one off that I saw? Or was it on something else? Also are there dust cap options for no insignia? Sorry if this is posted some where else but I could not find it. I do believe there is a CF dust cap option but I would prefer to have the whole cone and dust cap of possible. Or at least a blank dust cap that matches the cone. Again thanks to anyones help.

here are some pics of the event i couldnt take part since i killed the solo x while testing, because one amp gone in protection while burping a 148, maybe 2 optimas arent enough to run strapped 3ks at 0,5ohm each? waiting for the spair and gonna try it again with better batteries. it was one of the biggest car audio events in germany over 200 competitors in db drag, db cup, bass race, spl classics and AYA many broken world records in cup and drag

In Meca where less is more. What fusing should I drop down to on an saz 1500? A little more info for my particular install. Amps SAZ 1500 SAX 100x4 Power Stock alt 2 yellow tops for a total of 88 amp hrs Subs 3 sa 8's I would like to run in the lowest class possible

I just recieved (1) 1500d v.1 and (1) 1500d v.2 last night. Looking at each of them they look exactly the same and I can not tell which is which. How can I tell? and can the two be strapped together? If not I still have another v.1 so no worries.

im pretty excited i purchased a 3000d today... Jacob is really a cool guy

Just curious what head unit some of you are using. I've been using a Kenwood kdc-x791 for the last year and I hate it. It sounds good but the screen is horrible in daytime and the interface is the worst I've ever seen. Anyone have a good suggestion in the $300-$400 range? I mostly play mp3 so that feature is a must.

Hey Jacob and the Sundown crew, I had a question that (due to my wording...) may have kept from yielding and useful topics in the searchbar. I have a Nightshade V1 12, and was wondering if it would be beneficial or even feasible to re-cone to a V2. Still on my learning curve about driver components and what does what, but is this a recommended idea? Would YOU do it? Didn't know if it would yield grand results, or if I should just go with a V1 re-cone. Thanks a million!

i want to run two solo x 12" in my grand prix on two 3000.1 sundown saz and i was wondering wut load solo x is best for my amps dual 2ohm or 4 ohm? and how many additional batteries do i need? this is a daily driver with a 220 amp alternator.

Ok I searched and couldn't find a thread about the 10" SD-1v2's can anyone give me a suggested enclosure size for a single one sealed? I will be running it with my SAE-1000 at 8ohms if I get it.. Thanks!! David

My brothers kids pre-ordered a SAZ2000d. He asked me when they might be in and shipped? I was the one who recommended the amp so I get to be the one to find out.

I've looked everywhere but can't seem to find the cutout diameter for the E12. Anyone know what it is?

Opinions Please How do you think the Sundown Audio SAZ-1500D would compare to the US Amps MD-2D?

I am in need of a 8" sub that works well in a very small, sealed enclosure. I came across the E8v2 Sundown sub, and it looks promising. I wanted to get some insight/experience from people in the know. Space is at a premium in my vehicle. I have around .3 to .35 ft3 to work with. I would like for it to have good SQ with good output (I am aware that it's an 8", but I have heard some 8s with decent output in a sealed enclosure, so I know what to expect). I have not purchased an amp yet, but I plan to run 300-400 RMS to the sub. This will be going in an mid-sized suv. I plan to build a center console type enclosure that will fit in the second row. So, having said all this, do…

Decided to get a professional box made by my friend who is a master installer... since i am no fabricator. What is the recommend port dimensions for these subs? I emailed jacob but I figured I'd post here. Would like to get started on it today. Should I do 2 seperate chambers? 2 ports , 1 with each sub.

Merry Christmas everyone

i have 2 saz1500d's.they are gonna be pushing (8)sdc2.5 10's.i figured they would be getting around 400ish rms per sub...i need more.. to my question..would it be possible to run 3 saz1500's to these 8 subs?if so how?i have no problem running them below 1ohm.

1. I'm in the middle of buying an SAE 1000d from a member of another forum and I'm curious about how many amps is this going to draw, I was guessing around a 150 amp fuse (guessed draw to be around 125 amps) assumed .8 efficiency) to be safe, but I'm not sure, and I figured someone on here could give me a much more accurate number and maybe even a link to fuses that would perfectly fit my system. 2. Also I've looked at other topics concerning this amp and it seems that it has 2 positive and 2 negative ports for the speaker wire... but it's a monoblock amp? Once I get the amp i plan on hooking it up to my two Alpine Type R's and I'm wondering, do I hook them up …

Would there be anything wrong with running the 3000 at .5ohms DAILY? Thanks,

Hey guys I thought i'd give you guys a headup for an awesome show and i'll be bringing my sundown setup with me. Import Face-Off USACi 2X event with Car Show @ 10:00am 8-31-2008 Kansas City International Raceway 8201 S. Noland Rd. Kansas City, MO 64138 Its got the best of all worlds spl/drag racing/ufc style events/car show/bikini contests