Has been flawless for over 1.5 yrs till the other day it shut off at low volume level. I only had the car on for 10 min aswell And then the car turned into a BBQ....What in the world happend? Is this fixable? Guess im going to have to talk to Greg I am assuming?

These are all the same MOSFET on one side closest to the power imputs

This is on the other side halfway on the board

Edited December 15, 200915 yr by Mynameismcgyver

Damn that looks nasty, hopefully it gets better for you and you can get it fixed.

It looks like your ground wire melted from the heat from the mosfet rail and then zap it shorted out and burnt up.

isnt the rail grounded to begin with? I was thinking something of that sort happend but to be completely honest, I believe it melted AFTER the bar turned into glowing molten metal. Im just hoping the board isn't toast because then I can have it fixed by greg.

isnt the rail grounded to begin with? I was thinking something of that sort happend but to be completely honest, I believe it melted AFTER the bar turned into glowing molten metal. Im just hoping the board isn't toast because then I can have it fixed by greg.

Yes the rail is grounded. I hope it is repairable also. I was just taking a guess based on th pictures.

I spoke to greg and sent him those pics. Ive always dreaded this day if something like this were to happen.. I love this amp. I would sleep with it if I could.

Leave the cover off and hang it on the garage wall as a trophy!!! save up for another one. Thats pretty cool

Ouch, hope it can be fixed.

Ouch, hope it can be fixed.

Anything can be fixed, determination is all that is needed

Ouch, hope it can be fixed.

Anything can be fixed, determination is all that is needed

X2, after seeing what you did with that DD Z1 was it.

Ouch, hope it can be fixed.

Anything can be fixed, determination is all that is needed

X2, after seeing what you did with that DD Z1 was it.

X3!

Ouch, hope it can be fixed.

Anything can be fixed, determination is all that is needed

X2, after seeing what you did with that DD Z1 was it.

X3!

Shame Adrian is not over here in the states, he could make a nice living fixing amps.

Looks like my 3200, wish I had taken a picture before I sent it away.

It can and will be fixed today with SEVEARAL updates...... As to what happened. It looks like 2 outputs died and the amp tried to drive through the shorted outputs.

Yep, thank goodness! Ive been sweating like a hostage hoping everything would turn out fine. Thanks to everyone over there. Been a pleasure dealing with everyone and im PROUD to use your products.

Just shows how high of a current you're pushing.

crazy