Just got my recone for my RE SX, got it fully loaded with drilled compression plug. This is my first time dealing with the compression plug, so I just want to make sure I apply it correctly. It goes on the inside of the coil gap between the coil and underneath the dustcap right? It probably won't be able to stay in place, so would I need to glue it down?

That should explain it, however you need to rough both surfaces up a bit with a little bit of sand paper, wipe both of them down with acetone and then mix a little bit of 2-part epoxy and put the slightest bit on the flanged side of the bp power plug, spin it around and let it dry over night.

Hope this helps!

That should explain it, however you need to rough both surfaces up a bit with a little bit of sand paper, wipe both of them down with acetone and then mix a little bit of 2-part epoxy and put the slightest bit on the flanged side of the bp power plug, spin it around and let it dry over night.

Hope this helps!

It helped a lot. Thanks bro.