Sundown Audio

Just sold the last of my audio gear, and I wanted to say thanks to Jacob for the serious help he gave me with everything. Amazing customer service x100000000000000000000000000000000

I have had 2 songs make my amp go into protect mode. The amp is cool, Subs are cool, so its not thermal, Not a speaker short, so last would be over current. So would over current mean that the gain is to high for that song, its a high note that makes it do it. So the voltage is spiking to high for the amp? its a saz 2k. I just have to turn deck off, turn back on, and all good again. Does it at high volume/full tilt but only on a couple songs

I have a question. I have been reading that Sundown has two positive terminals hooked up parallel and two negative terminals that are hooked up in parallel. Which has lead me to be confused. (2) JL W7 13.5 (1500Wrms) DVC 1.5 ohm If I wire the woofers as so: And hook just one lead (+) to one (+) terminal on the amp and hook one lead (-) to one (-) terminal on the amp I should come out with 1.5 ohms and approximately 2625Wrms right? (and of course more power since they are underated) And secondly can I just hook it up to one lead and come out with the full power range?

SA-8/10/12/15 will be fully in stock again... container is here. Will be a day or two to unload and a couple more after to sort and ship things. But you can order now from your dealer.

A guy sent me his car to work on for a few months. I received it today and I've still got to figure out what I CAN do in it. By the time it's done, I'll be doing what I can in the trunk and redoing the door panels. The goal (if I can make it fit) is two SAZ-3500d's, a SAX-200.4, four Neo-Pro 10's and four Neo-Pro 8's.

how would this box work with 2 SA 12s in my tacoma on a blow through... i listen to rap and rock tuned to 31. 2 cubes per sub net... roughly... gonna be running a hifonics 2000d to them.

forgot to post this here Let me Know what ya think well Team MN Loudest and PPC did it again..... hrmmmm interesting....

Can i check the status of an order

Hey all I have an issue that's starting to annoy me. I currently have 2x sundown 2500d strapped at 1hm each. Running 2X 15" in a 10 cube box tuned to 32hz. Electrical is dc ho alt 270, xsD3100 in front and rear. 3 runs of power and grounds are all doubled in 0 gauge. What's happening started with the new box. The last box was a perfab bout 6cubes. When I play some songs that get real loud my slave cuts off. I can play it fine on alot of songs but when I get to the songs that have mad lows my slave amp cut out. When I'm driving i never drop below 13.2 Volts and i dont play at idle. Amps never get hot and happens right away when I play Thoes few songs. What should I do!! Ca…

Lots of other projects took priority over more NS v.2 motors but they came back to the top this week -- so the new ETA for more motors is end of May. Of course I'd rather product not be out of stock this long but we invested alot in amps to get around the MOSFET shortage so the NS v.2 had to take a back seat for bit.

im new to this forum but not new to car audio. ive done many installs in many types of cars trucks and suvs. i have installed sundown some times before and now im deciding on buying a pair of sa-8s. i drive a 95 dodge ram 1500 single cab that i just bought. currently i have 2 jbl p1224 12s in a downfiring box center console build in a 3.96 cubed box after compensation tuned to about 37 htz on 1200 watts rms at 1 ohm on a hifonics brutus amp. ive heard sundown sa 12s sound incredibly good and i just want to make sure im not going to lose any output by running two of these 8s from my two 12s that mount at 14 and 5/8s and weigh 33 lbs a peice. i guess i just want some clarit…

anyone within driving distance have a pair of SA-8s i could hear? REALLY thnkin this is the way for me to go, im just from the old school and cant get over 8s that perform like this, id LOVE to hear a pair

My order of SA-8's is on the way (should arrive today). This is my first experience with sundown products, and Im extremely excited to try out these 8's! I ordered 4, but decided to only put two in my car for now, ran off a RF 1000bd Amplifier. The other two Ill put in my truck later on another 1000bd I wanted to make a nice box for it, something that looks as good as it sounds. Most of my boxes are all about function, this one started that way, but has since changed into quite the nice box. The box is built to 1.1 ft^3 net, 1.5 gross volume, 18 inches of port area, and tuned to 34 hz. I should have the last few coats of clear applied today, and I should have the subs…

To order a re-cone e-mail [email protected] -- do not e-mail my "sundownz" address if you need a quick response.To reduce back-and-forth e-mails ALWAYS include the following : 1) What you are ordering -- Model, Coil Configuration, Etc. 2) If you already have a basket or not; please check below for any special notes. 3) If you need ANY custom options please specify up front. 4) !!! YOUR ADDRESS AND NAME !!! 5) A picture of what you have goes a long way to be SURE we are talking about the same thing. IT WILL TAKE, ON AVERAGE, 10-14 days for a built item like a drop-in to be completed. ---------- EDIT 8/30/11 : WE CANNOT WARRANTY DIY RE-CONE ASSEMBLY ISSUES. Rea…

so I was sitting here wondering something so i thought i would post a question. first here is the sub a 15inch Nightshade v1 d1 now notice the terminals and how there is a hole on top of the terminals. now are those holes used for banana plugs? like this? http://cgi.ebay.com/NEW-STINGER-SPT8503-DUAL-BANANA-PLUGS-1-PAIR-GOLD-/170579337433?pt=LH_DefaultDomain_0&hash=item27b75220d9 if not what are they for? and if they are does anyone use them? I ask because lately with my new setup my subs are mounted backwards and accessing the one set of terminals is very very hard to do. notice the sub on the right hand side well that one is very tight to get to lol! so I was wo…

I just wanted to say thank you Jacob for your exceptional customer service and especially for what you did for me on Friday. I was not expecting that at all. I will always remember that. You have a customer for life my friend. I cannot wait to see the new shop once everything is in place.

(I originally posted this in the main subwoofer forum, but didn't realize there was a Sundown specific forum. Since I'm leaning towards Sundown, I'm re-posting here) What's up SSA? Hoping I could get some advice from you guys. I need a sub for my boat, but I'm just not sure which one will be best for my application. I like everything I've read about sundown so I'm leaning in that direction. I had an 12" Alpine type R powered by an Alpine MRP500 in a crappy best buy enclosure...I took it out, and looking for more The new sub(s) primary purpose is to get girls to dance on the boat. Most of the music played will be fist pumping club music, e.g., house, hip hop, and some rock…

We've shown a few pictures of the new frame... this is the first peek at the newly tooled and designed spider. I designed this spider based on all the information gathered during testing of the v.1 model -- this is our own spider design / tool where the other two spider versions from the v.1 were simply the best readily available roll profiles. IMO... this roll is FAR superior and should show in testing -- which will likely be coming on Friday. One thing that should be noticed quickly is the massive reduction in mechanical noises from the new spider -- MUCH quieter all the way up until we run out of frame clearance; which I do in the video when you hear the tick sound. Th…

Most of today will be a dedicated moving day -- we have been doing just a little at a time up to now but we are spending a solid day of it today. So shipping and e-mails will likely be delayed a day.

On a strong 14v electrical, what can I expect? I have a 275 HO Alt, 3 YT, 4 runs of 1/0 (2+/2-). I've sold my MM 2K autotek and i'll be looking for another bigger amp shortly, and i'm kinda leaning towards this.

what do i need to power this amp correctly?

Just wondering... How come this amplifier isn't listed on the Sundown website? At least I cannot find it... Maybe I'm too drunk to notice but it seems like it is missing...

sup forum. I'm wanting to upgrade my front stage . i have a saz 1000d with an icon 12'' box built to specs. i'm leaning torwards rainbow slc 265.25 since my id CX.62 v2's blew ( friends borrow + drinking = blown ) the amp i have for them is a cheap performance technique. i was wondering if the sax 125.2 is good for frontstage.. simple question but i want to confirm before spending $$ thanks!

Want to know if i can run this amp on stock alt with stock batt up front and a d3100 in the rear big 3 and one run of 1/0 to rear, will be running it at 1ohm, on a pair of Xcon 12's. Thanks

I scored a 99 Suburban without the 3rd row and would like 4 SA18's to put into it The plan right now is 4 SA15's but I really want some 18's Jacob, any info would be great, whether they are or not so that I can start moving foward. Slamology is here in June and I gotta be busting heads by then.