Sundown Audio

What is the proper way to adjust the settings on my SUNDown 3000? I'm only adjusting it to be clear to my ears as of now Can someone explain each potentiometer setting? / What each one does? and how to adjust properly. Do I set different if I want "lower" or "higher" notes to come alive? Thanks in advance ~Ronrico

Running a strapped pair of Sundown 1500d's at 2ohm daily, and .5 for comps. Kinetik 1400 up front, two 1800's in the back. Or, to the point, will an excessive amperage 200a be ok?

ok, so its either 2 15's or 2 18's and its coming down to port area that will decide whether i have enogh space or not. how much port area are you guys using for 2 18 nightshades. im shooting for 8cubes w/ ? port area @ 30hz

im goin back and forth between the 2. i think it would be badass to see peoples reactions off the fact that its 8's hittin that hard, but at the same time im really lookin for hard hittin mid and especially low bass wich is what makes me lean towards the 15's. so yalls input would be greatly appreciated.

Hi guys need your help here, would you recommend the SAZ 1000D or SAX 1200D to drive 1 Fi Q 12 Dual 2 ohms (1000 watts RMS) in a ported enclosure? I been doing some reading which indicated that, it's been recommended that the amp should be higher than woofer's RMS so I decided to ask the experts. Thanks, Shopvac.

i got everything hooked up yesterday. 2 strapped 1500s on 2 bl loaded 18's. Camera is charging, will post pics later and maybe a couple videos. I liked how the 1 1500d made my bl 12 sound, but it sounds awesome with 2 strapped. May change to 2 3000d's later,

Please say the upcoming (and highly anticipated for me anyway) SAX-50.4 model will have the same awesome crossover capabilities as the new SAX-100.4 Rev D?

I am going to be purchasing a 3500 in the next week 2 at the most. I was just wondering what would be a better match 4 sa12's or 2 nightshade 12's both boxes will be ported. reason I am asking this will be my first time using sundown equipment so I was just seeking a little advise. I have a 275a alt., 2 svr1500 batt., so I think I will be fine powering it .

jacob, i sent you an email about this, but you're stacked up on those. can i get a set?

Recently came back into stock but sold out again -- we have more coming with the SA-15 shipment due December 12th to 15th. These will have the new spider pack and significantly thicker tinsel lead wires to address the only somewhat common failure on the 8s -- burnt / broken tinsel leads.

8x SAZ-3000Ds - SEE BELOW * 3x Excellent Condition New Casing -- re-built by DB-R * $725 each w/ FULL 2-year warranty * 3x Good Condition New Casing -- Used Amplifiers * $675 each w/ 1-year warranty * 2x Okay Condition OLD Casing -- Used Amplifiers * $600 each w/ 90-day warranty

Watsup fellas, so I got a new Sundown SA12D4 after I blew my other one and I got some questions in regards to setting gains to prevent this from happening again. So my setup consist of a single sundown SA12d4 in a ported box 1.75 cubes tuned at 35hz, wired at 2ohm to an Alpine MRX-M110 (rated 1100rms @ 2ohms), and Kinetic HC2000 w/ knuconceptz 4g kit. So i set my gains with a DMM using the equation squareroot(rms×ohm impedance). Since my amp is more powerful I downgained and used the rms rating for the sub instead of the amp in the equation which gave me squareroot(600×2ohm)=34.64voltage. What I'am wondering is if id be able to raise the gain past that to perhaps squa…

any one know any thing new on the new stock of sundown audio sa-8v2? the last i heard they would be in around april 10. i cant wait for them to come in and im just wondering if there is any updates.

i am gettin alot of question lately about this, and it seems to put off alot of people that ask for a passive set up front and a 2 ohm subwoofer. and they been asking me if i can check for the SAX100.4 for 2 ohm bridged ability. can anyone test this? i only tried for a few mins on a low power subwoofer , without any special faults. no excessive heat, no protection, no audible distortion, i was wondering if anyone could bench the 100.4 @ 2 ohm bridge usability. it could be great to find out that it can do this:) thanks Eli.

hey guys... was wondering if anyone knew where i could find out the enclosure recommendations for the NSv2 18" thanks an advance!!!

Well im a big fan of Sundown and recently aquired a 3000D now im using one of the clasic Opti AMps and might be able to sell and was considdering saz 4 channel. Neetless to say if they keep doing what they are doing ill never buy a different branded Mono but my question is about the 4 ch Ill be using it to run active so crossover points not that important but being loud and sounding clean will be. It will be the older labeled model but it will still be un used. IDK if that makes any difference

im sure its been asked before but im about to strap my amps today... so do the gains need to matched or does the master control gains for both amps?

got a good deal on a saz1500 v2 .. what is the difference in the v2 and v3 .. I don't want to feel outdated lol. will be using it to power a 10 inch xcon sealed

Would an electrical system comprising of a 100A alt, two yellow tops, and 0/1 throughout support a 1500D @ .5 ohm?

Is it possible to get a custom recone for a pair of RE HC's that I have?

would there be any way to make a completelly wireless amp? something like a Bluetooth setup so people can get away from tearing their vehicles apart to wire their doors and what not. it's easy to power up an amp, but a pain in the ass to wire up the doors and the rest of it. i would love to see an amp that only needs the power and ground and instead of a remote wire or RCA's the amp turns on via Bluetooth signal sent from the headunit and sends signal to the speakers via Bluetooth. could you imagine how great that technology would be? i think it's an awesome idea. i think the amp would have to be on each speaker though and someting like a Bluetooth router would have to be…

Hey Guys. I wanted to show you a few items I picked up this weekend in Newton Grove NC. What's In The Box? NSCSPL Loudest Of The Day JFF- Truck 165.5DB in the Port This is what was in the box! The Highlander Sword. One Hell of a competition and against a tough competitor named Brian Thornhill The Highlander Sword Unsheathed. I really had an awesome time at the show this weekend and thanks to everyone for helping me out. Props to Jacob for building a very strong subwoofer and My 3500D amplifier. I set a State Record in StreetBeatz with 149.4DB on music. Chock up another victory for Team Sundown.

We did a really fun build this last few days with some great amps. Thought i'd throw a topic in this section incase the sundown guys didn't get a chance to see it. See the whole build here: http://www.soundsolutionsaudio.com/forum/i...showtopic=24203 video:

got a couple NSv2 15" d1's, built the box and would like some input on amp selection (Sundown as im a new dealer). We running Street Beat 4 (unlimited alt, bat, amp... across the board). Box is 3ft^3 per sub and tuned to about 55hz, (subs and amp on same plane) bed cut into a single cab silverado. My question is i guess is what can i put to these things (within reason), money not being an option, 2500 per coil?? 4500 on each one??? if we use 45's should we dual alt? goal is 156db, which sould be easily obtainable, imo might get close to 160 with the luck we've had lately (outlaw rules, i can post legal #'s too)

i'm currently looking at getting new Amps for my setup i'm running 4 RF T-2 15s, 2 250 amp alts. 10 batteries at 16 volts. I'm thinking about adding 3rd Alt if need be I have the 3rd one on hand. i know that sundown has 3000watt doing well over the rated output at 14.4 volts. I have heard about a new amp that is coming out and i'm very interested in running the Amps but i don't want to over load the subs to much(LOL) yes i do....... this is all installed in a 93 Jeep 4X4 Lardeo.