Sound Solutions Audio (SSA®)

Just saw this banner... Is the Icon another new driver?

Here's a video from this build. http://www.soundsolutionsaudio.com/forum/i...showtopic=26020 Enjoy

Newb here. Looking for some input from the more knowledgeable. So i can conclude on amplifier choice. Desiring to put a Gcon 15 sealed in the trunk of my Jetta. I have approximately 2.88cuft to work with. So now my question is; what rms power would be better for daily use 820 or 930? I listen to mainly hip hop and electronic types of music. Occasional rock and jazz. Please let me know if any other info needed and thanks for your help. Mark

the car the box design from sound=vibration thanks but it was too big trimmed down about 2inches and added it to the back making bigger cutouts to fit lanzar optidrive mids w/ tweets box couldnt fit with my altima mat! amp mounted w/ battery holder all knukonceptz 0ga wires, terminals, krystal kable RCAs, except a little 4ga monster cables

I'm planning on ordering two 15" Icons in the next few days and I was just wondering what you guys think I should power them with? Would one SAZ-1500D be underpowering them? It'll be a ported box... Thanks!

I made up my mind!!! and it's the Xcon.Since the xcon been on parole I can't stop drooling, 31 mm Xmax damn!!!! I will like to know the min. and optimal cu. ft 12''s and 15'' ported????

Just got these up on the shop finally. 3 Left. We can order more. http://www.soundsolutionsaudio.com/store/products/SSA-BANNER-6ft-x-3-ft.html

for my ears that is. I am 32 years old, had dozens of set ups and this thing blows me away. The only thing that I think could have possibly been louder was my first "Big" set up with 6 12s. But this was like 14-15 years ago, and my memory may just be fuzzy. After a 5 minute run around the block at full tilt, I felt slightly nauseous. It's on 1500 watts, ported at 32 hz in the recommended enclosure, firing forward sealed off from the trunk. No pics since my install isn't done. Just wanted to say this thing is violently loud and awesome.

I just picked up a single DCON 10" S4 and can't wait to get it installed. It will be going into a custom made sealed fiberglass box that is built into the side of my Cayenne. The box, after displacement, is .93 cu ft. The box used to house a single L7 and did fairly well. I am not opposed to running the DCON sealed but I am thinking of possibly porting the box for a bit different sound. I have already re-faced the box for the DCON. My question to the experts is, would it be worth it to port the box even though it would be smaller than recommended? A couple of additional things... I can increase the box by adding a 1-ended sealed piece of 4" PVC pipe that would effectively…

can anyone tell me the mounting depth of the ICON 12"er? also do you think it'll work well in 2 cubes @ about 35ish

Updated photos of the EVIL. New Black Top/Back Plates, with F.O.A.D. leads added. http://products.soundsolutionsaudio.com/index.php/product-information/evil.html

Doing a install and have 400 watts to give substage and want to use one of the ssa woofers. Going to be in back of suv,ported box,listento mostly rap . What would be a good match? 1 dcon or 2dcons. Or a single icon

so I just hooked up my xcon today to a Rockford fosgate punch 1000x1bd doing 1400 watts rms (stock electrical for now, so I know I'm not seeing all that power) .. wow this thing sounds awesome I am only giving it .5 of airspace sealed it being a 10 inch sub. before I had a kicker cvr and even when I play the same songs I hear frequencies in songs that the cvr didn't even play. my xcon does get warm but don't blame it cause the box is small..... whoever builds these subs , please keep up the good work.

hi , i am wondering has anyone tried putting a 15" icon in a sub up port back type enclosure in a trunk car. i would really like to use a 15" but my trunk height is only 15.5 inches high so this is the only way that i can think of.

hey there guys, so finally i decided going with my sub, ssa zcon 15'.. i just had question.. which one shuld i go with ?? the D1 or D2??? i will be running the sub with a sundown SAZ-2500d and i want the sub to powered what it requires?? so before i go ahead and order the Zcon, i just wanted to make sure which one. thanks!!

I started some spring cleaning today and noticed the mids on my old Baby Advent IIs had blown out the surrounds, so I figured I'd throw the Evil 6.5s in their place and have some fun. Now, these are in a simple bass reflex at 9.1L. There's a simple 1st order crossover running up to 6K, so the woofer is wide open down low and starts rolling 6dB at 6K. It's a really simple design. These are being powered by an old Pioneer Elite receiver rated at 40WPC at 6 ohms. Standing DCR on them was 7.12, so we're in business. Now, I didn't expect much as this was just a WTF experiment. I fired them up and was immediately blown away with the midrange. It's generic, …

where can i get stickers i can put on my car?

What does " Awaiting Fulfillment" mean in the order status page? and what other status's are there and what do they mean?

ok heres the deal, i have a friend that competes in streetspl,. he started the season off with 4 SA 12s on 2 M3as and was doing great, then he stepped up to 4 soundlab 18's on 4 M3as and was whopping ass. the new season starts in january and hes looking to rebuild, he asked me to find him 9 SA 12s but im thinking to suade him into 9 Gcons, the thing is, he knows the SA12's he ran them before, and i have too, great subs, but the Gcon is new, but it priced around the same, and its a comparable woofer on paper, im looking for someone that has used both woofers, i dont want to talk this guy into getting something he may not be happy with then look at me like im an as…

Back in Oct. 2010 I had a box designed for an 10" Icon at that time which I became pretty busy and never got a chance to buld it or buy the sub. Since then I've noticed the Icons been revised, I'm wondering if I should get a new box designed or if the new icons are pretty much the same as the old icon specs that the design I have will be fine??

When I play my Icon moderately loud I get a smell that almost smells like paint and when I touch the Icon it's very warm. I like the way my sounds alot however I just find that it heats up too easily. I'm beginning to think the Icon isn't what I'm looking for in a sub if it can't take much abuse. I'm not knocking it in any way, it's a great sounding sub and can get decently loud. I just find the voicecoils get stressed too easily. Everything in my car is set up properly so I know it's not the install. Could it be just be because it's hot outside? I mean I had a pair of JL Audio W3D4 12s sealed and a pair of Orion P12s sealed and would play it as loud as I wanted an…

Hey. I saw the weight that's listed in the store, but is that with packaging? Anybody know what's the weight of the 12" and 15" Xcon?

We have an update. The news is that the Carbon Fiber dust caps that were originally planned for the Xcon have been delayed. But we are going to offer dust cap options. The logo will be the same regardless of option choice. By doing this we are able to keep the standard cost of the Xcon down just under the $400 mark. The XCON will have option of three dust caps: 1.) Inverted Cap (concave mica reinforced polypropylene) 2.) SSA Convex Cap (Same as Dcon and Icon) 3.) Carbon Fiber Cap (Offered at a later date) + $17 The standard Xcon dust cap offered is the inverted option which we feel with give a very clean look.

I have just received my 15" Icon sub, and I can have a sealed free enclosure (about 4 cu ft). I listen mostly to reggae and rap, What should I do? Keep it sealed, or add a round port to it ? My amplifier is a JL Audio A1800 and will give the sub 650w rms @ 4 ohms. I have Focal 165KP for front speakers on a big Boston GT42 amp. 0 Ga power wiring... Still to come:big 3 And.......my car is a Toyota Auris(new Corolla hatchback). That's'it ! Thank you for your advices!