Leaderboard

A little more whitled in. All the specialty wood pieces installed to sculpt to the seat bottom, and pieces to support the inner edges of the side panels. Decided it should have drink holders like the other. THen ready for a second coat of paint. Thats where I'm at this morning.

I started on a second Mustang couch this week. Worked out the quirks I don't like about the first one. Got the seat a little more raked out for us taller peeps too. THe initial framework assembled... Seat and side panels installed! This one's getting a little something extra. Using these trim off of a 50's Ranchero bed top to cap the edge. Corner shot.

Washing often and sleeping as much as I can. With no job ATM and hunting going on daily/nightly, it's not like I have much else to do. I do need to get outside in the 'yard' some though. A lack of daylight is finally starting to cause issues with my mental state. With no beach recharge, I need to find an answer. He's got a great shop and a gentle ink hand right?? Glad someone else finally got some Jared ink!!! J

My wife made pizza’s with homemade dough last night. Extra good with the bread flour. Wish I could try some of your sourdough. Yes you should definitely send me pictures. I was having a pretty manic off week when you guys were here. I was bummed I didn’t get any myself. My wife got laid off a week before me but at least gets Job attached unemployment. Not that that comes close to covering everything, but is a start. She is super stressed out. I have a few ventures in the works. Wish me luck.

I still get to work and get 40 extra hours a week added to my already over 40 hours a week for hazard pay.

Ground wire is complete, covered in wire loom and two layers of electrical tape for protection. I also zip tied to keep the tape from unsticking together from the engine heat and Texas heat.

I was in talks of getting new subs, as well as the scheduling process of arranging some much needed body work, & we had a pair of amplifiers in a lay-away like arrangement w/ Sean. ....had yet another unforeseen situation arise that demanded all funds. We have new works in play that suggest that this fall we could pick back up again. Until then, I am going to try hard to start back up on completion of all the small details and loose ends...there are plenty. My work schedule will leave a few potential 3 day weekends through the summer, I hope to have a few projects stocked, awaiting my schedule to allow me to jump right in.

Im upgrading the rear door speakers so I needed some speaker rings made. Didnt feel like waiting on hdpe board to get here since thats what my front door speaker rings are made of. Found some wood at work and used a co-workers jigsaw to make these, also covered with paint to match the door panel.