Subwoofers / Speakers

Do you have a date when they will be available?

I'm building a midgate box for my avalanche and I'm looking for a good "SQL" Sub. The box is 3.8 net after port tuned to 31hz with roughly 38 sq in port (3-4" PVC 24" long). I'm going to go with a dual 12" set up or a single 15". Looking at 12" Dcons or Gcons if the box size will work or 1-15" Icon. Sub(s) will face the seat and port will be in the bed. Going to run a BRX1600 or BRX2000 depending on which sub. 60/40 on sq vs spl. Need some opinions. Thanks.

OK. So I've recently come into a little bit of money (retroactive pay from finally getting a contract). So I booked a trip to Disney world for the FAM and still have a little kicking around so... Was debating either getting: a new subwoofer, a new shotgun, or finishing off a tattoo on my ribs. So, if I went with new subwoofer, I would be looking at a 15" subwoofer, dual 2 ohm coils. I will have 850 watts on tap at 1 ohm (PPI sedona 850.1) and an enclosure that would be 4 cubic feet tuned to 33 hz. My question I guess is will any of the following do well in this enclosure: 1: SSA gcon 15 2: IA lethal injection 15 3: fi ssd 15 Enclosure is already in the vehicle with an r…

So i am looking into a clean sounding component set that could keep up with 3 SA 10's Budget is not a huge matter in this as I was looking at the focal krx3. If I don't have to spend that much and keep everything in factory locations then that would be great. Going in a 2013 tundra. Plan on running them off a CT Sounds 125.2

So I am looking for a sub that could fit my needs. I need something around a 6" mounting depth as that would give me just over 1.5" of backspacing. I was planning for 4 sa 10's but my box wouldn't allow for it. My max dimensions for the box are 27-H x58-W x9.5-D1 x6.12.5-D2. Any help would be great.

Hello everyone, I have heard Rockford fosgate p3 12s in a ported box and sundown SA 12s in a ported box, I heard them at different times and both seem to be about the same as far as loudness goes, they are both 600 rms. I just wanted to know if anyone has had experience with either and what sub is a "better sub" in your opinion.

funky-pup/ does anyone remember these.....LOL

Hello, I am wondering if anyone would happen to know how big of a box and a great tuning frequency for a Incriminator Audio Judge 15" sub? T/S parameters would also be greatly appreciated. I just need to know the basics really, I can figure out the rest with BassBox Pro 6. So far I just been kinda guessing on what the box size should be. What I have gotten, was 5.5 Cubed tuned to 29Hz.

In the interest in trying to do as Sean (///M5) had told me I needed to do in my ON/OFF Axis thread I've been playing around with everything. I've been going through crossover and EQ settings on the components in the van, I've spent time playing with the components in the Jimmy (I can't drive it, may as well work on the audio, right?), and I've also been slowly buying up some other stuff to play with. I bought the Dayton RS180-4 mids from Ricksi, I bought a pair of Aura NS3 3", a pair of Fountek FE85 3", and a pair of FaitalPRO 3FE25 3" full rangers all for the sake of trying to train my ear and learn what problems and anomalies can and are occurring in the hunt to get …

Tossing up a single 15'' Sundown Zv4 or two 12'' XCON's tuned for lows. I know that the Sundown is built for it but would it be able to offer me the same amount of throw that 24'' of cone area would from two 12's?

thinking about buying these 2 sundown zv3 18s to replace my 2 fi ssd 18, would i be gaining or loosing, i got a mmats 3500.1 for da power

Now days the new Fi Q's are rated for 1500 RMS stock, 1700-1900 RMS with cooling while the AA Havoc is rated for 1250. In searching older reviews and comparisons I have read that for the most part the Havoc plays better down low but I don't know if it will handle the 1800-1900 watts RMS daily the Crescendo BC3500D will be giving it. I would like for the enclosure to be 5.0 net cubes tuned to a medium of 31 Hz either way and I prefer lower end deep and ground-pounding bass in the 28-36hz range more than anything. I want to flex my car to bitts and pieces and "feel" the music more than merely hear it. I want to violently shake everything and make it feel as though my car is…

I am trying to decide what to run on my front stage and I have been curious about these http://www.hertzaudiovideo.com/schedaProdotto_en.asp?id=2&idcat=31&idprod=98&numid=1&numcat=2&numprod=4 has anyone here run these yet or have any experience with the Mille 's ??? I have been looking at this set for my front stage and wanted to see if people who got them in their installs are happy with their performance for the $$$$...comments good or bad

I'm wanting to know what would be the best interior speakers to swap out with my current stock ones. I have 3 different sets in my Lesabre. Dash is 4x6. Front door speaker size is 5 1/4 and the rear deck has 6x9s in it. What would anyone recommend me running? This way I don't have to do any cutting anywhere just yet. And also what kind of amp would be recommended to run these speakers off of? Appreciate everyones input and comments.

Wondering which would get lower and deeper (not necessarily louder) on a daily basis. I listen to strictly Decaf and chopped & screwed music in the high 20Hz range and low 30's

So in the next month i will be starting a new box build. I am kind of good at this stuff but always look for others advice. So the new build will be for 2 Fi sp4 18" fully loaded subs. 1 Crescendo Audio bc5500d and 3 xs power xp3000 batts. Still have to find some one that makes an upgraded alt for my car(2004 Hyundai Elantra gt HB) that does not cost an arm and a leg. I will be removing the back seat building a large box and then walling around it the box size is going to be 48"w x 36"h x 30"d. Will be 1.5in thick with at 2.5in front plate. From what i came up with(been a while since i made a box) was a box that will have 15.98 cuft after porting. The port is 7in tall and…

Does anyone know the exact outter diameter of the hcca 15? Cant find it anywhere and doing a blowthrough for someone and its going to be a tight fit

I'm planning on upgrading my system within the next month or so, currently I have a Kicker L5 15" running on 1k watts rms in a 4 ft^3 tuned around 40 hz. It's gets low, but doesn't get low enough... I'm leaning towards the Sundown X-18, or maybe a Sundown SA-15. I've heard the X series can take a hell of a lot more power than what they are rated for (1250W) I believe. Which is what i'm leary about, would I be better off getting a X-18 wired down to 1 ohm at 1400RMS, or go with a SA-15 wired at 2ohm at 1k rms? How much can these subs truly take?

im running a 12inch icon at 1 ohm on a sd sax1200, ported at 32hz. im looking to upgrade for more output. the icon is amazing but i want to move a little more air. contemplating going to an xcon 12 or 15. i like the specs of the sundown x series also. i want something brutal! am i barking up the wrong tree with an xcon? do i have enough power to push one in a 15inch? lemme know what you guys think.

This may be a stupid thread or question or both.I was curious if. anyone out there has designed a square vc sub?Would there be any pros and cons if it was/could be done?Sorry if this is waste,I woke up with this random thought for some odd reason lol. That N is soppose to be a ? mark.in the title

What I have right now.... 2 Sundown E-12s (400rms version) Hooked up to a 1700.1 Hifonics Amplifier at 1 ohm. Inside of a custom box made for the Ford Mustang Convertible, .9 each sub, sealed. Well, isnt that too much power? yes it is! So obviously the gain is way down. My question, Would I benefit from switching the subwoofers to something that can handle more power? The problem: If I do get new subwoofers, the mounting depth can be NO MORE than 6.5 inches.

I just recently got my 97 Buick Lesabre and want to do a budget build in it. What would be some good ones for me to consider? The trunk dimensions are roughly 34w 14h 32d for the box build. I'm looking to get more spl than sq right now I will upgrade the highs and mids at all later date just want to get it going.

I have a 2002 forester looking for a good starting place for box ideas for 2 9515's and what would be better power wise. M4, M4a, DC 5k?

I am wondering which amp setup would be better to run on some.mid range bass door speakers and tweeters? I see a lot of people running 4 channel ones but wanted to know everyone's input on them considering I have a 2 channel just sitting here at home that hasn't seen any power yet.

So I was coming home from work yesterday and I was bumping at a decent volume. I started to smell something burning, but it wasn't coil. I took a reading of the coils from the amp today and wasn't getting the correct nominal. Took the sub out and read the coils from terminals. One coil wasn't reading out at all, and the other was reading like 12. Took the coil out and this is what I found: Recone was done in November or so. This sucks.. =[