progress update, last post was not feeling the fuse mount on the passenger side , it was not gonna work so after some scrap hunting decided to go with some plate aluminum. By grasshoper at 2010-10-21 decided to try my hand at some detail work on the plates with a cordless drill and wire brush, looking for a scalloped pattern By grasshoper at 2010-10-21 By grasshoper at 2010-10-21 By grasshoper at 2010-10-21 By grasshoper at 2010-10-21 By grasshoper at 2010-10-21 By grasshoper at 2010-10-21 By grasshoper at 2010-10-21 ! By grasshoper at 2010-10-21 By grasshoper at 2010-10-21 I like these mounts better than the previous ones, fuse holders mounted, fuses installed were going hot By grasshoper at 2010-10-21 By grasshoper at 2010-10-21 By grasshoper at 2010-10-21 got the twin e-fans and radiator permanently mounted, all wired , soldered , and shrink wrapped, man sefugi has got a super clean sense of flow when it comes to wiring, routing, painting, installing flux capacitors, you name it if hes involved , half ass wont cut it its either ready for the judges to inspect or its nothing! By grasshoper at 2010-10-21 By grasshoper at 2010-10-21 By grasshoper at 2010-10-21 By grasshoper at 2010-10-21 By grasshoper at 2010-10-21 By grasshoper at 2010-10-21 By grasshoper at 2010-10-21 By grasshoper at 2010-10-21 By grasshoper at 2010-10-21