T/S param change on IXLs

[dubbreak 4]

When did this happen? It looks like the website was just updated recently. Any chance there are some of the 'old' model ixl 10.2.2 and 12.2.2 with the lower FS kicking around to be purchased?

With my application sealed is a lot easier (yes the recommended ported sizes are small, but you still have to get a port in there). I can't do 2.5cubes so the 15.2.2 is out of the question.

[mrogowski 6]

Hang in there. Things are "transitioning" right now. I'm working to match parameters closer to 'decent sealed' and 'decent ported' so folks can be more definitive in their selection.

Best,

Mark

[dubbreak 4]

Hang in there. Things are "transitioning" right now. I'm working to match parameters closer to 'decent sealed' and 'decent ported' so folks can be more definitive in their selection.

Best,

Mark

Cool. Thanks for the update Mark.

I'll be watching for updates. I'm itching to get a 12.2.2.

[mrogowski 6]

Alrighty. Not sure if you're south of 49 but if you are, order it through SSA...

Best,

m

[dubbreak 4]

Alrighty. Not sure if you're south of 49 but if you are, order it through SSA...

Best,

m

I'm in BC. So ordering from SSA probably isn't the most cost effective way to get my hands on an IXL..

[slim2fattycake 85]

can you post or pm the T/S parameters of the older 10" IXL 2.2 dual 2 ohms?

[crosspug 2]

T/S Parameters IXL 10.2.2

* Fs: 27.8 hz

* Re: 3.7 ohms

* Qes: 0.46

* Qms: 6.44

* Qts: 0.43

* Mms: 234.1 grams

* Rms: 6.34 kg/s

* Cms: 0.14 mm/N

* Vas: 13.9 litres

* Sd: 265.9 cm2

* Xmax: 20 mm (one way linear)

* Cone Diameter: cm

Jono

[slim2fattycake 85]

thanks.