audiohz 2 Posted August 10, 2020 With my components the crossover has -3, 0 and +3 dB what do most people use? I will be right at the sets rms maybe a little over but not by much. 0 Share this post Link to post Share on other sites
Tirefryr 1,742 Posted August 10, 2020 Start at 0. If the tweeter is too much, go to -3. 0 Share this post Link to post Share on other sites
///M5 2,833 Posted August 11, 2020 Your ears can tell you best. Try all phase variations as well! 0 Share this post Link to post Share on other sites
Michael Evanchuk 0 Posted February 25, 2021 On 8/10/2020 at 10:22 PM, Tirefryr said: Start at 0. If the tweeter is too much, go to -3. I think you are right 0 Share this post Link to post Share on other sites
randolphcarr 0 Posted February 11 (edited) Component speaker crossovers optimize car audio by directing specific frequencies to different speakers. There are passive and active types. Passive crossovers, using components like capacitors and inductors, are cost-effective and easy to install. Active crossovers, integrated into amplifiers, offer more precise tuning and minimize signal degradation. Both types enhance sound quality by ensuring each speaker receives the right frequencies for optimal performance. Edited February 15 by Aaron Clinton spam 0 Share this post Link to post Share on other sites
markburnett 0 Posted May 16 (edited) In the realm of component speaker crossovers, the importance of seamless connectivity cannot be overstated. Edited May 18 by Aaron Clinton and delete spam 0 Share this post Link to post Share on other sites
