Jump to content
stevemead08

IAK needs an "IHOP"

Recommended Posts

Knew what angle you were coming from, us poor boys gotta make that dollar stretch!

Share this post


Link to post
Share on other sites

Small update: I got the 2 XS XP3000's ordered & should have the SAZ-3500v.2 ordered either this weekend or next. Hoping to order the subs by the end of the month & use my tax return to get the comps & 4ch.

Share this post


Link to post
Share on other sites

Small update: I got the 2 XS XP3000's ordered & should have the SAZ-3500v.2 ordered either this weekend or next. Hoping to order the subs by the end of the month & use my tax return to get the comps & 4ch.

I call you now.

Share this post


Link to post
Share on other sites

Ooooooooh yeah!!!! Looks like I'm about a couple of days from ordering some Sundown goodness ;)

Share this post


Link to post
Share on other sites

Huh... for some reason, my battery charger is being used excessively today...

Share this post


Link to post
Share on other sites

Now, for some reason.. the battery charger is now complete and un-needed for probably quite a long time now, :)

This week will be interesting...

Share this post


Link to post
Share on other sites

So, basicly, I need to put a few extra bucks back for gas next weekend!!!!

Share this post


Link to post
Share on other sites

hehe, no, i do not plan on showing it's potential off until it's tuned, tweaked and i am fully aware of what i just accomplished.

Share this post


Link to post
Share on other sites

The following will be updated once i get to that stage today...

Currently having to re-wire some tweeters.... i forgot too, lol.

Once that's done, i have to repair one wire run then go over everything very carefully then prepare to check the following with status-

Checklist of functionality-

Head Unit Operations-

Bass amp 1

Bass amp 2

Bass amp 3

Bass amp 4

Highs amp 1

Highs amp 2

Processor 1

Processor 2

Fusing throughout-

RCA signal detection-

Voltage stability-

Current stability-

Subwoofer 1

Subwoofer 2

Subwoofer 3

Subwoofer 4

8" 1

8" 2

8" 3

8" 4

Tweeter 1

Tweeter 2

Master Relay switch

Ground Loop Detected?

AC Signal Distortion?

I will post with results once i have them...

Share this post


Link to post
Share on other sites

Here is the newest update-

Head Unit Operations- PASS

Bass amp 1- PASS

Bass amp 2- PASS

Bass amp 3- PASS

Bass amp 4- PASS

Highs amp 1- PASS, but requires turn off pop eliminator.

Highs amp 2- PASS

Processor 1- PASS, induces Signal distortion that will be investigated later at low volume (1-6 out of 35)

Processor 2- FAIL, Output 4 of 4 is dead. Also induces signal distortion which attributes to volume range 1-6 of 35.

Fusing throughout- PASS

RCA signal detection- PASS

Voltage stability- PASS

Current stability- Not tested yet

Subwoofer 1- PASS

Subwoofer 2- PASS

Subwoofer 3- PASS

Subwoofer 4- PASS

8" 1- PASS

8" 2- PASS

8" 3- PASS

8" 4- PASS

Tweeter 1- PASS

Tweeter 2- PASS

Master Relay switch- PASS

Ground Loop Detected? NEGATIVE. PASS

AC Signal Distortion? YES but inaudible during playback. Will investigate later.

Share this post


Link to post
Share on other sites

Well its freaking 4deg here and my batteries dont like it.

Well i hadn't driven in 3 days because i was on my bike, lol, but got in the truck today and i was at 12.1vangry2.gif

Not to mention a sticking thermostat that did open up till on the highway and went from C-H in 2 secs smh

Def need to start leaving my bat charger hooked up in the winter, i bet now my bikes battery is bad since i didn;t take it back out...lol always something

Share this post


Link to post
Share on other sites

That many battery charges will most likely end up being classified as a felony!

Share this post


Link to post
Share on other sites

SAZ-3500v.2 ordered & paid for :)

2-XS-XP3000's sitting @ Jeff's & getting topped off ;)

The subs will be ordered next week!

Share this post


Link to post
Share on other sites

Nope, not yet. I'll text him.

Share this post


Link to post
Share on other sites

new update-

Head Unit Operations- PASS

Bass amp 1- PASS

Bass amp 2- PASS

Bass amp 3- PASS

Bass amp 4- PASS

Highs amp 1- PASS, but requires turn off pop eliminator.= getting better without it.

Highs amp 2- PASS

Processor 1- PASS, induces Signal distortion only at or below vol. 1!

Processor 2- FAIL, Output 4 of 4 is dead. Induced signal distortion has been eliminated..

Fusing throughout- PASS

RCA signal detection- PASS

Voltage stability- PASS

Current stability- Not tested yet

Subwoofer 1- PASS

Subwoofer 2- PASS

Subwoofer 3- PASS

Subwoofer 4- PASS

8" 1- PASS

8" 2- PASS

8" 3- PASS

8" 4- PASS

Tweeter 1- PASS

Tweeter 2- PASS

Master Relay switch- PASS

Ground Loop Detected? NEGATIVE. PASS

AC Signal Distortion? YES but inaudible during playback above vol. 1

Share this post


Link to post
Share on other sites

Good to see you see being able to apply some time each day on this!

Keep it up!!!

Share this post


Link to post
Share on other sites

i am about to start testing where the wall is peaking at with no port and then take a cabin gain response graph of the vehicle soon to find out how this new wall will effect response.

As of right now, it sounds audibly around 57-65hz peaking with no port.

Also audibly, with 2 subs playing on ~6400w wired, it doesnt sound deafening at all.. but now have all 4 subs playing(all tuned differently, lol) so the measured peak spl numbers will be of the worst capability but response graphs do not need total tuning for accuracy.

Share this post


Link to post
Share on other sites

Sweet.....did rattlebox get a hold of you?

I got in touch with him & he's gonna get the last deka batt I have. He still wants 1 more from my understanding though.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×