Need help with amp & bass controller setings

[whitesharingan 0]

My amp has a signal voltage adjustment range of

150mV - 5V (RCA Input).

And my question is do I set the sub. output level

from the MX-3 Bass controller to 5V?

If it helps I have a RF T2500-1bd amp.

Thanks for any response.

[bakedboy08@yahoo.com 6]

you match the volts from your h/u preouts to the amp, so if your h/u preout volts are 4v then you want your amp at about 4 volts

[whitesharingan 0]

you match the volts from your h/u preouts to the amp, so if your h/u preout volts are 4v then you want your amp at about 4 volts

But I have this in line (MX-3)

So I match the h/u's voltage to the sub. input of this unit. Then my

question is do I match the output voltage of the MX-3 to the signal

voltage rating on my amp?

Edited April 28, 2011 by whitesharingan

[bakedboy08@yahoo.com 6]

iv never seen a mx-3 but somebody here will have the answer, but yes match the volts from your h/u to the amp

[whitesharingan 0]

click on the (MX-3) it's a link to the page with info.

Edited April 29, 2011 by whitesharingan